Cleveland 24-CEA-10 User Manual

Cleveland

™

roject ________________________________

Item __________________________________

Quantity _______________________________

CSI Section ____________________________

pproval _______________________________

ate __________________________________

1333 East 179 St.,

Cleveland, Ohio, U.S.A. 44110

Tel: 1-216-481-4900

Fax: 1-216-481-3782

Web Site: www.ClevelandRange.com

Email: Steam@ClevelandRange.com

STEAMCRAFT®GENERATOR STYLE HIGH SPEED CONVECTION STEAMERS

SteamCraft®GeminiTM10

TWO COMPARTMENT FLOOR MODEL DESIGN PRESSURELESS CONVECTION STEAMER TWIN ELECTRIC STEAM GENERATORS, 16 KW EACH

Cleveland Standard Features

Cooking Capacity for up to ten 12˝ x 20˝ x 21⁄2˝ deep Cafeteria Pans, five each compartment.

Innovative PowerPak Electric Steam Generator: Twin

Vertical Atmospheric Electric Steam Generators operate independently. Two 8 KW Fire Bar Heating Elements per generator. Strong 14 Gauge Stainless Steel Construction. Large 5 gallon generator reservoir for each compartment for high speed steam cooking production. Two fully insulated rear mounted independent steam generators.

Each steam-cooking compartment is independently operated and controlled by a separate stainless steel steam generator.

Easy Access Generator Cleaning Port: Two Generator Cleaning Ports located on the outside, top of the unit.

Generator Cleaning Light: Indicator Light located on the front of the unit warns operator it is time to delime generator.

Instant Steam Stand By Mode: Hold generator at a steaming temperature. Allows unit to start cooking instantly.

Durable 14 Gauge, Stainless Steel Construction:

For compartment door, cavity and steam generator.

Two 60 Minute Electro-Mechanical Timers and Switches for manual operation: Audible signal for cooking time

completion. (MCS)

Main Power On/Off Switch: Automatically fills generator with water, and then starts heating elements in generator.

Exclusive Steam Cooking Distribution System:

Exclusive Brass Steam Jets produce a high velocity convection steam without fans. Coved Corner design in cooking compartment distributes heat evenly, and is easy to clean. Creased top & bottom enhance drainage. Cold Water Condenser for each compartment maintains a dry steam. Fully Insulated cooking compartment for thermal efficiency. Removable Stainless Steel Slide Racks.

Automatic Generator Drain: Contains a “Water Jet” Spray Rinse Drain Cleaning Cycle to keep drain clear.

Exclusive Automatic Probe for Water Level Control:

Separate from the generator for easy access, contains a high velocity rinse cycle to eliminate mineral build up.

Exclusive “Cool to the Touch” Two-Piece Compartment

Door Design: Free floating inner door with reversible gasket provides an air tight seal. Stainless Steel Slam/Latch Door Latch mechanism for reliability.

Condensate Drip Trough: Provide under lower compartment door to collect condensate.

Left Hand Door Hinging: Compartment Doors hinged on the left, controls on the right.

I NSF Certified 6˝ Stainless Steel Legs with adjustable

flanged feet for a one inch level adjustment.

MODEL:  24-CEA-10

Shown with optional Electronic Timer

Shall be Two Compartments, Cleveland Convection Steamer series

SteamCraftGeminiTM10

Steam Generator, 32 KW input. Controls Generator Blowdown, Two each 16.5 KW Fire Bar Heating Elements. Choice of Compartment Controls, Manual By Pass Operation Mode, Exclusive Cold Water Condenser design, Type 430 Stainless Steel exterior and cooking compartments.

Options & Accessories

Ë Right hand Door Hinging, Controls on the Right (DHR) Ë Electronic Timer with Compensating Load Feature (ETC) Ë ON/OFF Steam Switch only for compartment controls (MC) Ë 10˝ Stainless Steel Legs (LF10) Ë Dissolve

markings (106174)

Ë Compartment Door Steam Shut Off Switch (SCS) Ë Cafeteria Pans in depths of 1˝, 2 Ë Low Wattage Option, 8 KW each compartment (LWO)

Ë Water Filters

Short Form Specifications

, Model 24-CEA-10, Twin Electric Atmospheric

. Steam Generator with Automatic Water Fill on start up. Automatic

Descale Solution, 6 one gallon container w/quart

Remote Probe Type Water Level

⁄2˝ and 4˝

SECT. IV PAGE 15

0609

Each Compartment has capacity for:

C1 C2

• Five, 12˝ x 20˝ x 2

⁄2˝ deep Cafeteria Pans.

WATER QUALITY REQUIREMENT

The quality of water varies greatly from region to region. Steam equipment must be blown down daily

nd chemically descaled periodically to ensure

a proper operation. To minimize service problems

caused by the accumulation of minerals and chemicals in water, review the following quality guidelines with a local water treatment specialist. Inlet water that is beyond these specified guidelines should be treated to achieve the acceptable limits.

TOTAL DISSOLVED SOLIDS less than 60 parts per million TOTAL ALKALINITY less than 20 parts per million SILICA less than 13 parts per million pH FACTOR greater than 7.5 CHLORINE less than 30 parts per million

A typical water quality analysis can be secured from your local water district. Water that is potable does not guarantee compatibility with steam equipment.

COLD WATERELECTRIC

35 psi minimum

Volts Watts Ph Amps Wire

208 32,600 3 91.7 3 220 27,393 3 72.9 3 240 32,600 3 79.5 3 440 27,393 3 36.4 3 480 32,600 3 39.8 3 360 29,259 3 47.6 4 380 32,600 3 50.2 4 415 32,600 3 46.0 4

Volts Watts Ph Amps Wire

208 16,600 3 47.3 3 220 13,948 3 37.6 3 240 16,600 3 41.0 3 440 13,948 3 18.8 3 480 16,600 3 20.5 3 360 14,899 3 24.5 4 380 16,600 3 25.9 4 415 16,600 3 23.7 4

TOTAL CAPACITY (2 Compartments)

10 — 12˝ x 20˝ x 21⁄2˝ Cafeteria Pans or 20 — 12˝ x 20˝ x 1˝ Cafeteria Pans or

26 — 12˝ x 20˝ x 4˝ Cafeteria Pans

NOTES:

Cleveland Range reserves right of design improvement or modification, as warranted. Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes. Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are UL, ULC, UL/NSF#4 and CSA (AGA, CGA).

Electrical Supply Drain: 1.50˝ Dia.

Cold Water Supply for Condenser 3/8˝ Dia. NPT Inlet for Generator Deliming Solution

Cold Water Supply for Generator and Water Injection.

3/8˝ Dia. NPT (for water treatment conn.) Unit comes with a 50 Mesh Water Strainer (installation required)

60 psi maximum

⁄8˝ Dia. NPT for Generator (for water treatment connection)

⁄8˝ Dia. NPT for Condenser

UTILITY CONNECTIONS

DRAINAGE

11⁄2˝ dia.

Do not connect other units to this drain

Drain must not be located beneath the steamer itself. Preferred floor drain location should be a minimum distance (from the unit) of at least 12” from the left side, 12" from the right side, 6” from the front and 6" from the rear

Do not use PVC pipe

CLEARANCE

Right - 3”, Left - 3”, Rear - 3” (12” on control side if adjoining wall or equipment is over 30” high for service access)

Contact factory for variances to clearances.

(NOT TO SCALE)

SECT. IV PAGE 16

Litho in U.S.A.

0609