Clear-Com AC60 Quick Start Manual

Page 1 399G108 Rev C 08/07/15

The beltpack can use a rechargeable Li-Ion

Power connector

Mounting bracket

Mounting bracket

Support for optional

moun ting bracket

Quick

Guide

FreeSpeak II™ battery charger

Optional wall-mounting bracket

Start

A FreeSpeak II (FS II) battery charger (AC60) allows you to charge up to five FS II beltpacks
simultaneously. You can use it either as a drop-in charger for the whole beltpack, or you can
charge separate beltpack Li-Ion batteries (BAT60) in the charging slots provided. You can use
the charger either as a desktop unit, or you can mount it to a wall using an optional wall
bracket.

Installing the battery charger

1) Either mount the charger to a wall using
the optional wall bracket or leave on a
desktop.

2) Connect the power supply to the power

Charging the beltpack

battery or AA batteries. The charger can charge
up to five Li-Ion batteries simultaneously.

connector.

Quick Start Guide | FreeSpeak II ™ battery charger (AC60)

Page 2 399G108 Rev C 08/07/15

Note: You can also recharge batteries by using

the supplied USB charger. However, this
will not charge AA cells.

1) Insert either the beltpack containing the
battery, or the battery itself into one of
the recharging bays on the battery
charger. A red LED indicates that the
battery is recharging.

2) If you are recharging the battery while it
is still in the beltpack battery
compartment, an illuminated beltpack key
(Talk key A) indicates the charging status.
The table below shows the charging
status conditions.

Status indicator Status

Talk key A or

Charging
charger status
LED red

Talk key A or

Fully charged
charger status
LED green

Beltpack screen

Displays current

percentage charge

and software version.

3) Wait until the recharging LED turns from
red to green (up to 2 hours). The battery
is now fully recharged.

Note: If a beltpack is on when placed in

the charger, when removed the
RF is re-enabled and the beltpack
attempts to reconnect to its
previous system. If a beltpack is
off when placed in the charger, it
powers off when removed.

Copyright © 2015 HME Clear-Com Ltd. All rights reserved.