CMA Dishmachines EST-AH Installation Manual

Models EST-AH ,

EST-C EST-AH-(TALL) & EST-C-(TALL) Quick Setup

MODEL EST REAR VIEW

800-854-6417

HARD WIRE

POWER SUPPLY

Instructions

WA R NIN G : E lect rical a nd

plu mbin g conne ctio ns nee d to be mad e by a lic ense d servi ce p erso n and com ply wit h al l Fed eral , State and Loc al Hea lth, Electr ical , Plu mbin g and S afet y cod es.

STEP

DRAIN/RINSE

SWITCH

SANI/DETERGENT

SWITCH

NORMAL-OFF DELIMER

SWITCH

ON/OFF

POWER SWITCH

1/2" WATER

INLET

TUBE

STIFFENER

CHEMICAL

TUBING

Connect dishmachine to hot water source recommended 140 temperature (120 minimum temperature required).

STEP

Connect hard wire power supply from dishmachine to power box.

2" DRAIN

OUTLET

STEP

� �

� � � � � � � � ��

Connect a 2" drain pipe (not supplied) from scrap accumulator to floor or wall drain.

� � � � � ��

STEP

Insert tube stiffener with chemical tubing into each corresponding chemical dispensers.

� � �

� � ��

� � � �

5-2008

Models EST-AH EST-C,

EST-AH-(TALL) & EST-C-(TALL) Quick Setup

MODEL EST FRONT VIEW

��

� � � ��

Instructions

WA R NIN G : E lect rical a nd

plu mbin g conne ctio ns nee d to be mad e by a lic ense d servi ce p erso n and com ply wit h al l Fed eral , State and Loc al Hea lth, Electr ical , Plu mbin g and S afet y cod es.

THERMOMETER

POLY PROTM SCRAP

ACCUMULATOR

FILL/START

SWITCH

DOOR

HANDLE

STEP

Level dishmachine by adjusting leveling legs. Dishmachine must be level front and back to ensure proper performance.

STEP

Press the "FILL/START" switch. Hold in the "FILL" position until the water overflows into the scrap accumulator.

STEP

LEVELING

��

LEGS

� ��

��

� ��

Open dishmachine doors completely. Closing the doors will automatically activate the machine.

5-2008