Cobra Electronics AirWave Box Product Information Guide

TM
Waterproof Bluetooth
CWA BT310
Product
Printed in China Part No. 480-933-P Version A
Information Guide
®
PRODUCT FEATURES
FRONT VIEW
LED Light
TOP VIEW
Volume Down Volume Up
Multi-Function Key
Microphone (hidden)
LoudspeakersSpeaker Mesh Rubber Sleeve
CARE AND MAINTENANCE
1. Never try to disassemble or service the product by yourself. Opening the unit will damage the seals that make it waterproof!
2. Keep the Cobra Airwave™ Box and accessories out of
REAR VIEW
reach from children.
3. Do not expose the Cobra Airwave™ Box to temperatures above +55° C (+131° F). If the product is operated in extreme hot or cold temperature, the battery capacity is reduced. Use it at room temperature for maximum battery capacity.
4.
The Cobra Airwave™ Box is waterproof and it can be cleaned by rinsing off or with a soft cloth and mild detergent.
5. Although the product is IPX7 compliant, it is not designed to be used for extended periods of time oating in water. Please make sure the rubber cover over the jack is closed tightly while around water. Retrieve and dry if the speaker is
SIDE VIEW
dropped in water.
CHARGING
The Cobra Airwave™ Box has a built-in Li-ion battery, so it
Audio In Jack
USB Jack
Water-Tight Cover (Shown Open)
2 3
can be used without connecting to a power supply. To charge the battery, follow these steps:
1. Connect the micro USB connector of the supplied USB
cord to the Cobra Airwave
2. Plug the USB full-size connector into a computer USB
port, common USB type AC charger (DC 5V, 500mA) or any USB power source.
• When the device is charging the LED status indicator will
be RED. When fully charged the RED status indicator LED will go off.
• A full charge will last for up to 10 hours of normal use.
Box micro-USB input.
OPERATION
Turning the Cobra Airwave™ Box On or Off
Multi-Function Key
Press and hold the Multi-Function Key for 2 seconds to turn On. The blue LED will turn on and blink. "Power On" will sound from the speaker. Press and hold the Multi­Button for 3 seconds to turn Off. The red LED will turn on then turn off. "Power Off" will sound.
Pairing the Cobra Airwave™ Box with a smartphone or any Bluetooth
To use the enabled smartphone or media device, you must rst pair the device to the been paired for the rst time, the phone or media device will automatically re-connect to the when the power is turned ON and Bluetooth® is enabled on your device. For additional information, see the operation manual for your smartphone or media device.
®
enabled music device
Cobra Airwave™ Box
Cobra Airwave™ Box
with any Bluetooth®
. Once they have
Cobra Airwave™ Box
Pairing with smartphone
1. Turn Bluetooth® on in your settings menu. It will begin
searching for any Bluetooth® device within range.
2. With power off, press and hold the Multi-Function
Key for 5 seconds (keep holding when you hear "Power On" after 2 seconds) and the blue and red LEDs will alternately blink.
"Pairing" will sound.
3. You will see the Cobra Airwave™ Box on the devices
list on your phone. Select the Cobra Airwave Box to pair. Once connected, the blue LED light will blink on the Cobra Airwave™ Box and sound
.
"Successful" will
Playing music
To play music through the Cobra Airwave the devices. Music played on the Bluetooth® enabled smartphone or other Bluetooth
®
device will be played
Box, rst pair
through the Cobra Airwave™ Box.
For smartphones and some other Bluetooth
®
devices pressing the Multi-Function Key will cause the paired device to start playing. Pressing the Multi-Function Key again will pause the audio.
The audio can also be started and paused using the smartphone controls.
4 5
ADJUSTING VOLUME
To increase or decrease the Cobra Airwave™ Box volume, press the "+" or "–" buttons.
Volume Down Volume Up
QUICK REFERENCE GUIDE
Mode Controls Action Functions
Power Press & Hold >2s Turn Power On/Off
Press & Hold >3s Pair to Bluetooth
Music Press Play/Pause Music
(from power off)
®
Volume can be adjusted with Cobra Airwave™ Box controls or the paired Bluetooth® device connected to the Cobra AirWave
Box.
