COATS Kit 85607965 User Manual

85607965 Lateral Sonar Kit

For use with COATS ProRide Wheel Balancer

Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Kit Includes:

Lateral Runout

Assembly w/

Cable & Sonar

Hardware

Tools Needed:

3/16 inch Drill Bit 11/16 inch Hole Saw or Drill Bit Hex Keys 6 mm 3/8 Wrench 7/16 Wrench Phillips Head Screw Driver

Mounting Plate

w/ Hardware

Rubber

Grommet

Plugs

Instructions

1. Unplug balancer from power source.

2. Lean balancer back to gain access underneath the

chassis and place tire under sonar bar. Remove storage pegs on front of balancer.

3. Place mounting plate on chassis; and align it with the three holes for storage pegs. Next mark the center of the last hole location. Drill a 11/16 hole in the chassis. Be sure there is no obstruction inside the chassis.

Use Mounting Plate as Template for Drill Hole

Location

Lean Chassis Back To

Gain Access Under Unit

3. Mount angle bracket with connector on the inside of cabinet (as shown) using supplied nut and bolt.

View From

Underneath Chassis

Angle Bracket &

Connector

5. Fasten the lateral sonar bracket to the mounting plate using supplied countersink screws. Place mounting plate on chassis front and align the hole locations. Install the storage pegs using a hex key.

Screw & Washer

Location

Install Storage

Pegs

Screw & Washer

Location

6. Open a slit in the side of the rubber grommet using a razor blade, knife or scissors. Route cable from the lateral runout sonar through the grommet and into the hole of the cabinet as shown. Install the grommet in the hole opening.

9. Perform functional checks to ensure proper instal-

lation.

Slit Grommet For Easy

Installation

Lateral Runout Cable

Entering Cabinet

7. Inside the chassis, connect one end of the audio cable to this connector and the other end to connector 12 at MCB.

8. Connect the switch cable onto the main circuit board (2 pin location).