Page 1
Wall Shadow Board
Kit 85609761
Balancing Solutions
Installation Instructions
with Parts Identifi cation
READ these instructions before placing unit in
service. KEEP these and other materials delivered
with the unit in a binder near the machine for ease
of reference by supervisors and operators.
1601 J. P. Hennessy Drive, LaVergne, TN USA 37086 615/641-7533 800/688/6359 www.ammcoats.com Manual Part No.: 85609760 00
HENNESSY INDUSTRIES INC. Manufacturer of AMMCO
®
, COATS® and BADA® Automotive Service Equipment and Tools. Revision: 10/14
Page 2
Parts Identification
The Wall Shadow Board Kit consists of the following
parts (Fig. 1):
Item Part No. Qty. Description
➊ 8107091 15 Grip
➋ 8113094 15 Hook
➌ 8106303 30 3/8-16 UNC Locknut
➍ 85609758 1 Shadow Board Front
➎ 85609759 1 Shadow Board Backing
➏ 85609792 1 3/8 x 3-inch Sleeve Anchors,
Pkg. 4
➐ 1 9-32-inch Masonry Drill Bit
Verify that you have received all of the parts listed.
Tools Required
☐ Steel Measuring Tape
☐ Electric Drill
☐ 1/2-inch Socket or Wrench
☐ 9/16-inch Socket or Wrench
➊
➌
➋
➍
➏
➐
➎
Figure 1 - Shadow Board Kit Contents
2 • Balancing Solutions
Page 3
Assembly and Installation
Always wear safety goggles to
protect your eyes.
1. Assemble the Grips onto the Hooks if not already
assembled. (Fig. 2)
2. Assemble each Hook onto the Shadow Board using
two 3/8-16 UNC Locknuts (Fig. 2 & 3). Hand-tighten the
Locknuts, leaving the threaded portion of the Hook flush
with the Locknut. Make sure the Hooks are pointing
upward toward the COATS logo.
3. Position the Shadow Board in the desired location.
Mark the four mounting hole locations on the wall, then
for each location drill a 3/8-inch hole 3-1/4 inch deep.
Mounting Hole
4. To install, insert a sleeve anchor into each mounting hole and into the wall. Tighten the sleeve anchor to
expand it.
5. Your Shadow Board is now ready to store your
COATS brand balancing accessories (sold separately).
➌
Shadow Board
➋
➌
➊
Mounting Hole
➏
➌
➎
➌
➊
➋
Mounting Hole
➍
Mounting Hole
Figure 3 - Shadow Board Assembly DiagramFigure 2 - Hook Assembly Diagram
Balancing Solutions • 3
Page 4
85609760 00 10/14 © Copyright 2014 Hennessy Industries and COATS® All Rights Reserved
Loading...