Installation Instruction for CMAX Antennas
Installation Guide for CMAX-DMxx-CPUSExxx and
CMAX-3030-CPUSEI53 Antennas
Note: Please read the complete description before starting the installation. Make sure that
connectors are properly sealed against water if no cables are connected to them
after installation.
Tools required: Wrenches, width 13 mm and 16mm
(We recommend using socket wrenches.)
1. Assembly
Fit the three parts together and fasten with screws M10, spring washers, and washers
(M10 torque: 43 N-m).
Screw
Spring washer
Washer
Page 1 M0149A0B_Installation_CMAX-DM-CPUSE
Installation Instruction for CMAX Antennas
2. Wall Mounting
1. Use the lengthening piece to mark 4 holes onto the wall as shown in the drawing above
or use a drill jig.
2. Drill 4 holes into the wall and insert appropriate dowels into holes.
3. Attach the lengthening piece with appropriate screws (not part of the delivery).
4. Insert the mount into the lengthening piece and fasten it with the four screws, spring
washers, and washers.
3. Pole Mounting (200 mm max. pole diameter)
1
200 mm
max.
2
Lashing
Straps
1. Lay proper lashing straps around pole and lead them through mounting bracket (1).
3
2. Adjust bracket in antenna direction and fasten the bracket (2).
3. The antenna bracket can also be fastened to the pole with a counter bracket (not
part of delivery). For poles with a larger diameter use the outer holes (3).
M0149A0B_Installation_CMAX-DM-CPUSE Page 2
Loading...