To charge a 5V USB device, connect the devices’ cable to the JumPack’s
USB output. The JumPACK will turn on, and start chargin g the device
automatically. The blue LEDs will indica te that the device is charging.
Press the Power/Flashligh t/Battery capacity button for 3 seconds to turn
S.O.S. and Off.
Battery Status Indicator LEDs
Note: When charging a device the number of lit LEDs may decrease
while the JumPack is in use. The battery capacity indicator cannot
the real battery capacity, disconnect the device being charged and
1 LED on: 10%-40% charge
2 LEDs on: 40%-65% charge
3 LEDs on: 65%-85% charge
4 LEDs on: 85%-100% charg e
To check the battery capacity of the JumPack press the
Power/Flashlight button on the top of the unit with no device
connected. The blue LEDs will show the remaining battery
capacity:
Check B attery Capac ity:
.7..6.
LED Flashlight:
Charging a 5 V USB Device:
1. Make sure the JumPack is fully charged.
2. Turn off all the accessories on the vehicle.
3. Disconnect the battery cables from the JumPack.
4. Connect the RED clamp to the POSITIVE post of the battery.
5. Connect the BLACK clamp to the NEGATIVE post of the battery.
6. Connect the battery cables into the JumPack cables port/jack. Be
7. Turn the ignition key to start the vehicle for 3 seconds only. If the
engine starts;
8. Disconnect the cables from the battery from the JumPack then
from the battery posts.
9. Leave the engine running for a few minutes before turning the
ignition off.
10.
wait for 1 minute
before trying to start the vehicle again.
Starting a Ve hicle :
.5.
.4.
START
Product Features:
• 7500 mAh Lithium Cobalt rechargeable battery.
• 200 Amp Starting Current/400 Amp Peak Current.
• 5V/2.1 Amp USB Output for rapid charging of portable devices.
• High Intensity work/Strobe/S.O.S LED light.
• Rechargeable by 240 V AC wall adapter or 13.8 V DC car adapter.
• Li-Cobalt rechargeable battery: 3.7 V/7500 mAh
• Size: 5.03” x 2.87” x 0.98”
(128 mm x 73 mm x 25 mm)
• Weight: 10.58 oz. (300 g.)
• Recharge time: 3 hours
• Starting/Peak Current: 200 Amps/400 Amps
• USB Output: 2.1 Amps
CUSTOMER SUPPORT & TRADEMARKS
Customer Support
Should there be a ny problems with thi s product or furthe r information
needed on its fea tures please visit www.cobra. com for support, f requently
asked questi ons, Declarations of C onformity, and the ele ctronic manual.
For warranty an d customer service inf ormation please c ontact the seller.
WEEE
For European Community Users
Cobra Electro nics Corporation comp lies with Directi ve 2012/19/EU OF
THE EUROPEA N PARLIAMENT AND OF THE COUN CIL 4 JULY 2012 on
waste electr ical and electr onic equipment (WEEE ).
Waste Electrical and Electronic Equipment Information
This produc t has required the extra ction and use of natura l resources for
its productio n. It may contain hazardou s substances that could imp act
health and th e environment, if not proper ly disposed. In order to avoid
the dissemi nation of those substances in ou r environment and to
diminish the pressure on t he natural resources, w e encourage you to use
the appropriat e take-back systems for p roduct disposal. T hose systems
will reuse or recycl e most of the materials of th e product you are disposin g
in a sound way.
The crosse d out wheeled bi
n symbol infor ms you that the product
should not be dispose d of along with municipa l waste and invites you
to use the appro priate separate take-b ack systems for prod uct disposal.
If you need more informat ion on the collecti on, reuse and recyclin g
systems, ple ase contact your loca l or regional waste adm inistration.
You may also contac t your supplier for more inf ormation on the
environmental per formances of thi s product.
Trademark Statement
©2014 Cobra Electron ics Corporation, 65 00 West Cortland St reet,
Chi
cago, Illinois 60707 U.S. A.
Cobra, the snake d esign is a proprietar y trademark of Cobra El ectronics
Corporation, U SA.
CPP7500E_MANL_ENG.indd 2 7/3/14 12:10 PM
CPP7500E_MANL_ENG.pdf 1 7/3/14 12:18 PM