COATS Kit 85608159 User Manual

Center Post Tire Changer Bracket Kit 85608159

For use with COATS EL-X™ Express Lane Inflation System

Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Instructions

Before beginning this modification or attempting any maintenance, remove the electrical power and air source from the machine; also, bleed off any stored compressed air by exhausting through the air blast foot valve.

Attach Bracket To

Tire Inflation Cage

Kit 85607770

DO NOT remove the far left screw.

Remove the middle and far right screws.

1. At chassis end, remove two screws and reserve

the hardware.

Important: Do not remove screw at the far left side of the chassis.

Center Post Tire Changer

3. Use two 3/8 x 2.5 inch U-bolts and four 3/8-16 nuts

to fasten cage bracket to inflation cage, then secure.

4. Refer to the Tire Inflation Cage Kit 85607770

instructions for its attachment and setup procedure.

5. Reconnect the air and electric supply to the machine. Test the machine for full function before returning the machine to operation.

Position Bracket And Fasten To Machine

2. Position cage bracket at chassis end and use reserved screws to fasten cage bracket to machine chassis, then secure.

Location of Tire Inflation Cage

Provide at least three feet of clear space between the Tire Inflation Cage and building walls. When a tire fails, the explosive release of air will throw all movable objects in the path of the expanding compressed air.

Trajectory

Zone

Wall

3-feet

Trajectory

Zone

Cage Attached Three Feet From Wall