Pairing a new device with the Cobra Airwave™ Box
1. Use the smartphone or paired devices' Bluetooth®
settings menu to unpair the Cobra Airwave™ Box.
2. Press and hold the Multi-Function Key for 3 seconds
to turn off the Cobra Airwave™ Box.
3. Follow the steps under "Pairing with smartphone" to
complete pairing.
Answer incoming call/hang up
If a call comes through in stand by mode or while playing music, click on the Multi-Function Key to answer the call. To hang up, press the Multi-Function Key again.
6 7
Phone
+
+
Press Volume Up
Press Volume Down
Press Answer Incoming
Press Volume Up
Press Volume Down
Press End Call
Call
FCC & INDUSTRY CANADA STATEMENT
For Products Purchased in USA: NOTE: This device complies with part 15 of FCC rules: Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that may cause undesired operation. CAUTION: Modications or parts not approved by Cobra Electronics Corporation may violate FCC Rules and void authority to operate this equipment.
For Products Purchased in Canada:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unautho- rized modications or changes to this equipment. Such modications or changes could void the user’s authority to operate the equipment. This equipment is portable device. The output power of this device is less than 20mW. The SAR test is not required.
This equipment has been tested and found to comply with the limits for a Class B digital
NOTE:
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec­tion against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter­ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
8 9
PRODUCT SERVICE QUESTIONS
For any questions about operating or installing this new Cobra product, or if parts are missing…PLEASE CALL COBRA FIRST…do not return this product to the store.
For Products Purchased in the U.S.A.
If your product should require factory service, please call Cobra first before sendi ng your radio. This will ensure the fastest turn-around time on your repair. Yo u may be asked to send your ra dio to the Cobra factory. It will be necessary to furnish the following to have the product serviced and returned.
1) For warranty repair include a copy of the original sales receipt. If you send the original receipt, it cannot be returned.
2) Send the entire product.
3) Enclose a detailed description of the problem along with the name and address of where the product is to be returned.
4) Pack radio securely to prevent damage in transit. If possible, use the original packing material.
5) Ship prepaid and insured by way of a traceable carrier such as United Parcel Service (UPS) or Priority Mail to avoid loss in transit to Cobra Factory Service:
Cobra Electronics Corporation 6500 West Cortland Street Chicago, Illinois 60707 U.S.A.
6) If the radio is under warranty, it will be repaired or exchanged depending on the model.
Please allow approximately three to four weeks before contacting Cobra for status. If the product is out of warranty, a letter will automatically be sent informing you of the repair charge or replacement charge. If you have any questions, please call 773-889-3087 for assistance.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for product service information.
LIMITED ONE-YEAR WARRANTY
For Products Purchased in the U.S.A.
Cobra Electronics Corporation warrants that its products and the component parts thereof, will be free of defects in workmanship and materials for a period of one year from the date of first consumer purchase. This warranty may be enforced by the first consumer purchaser, provided that the product is utilized within the U.S.A.
Cobra will, without charge, repair or replace, at its option, defective products, products or component parts upon delivery to the Cobra Factory Service department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt.
You must pay any initial shipping charges required to ship the product for warranty service, but the return charges will be at Cobra’s expense, if the product is repaired or replaced under warranty. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Exclusions: This limited warranty does not apply: 1) To any product damaged by accident; 2) In the event of misuse or abuse of the product or as a result of unauthorized alterations or repairs; 3) If the serial number has been altered, defaced, or removed; 4) If the owner of the product resides outside the U.S.A.
All implied warranties, including warranties of merchantability and fitness for a particular purpose are limited in duration to the length of this warranty. Cobra shall not be liable for any incidental, consequential or other damages; including, without limitation, damages resulting from loss of use or cost of installation.
Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for warranty information.
Trademark Acknowledgement
Cobra®, Nothing Comes Close to a Cobra®, and the snake design are registered trademarks of Cobra Electronics Corporation, USA. Cobra Airwave™ and Cobra Electronics Corporation™ are trademarks of Cobra Electronics Corporation, USA.
The Bluetooth of such marks by Cobra Electronics Corporation is under license.
®
word mark is a registered trademark owned by Bluetooth SIG, Inc. and any use
©2014 Cobra Electronics Corporation
6500 West Cortland Street, Chicago, IL 60707
www.cobra.com
10 11
Loading...