Mini Speaker
Printed in China Part No. 480-919-P Version D
Information Guide
CWA BT300
Product
IMPORTANT
To get the full capability of your new Cobra Airwave® Mini,
please read this manual. It's more than just a Bluetooth®
Speaker!
Micro-USB Charging Point (under ap) TIP: Use a
Volume Down
Multi-Button
Microphone
pen tip to lift
ap open.
Volume Up
Wrist Strap
Insert
CARE AND MAINTENANCE
1. Never try to disassemble or service the product
by yourself.
2. Keep the Cobra Airwave® Mini and accessories out
of reach from children.
3. Do not expose the Cobra Airwave® Mini to
temperatures above +55 deg C (+131 deg F). If
the product is operated in extreme hot or cold
temperature, the battery capacity is reduced. Use it
at room temperature for maximum battery capacity.
CHARGING
The Cobra Airwave® Mini has a built-in Li-ion battery (3.7V,
1600 mAH), so it can be used without connecting to a
power supply. To charge the battery, follow these steps:
1. Connect the micro USB connector to the Cobra
Airwave® Mini micro-USB input.
2. Plug the USB full-size connector into the microUSB input. A common USB type AC charger (DC
5V, 500mA) or any USB power source.
• When the device is charging the LED status
indicator will be RED. When fully charged the RED
status indicator LED will go off.
• A full charge will last for up to 12 hours of
normal use.
2 3
OPERATION
Turning the Cobra Airwave® Mini On or Off
Multi-Button
Press and hold the Multi-Button for 3 seconds to turn On.
The blue LED will turn on and blink. Press and hold the
Multi-Button for 5 seconds to turn Off. The red LED will
turn on then turn off.
Pairing the Cobra Airwave® Mini with a smartphone
or any Bluetooth® enabled music device
To use the Cobra
enabled smartphone or media device, you must rst pair
the device to the Cobra
been paired for the rst time, the phone or media device
will automatically re-connect to the Cobra
when the power is turned ON and Bluetooth® is enabled
on your device. For additional information, see the
operation manual for your smartphone or media device.
Airwave® Mini
Airwave® Mini
4 5
with any Bluetooth®
. Once they have
Airwave® Mini
Connecting with smartphone
1. Turn Bluetooth® on in your settings menu. It will begin
searching for any Bluetooth® device within range.
2. With power off, press and hold the Multi-Button for
7 seconds until a double-beep sounds and the blue
and red LEDs will alternately blink.
3. You will see the Cobra Airwave® Mini on the devices
list on your phone. Select the Cobra Airwave Mini to
pair. A single beep will sound and "Connected" will
appear in the device's screen. Once connected, the
blue LED light will blink on the device.
ADJUSTING VOLUME
To adjust the Cobra Airwave® Mini volume, press on the
"+" or "–" buttons to increase or decrease volume.
Volume Down
Volume Up
• Volume can be adjusted with Cobra Airwave® Mini
controls or the paired Bluetooth® device connected
to the Cobra AirWave
®
Mini.
Pairing a new device with the Cobra Airwave® Mini
1. Use the smartphone or paired devices' BT settings
to unpair the BT 300 Mini.
2. Turn on BT/scan with a different device.
3. Connect with new device and play.
Answer/hang up/place a call
If a call comes through in Stand By mode or while playing
music, click on Multi-Button to answer the call.
To hang up, press the Multi-Button again.
6 7
FCC & INDUSTRY CANADA STATEMENT
For Products Purchased in USA:
NOTE: This device complies with part 15 of FCC rules: Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received including interference that may cause undesired operation.
CAUTION: Modications or parts not approved by Cobra Electronics
Corporation may violate FCC Rules and void authority to operate this
equipment.
For Products Purchased in Canada:
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
This equipment complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment. This device complies with Part 15 of the
FCC Rules and with RSS-210 of Industry Canada. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB003 du Canada.
NOTE: The manufacturer is not responsible for any radio or TV interfer-
ence caused by unauthorized modications or changes to this equipment. Such modications or changes could void the user’s authority to
operate the equipment.
