Clarity Telephone User Manual
4289 Bonny Oaks Drive • Chattanooga, TN 37406
TEL:
(800) 426-3738 • FAX: (800) 325-8871
Email: claritycs@plantronics.com Website: www.clarityproducts.com
E
N
G
L
I
S
H
F
R
A
N
Ç
A
I
S
JV
M021004 JV-35 C 2/04 English
∆
JV-35
The Talking Phone
™
Ameriphone products are manufactured by
Clarity
®
, a Division of Plantronics, Inc.
4289 Bonny Oaks Drive, Chattanooga,TN 37406
Tel: (800) 426-3738 Fax:(800) 325-8871
Email: claritycs@plantronics.com Website: www.clarityproducts.com
©2004 Clarity, a Division of Plantronics, Inc. All rights reserved.
Ameriphone, Amplifying Your Life, Clarity and The Talking Phone are trademarks or registered trademarks of Plantronics, Inc.
Operating Instructions
Contents
Important Safety Instructions
. . . . . . . . . . . . . . . . . . . . . . ii
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Package Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Features Identification . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation
A. Desk mounting . . . . . . . . . . . . . . . . . . . . .4
B. Wall mounting . . . . . . . . . . . . . . . . . . . . .4
C. Batteries . . . . . . . . . . . . . . . . . . . . . . . . .5
Operating Your JV-35
A. Dialing . . . . . . . . . . . . . . . . . . . . . . . . . .7
B. Making calls louder . . . . . . . . . . . . . . . . . .7
C. Adjusting the tone . . . . . . . . . . . . . . . . . . .8
D. Ringer volume . . . . . . . . . . . . . . . . . . . . . .8
E. Hold . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
F. Last number redial . . . . . . . . . . . . . . . . . . 9
G. Programming the Emergency buttons . . . . 10
H. Dialing with an Emergency button . . . . . . . 11
I. Programming frequently dialed numbers . . . 11
J. Memory dialing . . . . . . . . . . . . . . . . . . . 12
K. Recording Emergency button
identification announcements . . . . . . . . . . 12
L. Recording memory button
identification announcements . . . . . . . . . . 14
M.Recording number button announcements . . 15
N. Selecting number button announcements . . . 17
O. Direct audio connection . . . . . . . . . . . . . .18
P. Cochlear implant adapter cord . . . . . . . . .18
Troubleshooting Chart . . . . . . . . . . . . . . . . . . . . . . . . . .20
Regulatory Compliance . . . . . . . . . . . . . . . . . . . . . . . . .21
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .30
i
ii
E
N
G
L
I
S
H
Important Safety
Instructions
When using your telephone
equipment, basic safety precautions
should always be followed to
reduce the risk of fire, electric
shock and persons including the
following:
1.Read and understand all
instructions.
2.Follow all warnings and
instructions marked on the
telephone.
3.Do not use this telephone
near a bathtub, wash basin,
kitchen sink or laundry tub, in
a wet basement, near a
swimming pool or anywhere
else there is water.
4.Avoid using a telephone
(other than a cordless type)
during a storm. There may be
a remote risk of electrical
shock from lightning.
5.Do not use the telephone to
report a gas leak in the
vicinity of the leak.
6.Unplug this telephone from
the wall outlets before
cleaning. Do not use liquid
cleaners or aerosol cleaners
on the telephone. Use a damp
cloth for cleaning.
7.Place this telephone on a
stable surface. Serious damage
and/or injury may result if the
telephone falls.
8.Do not cover the slots and
openings on this telephone.
This telephone should never
be placed near or over a
radiator or heat register. This
telephone should not be
placed in a built-in installation
unless proper ventilation is
provided.
9.Operate this telephone using
the electrical voltage as
stated on the base unit or the
owner’s manual. If you are
not sure of the voltage in your
home, consult your dealer or
local power company.
10. Do not place anything on
the power cord. Install the
telephone where no one will
step or trip on the cord.
