COATS Kit 85608046 User Manual

Line Laser Kit 85608046

For use with COATS 1250 Series Wheel Balancer

Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Bracket Installation

1. On faceplate side of balancer, remove two screws that fasten balancer weight tray to chassis. Reserve the hardware.

2. Now position laser bracket as shown. Fasten to the chassis using reserved hardware.

Line Laser

Laser Bracket

1/4-20 x 3/4 Self Tapping HWHST Screw

Operating Instructions

1. For corrective weight placement at top-deadcenter, mount line laser either inboard on laser bracket magnet or outboard on motor shaft end.

Maintenance Instructions

The line laser assembly requires only minor mainte-

nance to keep the unit operating properly.

• Keep the unit clean and clear. Use a damp cloth. Do not use cleaners or solvents that leave oily or filmy residues behind.

• To replace the line laser batteries, remove cover. Discard old batteries, install two new AAA batteries and replace the cover.

2. Press button on line laser to activate the line laser beam.

3. Use the line laser beam as a guide to center and attach the corrective weight amount at top-dead-center.

Laser Beam Guide at Top-Dead-Center

Line Laser Mounted on Motor Shaft End

Important: Remember to turn the line laser off to

conserve its battery life.

CAUTION: Be sure to remove the unit, if mounted

on balancer motor shaft end, before the next measurement cycle (spin).

4. Press button on line laser to turn laser beam off.