Cobra Electronics AirWave 360 Product Information Guide

Printed in China Part No. 480-900-P Version A
Information Guide
TM
CWA BT320
Product
IMPORTANT
To get the full capability of your new Cobra Airwave™ 360, please read this manual. It's more than just a Bluetooth® Speaker!
INTUITIVE DIAL CONTROL INTERFACE
Press anywhere on the perimeter of Dial Control or rotate the dial to:
Play/Pause music
Interrupt music to answer an incoming call
Hang up a call and resume music
Increase or decrease volume
Other Controls:
Track Forward/Reverse
Access voice command
Hand gesture controls
CARE AND MAINTENANCE
1. Never try to disassemble or service the product by yourself.
2. Keep the Cobra Airwave™ 360 and accessories out of reach from children.
3. Do not expose the Cobra Airwave™ 360 to temperatures above +55 deg C (+131 deg F). If the product is operated in extreme hot or cold temperature, the battery capacity is reduced. Use it at room temperature for maximum battery capacity.
CHARGING
The Cobra Airwave™ 360 has a built-in Li-ion battery (3.7V, 1600 mAH), so it can be used without connecting to a power supply. To charge the battery, follow these steps:
1. Connect the micro USB connector to the Cobra
2. Plug the USB full-size connector into the 12V
3. Place the Cobra Airwave
When the device is charging the LED status
A full charge will last for up to 20 hours of
Airwave
360 DC 5V input.
accessory car plug (included). A common USB type AC charger (DC 5V, 500mA) can be used as well or any USB power source, or
360 in it's charging dock (not included). Please make sure the charging contact on the bottom of the device is lined up correctly to the charging contact on the base.
indicator will be RED. When fully charged the RED status indicator LED will go off.
normal use.
DIAL CONTROL INTERFACE
Top view
Gesture sensor
Smartphone Voice Command access
Play
Music track Prev/Next buttons
LED status indicator
Front view Rear view
Phone
Microphone
Gesture sensor
Volume Up or Down
Stop
Bottom view
Power ON/OFF switch
Micro USB jack
Audio Out (3.5mm Stereo)
OPERATION
Turning the Cobra Airwave™ 360 On or Off
The ON/OFF switch is located on the bottom of the Cobra Airwave™ 360.
Pairing the Cobra Airwave or any Bluetooth® enabled music device
To use the Cobra
Airwave™ 360 enabled smartphone or media device, you must rst pair the device to the Cobra been paired for the rst time, the phone or media device will automatically re-connect to the Cobra 360 when the power is turned to the ON position and
Bluetooth® is enabled on your device. For additional
information, see the operation manual for your smartphone or media device.
Connecting with smartphone
1. Turn Bluetooth
®
searching for any Bluetooth® device within range.
2. Make sure the Cobra Airwave
ON position, then press and hold the Dial Control for 3 seconds until a double-beep sounds and the LED ashes orange and blue.
3. You will see the Cobra Airwave
list on your phone. Touch the Cobra Airwave 360 to pair. A single beep will sound and "Connected" will appear in the device's screen.
360 with a smartphone
with any Bluetooth®
Airwave™ 360
. Once they have
Airwave™
on in your settings menu. It will begin
360 is turned to the
360 on the devices
Loading...
+ 6 hidden pages