CMA Dishmachines GW-100 Installation Manual
GW-100 Carousel
Glasswasher
800-854-6417
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
POWER BLOCK
1
HEATER THERMOSTAT
6
THERMOMETER
6
DRAIN CONNECTION
3
LEVELING LEGS
4
POWER SWITCH
5
GW-100 FRONT VIEW
PRIME
DETERGENT
CONCENTRATION
PRIME
SANITIZER
CONCENTRATION
PRIME
RINSE
CONCENTRATION
ON
OFF
FLUSH
COLD WATER
INLET
HOT WATER
INLET
2
2
STEP
1
(N)
L2
L1
GROUND
Connect L1 and L2 leads to the power block and
one ground. 110/120V.
STEP
4
STEP
2
Connect water lines (hot 140F/160F) and (cold
75F) to water solenoid valves.
STEP
5
ON
OFF
FLUSH
PRIME
RINSE
CONCENTRATION
STEP
3
1"AIR GAP
Connect the drain hose to the FLOOR DRAIN. If
floor drain is not available connect to the wall. Floor
drain must have a (1 inch) air gap between the drain
hose and the floor drain.
STEP
WALL
DRAIN
FLOOR
DRAIN
6
140
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back to
ensure proper performance.
Flip power "on-off/flush" switch to "ON" position.
Wash tank will automatically fill.
Adjust heater thermostat to 140F.
3-2008
GW-100 Carousel
Glasswasher
800-854-6417
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply with
all Federal, State and Local Health,
Electrical, Plumbing and Safety codes.
AUTO FILL TIMER
7
OVERFLOW
DRAIN TUBE
9
PRIMER
PUSH BUTTONS
GW-100 FRONT VIEW
TUBE
STIFFENER
CHEMICAL
TUBING
PRIME
DETERGENT
CONCENTRATION
PRIME
SANITIZER
CONCENTRATION
PRIME
RINSE
CONCENTRATION
ON
OFF
FLUSH
ROCKER
SWITCH
10
PRIME
DETERGENT
CONCENTRATION
PRIME
SANITIZER
CONCENTRATION
PRIME
RINSE
CONCENTRATION
ON
OFF
FLUSH
CHEMICAL
STORAGE AREA
8
8
4
5
STEP
7
6
72
INIT.
10
MIN
3
2
7
1
MAX
9
8
INPUT
LOAD
3
2
1
STEP
8
3/4"
Adjust auto-fill timer to set water level.
STEP
Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
10
BLUE RED
WHITE
DRAIN TRAY AND
WASTE COLLECTOR
STEP
PRIME
DETERGENT
CONCENTRATION
9
PRIME
SANITIZER
CONCENTRATION
PRIME
RINSE
CONCENTRATION
Push each of the chemical prime buttons
and hold until the chemical feed tubes
are full.
Start conveyor by flipping rocker switch to
"ON" position.
Available Option: Drain tray and waste
collector. (Recommended)
3-2008
Loading...