Cleveland 36-CEM-16-48 User Manual

Cleveland

™

P

roject ________________________________

Item __________________________________

Quantity _______________________________

F

CSI Section ____________________________

A

pproval _______________________________

D

ate __________________________________

1333 East 179 St.,

Cleveland, Ohio, U.S.A. 44110

Tel: [phone]

Fax: [phone]

Web Site: www.ClevelandRange.com

Email: [e-mail]

CLASSIC CONVECTION STEAMERS
15 PSI BOILER BASE STYLE

CONVECTION

®

ConvectionPro XVI

TWO LARGE COMPARTMENTS, PRESSURELESS
48 KW ELECTRIC STEAM GENERATOR
36” WIDE CABINET BASE DESIGN

Cleveland Standard Features

II

Cooking Capacity for up to eight 12˝ x 20˝ x 21⁄2˝ deep
Cafeteria Pans per compartment, or four 12˝ x 18˝ Buns
Pans.

I

I

Pressureless cooking with forced convection steam,
permitting doors to be opened while cooking continues.

II

Solid State Controls operate water level and safety functions.

I

I

Each compartment is equipped with a 60 minute mechanical
timer, separate bypass switch for constant steaming and a
cold water condenser for superior cooking results.

II

Instant Steam Standby Mode: Holds generator at steam­ing temperature. Allows unit to start cooking instantly.

II

Durable 10 Gauge Stainless Steel Construction:

For Compartment Door and Steam Cooking Cavity.

II

Separate Main Power Switch for “On/Off”

II

Exclusive Steam Cooking Distribution System: The
exclusive Convection Jets produce a high velocity
convection steam without fans. Coved Corner design in
cooking compartment distributes heat evenly and is easy to
keep clean. Creased bottom enhances drainage. Cold
Water Condenser for each compartment maintains a dry
steam. Fully insulated cooking compartment for thermal
efficiency. Removable Stainless Steel Slide Racks for easy
cleaning.

II

Heavy duty, one piece, solid compartment door design
with replaceable door gasket.

Left Hand Door Hinging: Compartment Doors hinged left,

II

controls on the right.

II

Modular Cabinet Base with Hinged Door.

II

Heavy duty Stainless Steel Base Frame.

II

Electric Steam Generator: Automatic Water Fill on start up.

II

Automatic Generator Drain at shutdown: Contains a
“Water Jet” Spray Rinse Cleaning Cycle to keep drain clear.

II

Automatic Water Level Control System with Low Water
Power Cut-off Circuit.

II

Steam generator equipped with High Limit Pressure Safety
Switch, 15 psi Safety Valve, and Steam Generator Pressure
Gauge.

II

Secondary Low Water Cut-Off, factory installed (CALE)

(Required for AZ. AR. CA. CO. CT. DE. FL. GA. HI. IL. IA. KS. MD. MA. MI.
MN. MT. NE. NV. NM. NC. OK. OR. PR. RI. TN. UT. VA. WA. WV., Buffalo, NY,
Wash. DC)

II

NSF Certified 6˝ Stainless Steel Legs with adjustable
flanged feet for a one inch level adjustment.

STEAMERS

MODEL:  36-CEM-16-48

Shown with optional
Electronic Timer

Short Form Specifications

Shall be Two Large Compartments, CLEVELAND Convection Steamer,
Model 36-CEM-16-48, 48 KW Electric; _____ volts, _____ Hz, _____ phase, 3
wire. Solid State Controls operate timing, water level and safety func­tions.Type 304 Stainless Steel cooking compartment. Insulated cooking
compartments. One 60 minute Mechanical Timer with Touch Control per
compartment. Audible and Visual Signals for completion and steam shut-off.

II

Standard voltage 208 or 240 volts, 60 Hz, 3 phase.

II

All Controls are serviceable from the front.

II

Compartment Door Steam Shut Off Switch.

Options & Accessories

Ë Electronic Timer with Compensating Load Feature. (ETC)
Ë ON/OFF Steam Switch only for compartment controls (MC)
Ë Cafeteria pans in depths of 1˝, 2
Ë 12˝ x 18˝ Bun Pans
Ë Voltages other than standard (see back page)
Ë Correctional Packages
Ë Boiler Descaling Pump Kit (107142)
Ë Water Filters

1

⁄2˝, 4˝ and 6˝

SECT. III PAGE 25

0609

Each compartment has capacity for:

C

•

Eight, 12˝ x 20˝ x 2

1

⁄2˝ deep Cafeteria Pans. Can

accomodate 18˝ x 26˝ Bun Pans.

Many regional, state and local codes exist and it is the

•

responsibility of the owner and installer to comply with
those codes.

Cleveland Range equipment is built to comply with

•

applicable standards for manufacturers. Included
a

mong those approval agencies are: UL, A.G.A.,

N

SF, ASME/N.Bd., CSA, CGA, ETL, and others.

WATER QUALITY REQUIREMENT

The recommended minimum water quality standards

hether untreated or pre-treated, based upon 10 hours of

w
use per day, and a Daily Blowdown, are as follows:

TOTAL DISSOLVED SOLIDS less than 60 par ts per million
TOTAL ALKALINITY less than 20 par ts per million
SILICA less than 13 par ts per million

H FACTOR greater than 7.5

p
CHLORINE less than 30 par ts per million

onsult a local water treatment specialist for an on site

C
water analysis for recommendations concerning steam

generator feed water treatment (if required), in order to
remove or reduce harmful concentrations of minerals. The
use of highly mineralized water will mean that more frequent
servicing of the steam generator will be necessary. The fact
that a water supply is potable is not proof that it will be
suitable for the generator.

ELECTRIC

KW Volts Watts Ph Amps Wire
48 208 42,900 3 119.2 3

220 48,000 3 126.1 3
240 48,000 3 115.6 3
440 40,300 3 52.9 3
480 48,000 3 57.8 3
600 48,000 3 46.2 3
360 42,900 3 68.9 4
380 48,000 3 73.0 4
415 48,000 3 66.9 4

NOTES:

Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are ASME/N. Bd, UL/NSF#4 and CSA.

WATER DRAINAGE CLEARANCE

Cold Water Inlet
35 psi minimum
60 psi maximum

1/4˝ NPT
Condenser feed
3/8˝ NPT Boiler
feed

The Floor Drain must be located
outside the confines of the
equipment base.

1 1/2˝ I.P.S. common drain.

Do not connect other units to this drain.
Do not use PVC pipe for drain.

D

Right - 3”, Left - 3”,
Rear - 3” (12” on control
side if adjoining wall or
equipment is over 30” high
for service access)

Contact factory for
variances to clearances.

(NOT TO SCALE)

SECT. III PAGE 26

0609

Litho in U.S.A