COATS Slide Nut Kit User Manual

8113351 01 4/09 © COPYRIGHT 2001 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

Item Part No. Description

A 85009997 40mm Slide Nut, double jaw

85009995 28mm Slide Nut, double jaw
B 8113345 Pressure Drum
C 8113346 Rubber Lip
D 8113347 Spacer

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.Hennessy-Ind.com

28mm Kit 85009996 (2 jaw)
40mm Kit 85009998 (2 jaw)

For use with COATS Wheel Balancers

A

A

A

B

C

B

C

D - spacer goes in

between cone

and wingnut

®

Balancing Solutions

Slide Nut

Back Cone

(not included)

Front Cone Mounting Procedure

1. Seat wheel on balancer shaft with a front cone

making sure the wheel doesn’t slip off the cone.

2. Press quick release trigger and position slide
nut (without pressure drum) until it engages the
cone.

3. Finish mounting by turning the slide nut on the
shaft clockwise until handtight.

Back Cone Mounting Procedure

1. Slide backing spring and appropriate size back

cone on balancer shaft.

2. Seat wheel on back cone making sure the

wheel doesn’t slip off the cone.

3. Press quick release trigger and position slide
nut (with pressure drum) until the pressure drum
engages the wheel.

4. Finish mounting by turning the slide nut on the

shaft clockwise until handtight.