This equipment is portable device. The output power of this device is
less than 20mW.The SAR test is not required.
FCC & INDUSTRY CANADA STATEMENT
continued
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Trademark Statement
®
Airwave
Cobra Electronics Corporation, USA. Cobra Electronics Corporation
is a trademark of Cobra Electronics Corporation, USA.
iPhone
registered with the U.S. and other countries.
Samsung S Voice
Electronics Company, LTD.
The Bluetooth
Bluetooth SIG, Inc. and any use of such marks by Cobra Electronics
Corporation is under license.
®
, Cobra
and the snake design are registered trademarks of
®
, iPod® touch and Siri® are trademarks of Apple, Inc,
®
is a registered trademark of Samsung
®
word mark is a registered trademark owned by
8 9
™
PRODUCT SERVICE QUESTIONS
For any questions about operating or installing this new Cobra
product, or if parts are missing…PLEASE CALL COBRA FIRST…
do not return this product to the store.
For Products Purchased in the U.S.A.
If your product should require factory service, please call Cobra first
before sending your radio. This will ensure the fastest turn-around
time on your repair. You may be asked to send your radio to the
Cobra factory. It will be necessary to furnish the following to have
the product serviced and returned.
1) For warranty repair include a copy of the original sales receipt. If
you send the original receipt, it cannot be returned.
2) Send the entire product.
3) Enclose a detailed description of the problem along with the
name and address of where the product is to be returned.
4) Pack radio securely to prevent damage in transit. If possible,
use the original packing material.
5) Ship prepaid and insured by way of a traceable carrier such
as United Parcel Service (UPS) or Priority Mail to avoid loss in
transit to Cobra Factory Service:
Cobra Electronics Corporation
6500 West Cortland Street
Chicago, Illinois 60707 U.S.A.
6) If the radio is under warranty, it will be repaired or exchanged
depending on the model.
Please allow approximately three to four weeks before contacting
Cobra for status. If the product is out of warranty, a letter will
automatically be sent informing you of the repair charge or
replacement charge. If you have any questions, please call
800-262-7212 for assistance.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for product service information.
LIMITED ONE-YEAR WARRANTY
For Products Purchased in the U.S.A.
Cobra Electronics Corporation warrants that its products and the
component parts thereof, will be free of defects in workmanship and
materials for a period of one year from the date of first consumer
purchase. This warranty may be enforced by the first consumer
purchaser, provided that the product is utilized within the U.S.A.
Cobra will, without charge, repair or replace, at its option, defective
products, products or component parts upon delivery to the Cobra Factory
Service department, accompanied by proof of the date of first consumer
purchase, such as a duplicated copy of a sales receipt.
You must pay any initial shipping charges required to ship the product for
warranty service, but the return charges will be at Cobra’s expense, if the
product is repaired or replaced under warranty. This warranty gives you
specific legal rights, and you may also have other rights which may vary
from state to state.
Exclusions: This limited warranty does not apply: 1) To any product
damaged by accident; 2) In the event of misuse or abuse of the product
or as a result of unauthorized alterations or repairs; 3) If the serial
number has been altered, defaced, or removed; 4) If the owner of the
product resides outside the U.S.A.
All implied warranties, including warranties of merchantability and
fitness for a particular purpose are limited in duration to the length of
this warranty. Cobra shall not be liable for any incidental, consequential
or other damages; including, without limitation, damages resulting from
loss of use or cost of installation.
Some states do not allow limitations on how long an implied
warranty lasts and/or do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitations may
not apply to you.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for warranty information.
10 11
Quick Reference Guide
Mode
Power Off
Music
Phone
Controls Action Functions
o
o
o
+
–
o
+
–
o
>3s Turn Power On/Off
>7s Pair to BT
Press Play/Pause Music
Press Volume Up
Press Volume Down
Press Answer Incoming
Press Volume Up
Press Volume Down
Press End Call
©2014 Cobra Electronics Corporation
6500 West Cortland Street, Chicago, IL 60707
www.cobra.com
Call
Loading...