ClearSounds Wake & Shake, Wake & Shake WS1 User Manual
COMMUNICATIONS
™
Wake & Shake
™
Large Display Alarm Clock
& Telephone Ring Signaler
User’s Guide
Important Safety Instructions
When using your alarm clock, always follow basic safety
precautions to reduce the risk of fire, electrical shock and injury
to persons, or property, including the following:
1.Read and understand all instructions, warnings and product
markings.
2.Be aware there is a slight possibility of electrical shock from
lightening.
3.Do not use this product near or in water or when you are wet. If
the product comes in contact with any liquid, unplug the power
cord and telephone cord immediately. Do not plug the product
back in until is has dried completely.
4.Do not use liquid or aerosol sprays for cleaning.
5.If this product does not operate properly, refer to the Warranty
information on page 9 of this manual. Do not open this product
as you may expose yourself to hazardous voltages or other risks.
Opening this product automatically voids the warranty.
6.Unplug this product from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
a.When the power supply cord or plug is damaged or frayed.
b.If liquid has been spilled on the product.
c. If the product has been exposed to rain and water.
d.If the product does not operate normally by following the operat-
ing instructions. Adjust only those controls that are covered by
the operating instructing because improper adjustment of
other controls may result in further damage.
e.If the product has been dropped or appears damaged.
f. If the product exhibits a distinct change in performance.
SAVE THESE INSTRUCTIONS
Description
%:)$
Installation
Your Wake & Shake offers you the option of using it as both an
alarm clock and a telephone ring signaler. The following diagram shows
you how to set up your Wake & Shake so you may use it for both.
NOTE: Setting up your Wake & Shake as a telephone ring signaler requires the use of a
phone jack adapter. This is a small inexpensive
device available at your local drug or hardware
store. (See #1)
1.Plug Dual Phone Jack Adapter into wall jack.
2.Plug telephone line from your telephone into one jack on adapter.
3.Plug one side of line cord (included) into phone jack on the back of
the clock and the other into the available jack on the adapter.
4.Plug the AC power adapter into the adapter jack on the back of the
clock.
5.Plug the AC power adapter into an electrical wall outlet.
6.Plug the Bed Shaker into the jack in the back of the phone.
dual
Now your Wake & Shake is ready for use. Simply set the time &
alarm and you are ready to go.
Loading...