Cleveland
™
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
Technology
T
M
S
t
e
a
m
S
a
v
e
r
HIGH EFFICIENCY GENERATOR STYLE
GAS CONVECTION STEAMERS
Gemini 6 SST
TWIN, INDEPENDENT GAS-FIRED GENERATOR
with SteamSaver™ TECHNOLOGY
and ENERGY STAR APPROVED
Cleveland Standard Features
I
I
Exclusive SteamSaver™ Technology (SST) is an energy and
ater saving compartment design that automatically controls
w
steam production based on the type and volume of food being
prepared. The Gemini SST with its high efficiency forced air gas
generator design allows enough steam to be produced for
proper cooking times while minimizing energy use and saving
water
II
54.5” (1385mm) height to top of upper compartment
(lower height makes maintenance easier by lowering the descaling ports)
II
Each compartment has cooking capacity for 3 each
12˝ x 20˝ x 2
II
Doors hinged left and the controls on the right
II
High efficiency independent Power Burner Steam Generators
50,000 BTU's for each compartment
II
Each steam-cooking compartment is independently operated
and controlled by a separate stainless steel steam generator,
gas valve, Power On/Off Control Levers and a Exclusive,
Remote Probe-Type Water Level Control
II
Easy Access Cleaning Port: Each generator has a deliming port
located on the outside, top of the unit
II
Generator Cleaning Light for each compartment warns the operator to delime generator
II
Generator Steam Standby Mode: Holds generator at a
steaming temperature, allows unit to start cooking quickly
II
Each compartment has one, 60-Minute Electro-Mechanical
Timer with "SureCook" load compensating feature.
Manual Bypass Switch for constant steaming.
II
Durable 14 Gauge, 304 Stainless Steel construction for
compartment door, cooking cavity and steam generator
II
Exclusive Gemini Drain/Power Control System:
Manual 1/2 inch "Ball Valve" type drain that controls main power
On/Off and automatically fills generator (located on the control
panel)
II
Exclusive Brass Steam Jets distribute steam evenly throughout
cooking compartment
II
Easy, Front -Access Generator Controls comes with a pullout
drawer for simple servicing of unit
II
6˝ Stainless Steel Adjustable Legs with Flanged Feet
II
Approvals: CSA (formerly AGA) U.L/NSF#4 and Energy Star
II
Compartment Steam Shut-Off Switch when compartment door
is opened
1
⁄2˝ Steam Table Pans
MODEL: 24CGA6.2SES
Short Form Specifications
Cleveland Gemini 6 SST Model 24CGA6.2SES 54.5" high, Two
compartment steamer
approved,
partment.
sating feature. Gas valve and water level control system. Exclusive
remote probe-type water level controls. Exclusive Brass “Steam
Jet” distribution system. Two-piece free-floating compartment door.
14 gauge stainless steel cavity and door. Pullout service drawer for
controls and Gemini Drain/Power Control System.
Independent steam generators
"SureCook" electro mechanical timer with load compen-
Options & Accessories
Ë Electronic Timer with Compensating Feature (ETC)
Ë On/Off Steam Switch Controls, no timer (MC)
Ë Dissolve
markings (106174)
Ë Water Filters (9797-21 KleenSteam II)
®
Descale Solution, 6 one gallon container w/quart
with SteamSaver™ Technology and Energy Star
, 50,000 BTU's input per com-
SECT. IV PAGE 11B
0609
20.63
33.13
4.87
7.75
10.44
5.00
12.76
1
5.06
17.43
59.21
1
3.25
10.00
2
.06
2
0.88
5.00
4.75
13.88
20.36
23.37
A GAS B ELECTRIC COLD WATER CLEARANCE C DRAINAGE
1-1/4" IPS line size, 3/4" connection
115V-1Phase, 60 Hz. 35 PSI minimum RIGHT = 12.00" for service
2" dia. OD
BTU 2 Fans & controls 60 psi maximum SIDES = 3.00”
50,000
each
150 watts each
(1) 1/2" dia. IPS for
D
Condenser
REAR = 3.00” Do not connect other units to
this drain.
Generator
FRONT = 24.00” Drain must be free air vented.
NATURAL
Piping 3/4" NPT
Supply pressure
4.50" W.C. Min.
14.00” W.C. Max.
PROPANE
Piping 3/4" NPT
Supply pressure
11.00" W.C. Min.
14.00” W.C. Max. 100,000 total
(1) 3/8" dia. IPS for
E
Generator
elba eb tsum gnibmulp niarD
to withstand 140°F (60°C).
The drain must not be located
beneath the steamer itself.
Manufacturer must be notified if unit will
be used above 2,000 feet
WATER QUALITY
REQUIREMENTS
The quality of water varies
greatly from region to region.
Steam equipment generators
must be drained daily and chemically descaled periodically to
ensure proper operation. To min-
mize service problems caused
i
by the accumulation of minerals
and chemicals in water review
the following quality guidelines
with a local water treatment specialist. Inlet water that is beyond
these specified guidelines
should be treated to achieve
these acceptable limits. Total
Dissolved Solids less than 60
ppm, Alkalinity less than 20
ppm, Silica less than 13 ppm,
pH factor greater than 7.5,
Chlorine less than 30 ppm.
Each Compartment has Capacity for:
• Three 21⁄2˝ x 12˝ x 20˝ Steam
Table Pans
• Six 1˝ x 12˝ x 20˝ Steam Table
Pans
• Two 4˝ x 12˝ x 20˝ Steam Table
Pans
Energy Star Data
(Heavy Load #3 Red Skin Potatoes)
Cooking Time (min) 25.8 3.6
Preheat Energy 16,860 15,587
(btu/kw) h
Idle Energy Rate 3,711 3,709
(btu/kw) h
Potato Production 187 122
(lbs/h)
Cooking Efficiency % 44.7% 39.3%
Energy Consumption 127.9 99.6
(Btu//kW) h
Cooking Energy Rate 47,683 37,657
(Btu//kW) h
Use the above information to access the Foodservice
Technology Center Life-Cycle and Energy Cost
Calculator @
http://www.fishnick.com/saveenergy/tools/calculators/
24CGA10.2ES 24CGA6.2SES
NOTES:
**DO NOT CONNECT TO GFI OUTLET. CLEVELAND RANGE RECOMMENDS GAS FIRED 120 VOLT STEAMERS BE HARD WIRED DIRECTLY TO ELECTRICAL SYSTEM.
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are UL/NSF#4 and CSA (AGA, CGA).
(NOT TO SCALE)
SECT. IV PAGE 12B
0609
Litho in U.S.A.