Code 3 Ford PI B-Pillar Bracket User Manual

INSTALLATION MANUAL

NGPI B Pillar

Bracket

Mounting

IMPORTANT:

Read all instructions and warnings before installing and using.
This manual must be delivered to the end user of this equipment.

INSTALLER:

The light head should be mounted

with the face of the light head close

to the glass in the side window to

minimize flash-back from the window

surface.

Use Split washers and #8 screws

provided to mount bracket onto B

Pillar Surface. (Do NOT use power

driver to insert these screws to

prevent stripping of the Trim plastic

cover.
Wire way hole in base of bracket

WARRANTY

Code 3, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided
they are installed and operated in accordance with manufacturer’s recommendations, Code 3, Inc. guarantees all
parts and components except the lamps to a period of 1 year, LED Lighthead modules to a period of 5 years (unless
otherwise expressed) from the date of purchase or delivery, whichever is later. Units demonstrated to be defective
within the warranty period will be repaired or replaced at the factory service center at no cost.

Use of lamp or other electrical load of a wattage higher than installed or recommended by the factory, or use
of inappropriate or inadequate wiring or circuit protection causes this warranty to become void. Failure or destruction
of the product resulting from abuse or unusual use and/or accidents is not covered by this warranty. Code 3, Inc.
shall in no way be liable for other damages including consequential, indirect or special damages whether loss is due
to negligence or breach of warranty.

CODE 3, INC. MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING, WITHOUT LIMITA­TION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO THIS PRODUCT.

NEED HELP? Call our Technical Assistance HOTLINE - [phone]

PRODUCT RETURNS

If a product must be returned for repair or replacement*, please contact our factory to obtain a Return Goods
Authorization Number (RGA number) before you ship the product to Code 3, Inc. Write the RGA number clearly on

being returned while in transit.

*Code 3, Inc. reserves the right to repair or replace at its discretion. Code 3, Inc. assumes no responsibility or liability for expenses incurred for the removal and /or reinstallation of
products requiring service and/or repair.; nor for the packaging, handling, and shipping: nor for the handling of products returned to sender after the service has been rendered.

Code 3 is a registered trademark of Code 3, Inc. a subsidiary of Public Safety Equipment, Inc.

Code 3®, Inc.

St. Louis, Missouri 63114-2029—USA

Ph. [phone] Fax [phone]

Revision 0, 08/09/2013 - Instruction Book Part No. T15624

10986 N. Warson Road

www.code3pse.com

©2013 Code 3, Inc. Printed in USA