Cobra Electronics 9820WR Users manual

User Manual

Remote Control

WASPcam 9820WR

NOTE**: Before pairing the remote to the camera, format the MicroSD card in the camera.

How To Pair the Remote:

1. When the camera is in standby mode, press the menu button twice to enter
system settings.

2. Press the left/right arrow buttons to scroll through the menu, choose remote
control to enter the remote menu. Then select Remote Match.

3. A message will appear on the LCD Screen “Wait Remote Match”, the camera is
now in pairing mode.

4. At the same time, press both buttons on the remote controller to start
pairing. Pairing is successful when the LCD screen shows “Remote Match
OK”

Press the Inquiry/Record Button (3) and the Photo

button (2) simultaneously to enter Pairing mode

1 - Indicator light

2 – Photo Button - press to take photos,

3 – Inquiry/Record Button – press to start/stop

recording, press and hold for 3 seconds to check

the present status of the camera (see below)

Status Inquiry

Pairing Mode

Remote Control Indicator Light Status

Status/LED Red LED Light Blue LED Light

Standby
Recording Off Light on 3 seconds, then off

Power off Light on 3 secs, then off Off

Pairing Long light Long light
Success Light on 3 secs, then off Light on 3 secs, then off
Failure Off Off

1 time/sec frequently
Flickers about 5sec

Off

Start recording

2 times/sec frequent
Flickers about 5sec

Off

Stop recording

Photo Off

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

1 time/sec frequent
Flickers about 5sec

Off
Flashes once each time you

take a photo