11. Do not overload wall outlets
or extension cords as this
can increase the risk of fire or
electrical shock.
12. Never push any objects
through the slots in the
telephone. They can touch
2
dangerous voltage points or
short out parts that could
result in a risk of fire or
electrical shock. Never spill
liquid of any kind on the
telephone.
13. To reduce the risk of electrical
shock, do not take this phone
apart. Opening or removing
covers may expose you to
dangerous voltages or other
risks. Incorrect reassembly
can cause electric shock when
the appliance is subsequently
used.
14. Unplug this product from the
wall outlets and refer
servicing to the manufacturer
under the following conditions:
A. When the power supply
cord or plug is frayed or
damaged.
B. If liquid has been spilled
into the product.
C. If the telephone has been
exposed to rain or water.
D. If the telephone does not
operate normally by
following the operating
instructions. Adjust only
those controls that are
covered by the operating
instructions. Improper
adjustment may require
extensive work by a
qualified technician to
restore the telephone to
normal operation.
E. If the telephone has been
dropped or the case has
been damaged.
F. If the telephone exhibits a
distinct change in
performance.
15. Never install telephone
wiring during a lightning
storm.
16. Never install telephone
jacks in wet locations
unless the jack is specifically
designed for wet locations.
17. Never touch uninsulated
telephone wires or terminals
unless the telephone line
has been disconnected at
the network interface.
18. Use caution when installing
or modifying telephone lines.
19. Use only the power cord
and batteries indicated in
this manual. Do not dispose
of batteries in a fire. They
Important Safety
Instructions
3
E
N
G
L
I
S
H
may explode. Check with
local codes for possible
special disposal instructions.
ADDITIONAL SAFETY NOTES
FOR CANADIAN USERS
The following items are included
as part of the CS-03 Requirements.
The standard connecting
arrangement for the equipment is
CA11A. This product meets the
applicable Industry Canada
technical specifications.
NOTICE: The Canadian
Department of Communications
label identifies certified equipment.
This certification means that the
equipment meets certain
telecommunications network
protective operational and safety
requirements. The Department does
not guarantee that the equipment
will operate to the user’s
satisfaction. Before installing this
equipment, users should ensure
that it is permissible to be
connected to the facilities of the
local telecommunications company.
The equipment must also be
installed using an acceptable
method of connection. In some
cases, the company’s inside
wiring associated with a single
line individual service may be
extended by means of a certified
connector assembly (telephone
extension cord). The customer
should be aware that compliance
with the above conditions may not
prevent degradation of service in
some situations. Repairs to certified
equipment should be made by an
authorized Canadian maintenance
facility designated by the supplier.
Any repairs or alterations made
by the user to this equipment, or
equipment malfunctions, may give
the telecommunications company
cause to request the user disconnect
the equipment.
Users should ensure for their own
protection that the electrical
ground connections of the power
utility, telephone lines and internal
metallic water pipe system, if
present, are connected together.
This precaution may be particularly
important in rural areas.
Important Safety
Instructions
4
CAUTION: Users should not
attempt to make such connections
themselves, but should contact the
appropriate electric inspection
authority, or electrician, as
appropriate. The Ringer
Equivalent Number is an
indication of the maximum number
of terminals allowed to be
connected to a telephone
interface. The termination on an
interface may consist of any
combination of devices subject
only to the requirement that the
sum of the Ringer Equivalent
Number of all the devices not
exceed five.
SAVE THESE INSTRUCTIONS
Important Safety
Instructions
F
R
A
N
Ç
A
I
S
E
N
G
L
I
S
H
1
Introducing the JV-35
Thank you for selecting the
exciting new JV-35 from
Ameriphone. It has been
designed to meet the highest
quality standards to provide
you with years of convenient
and trouble-free service
Please read these operating
instructions thoroughly
before using your telephone.
Keep this manual for future
reference.
You must save your sales
receipt as proof of purchase
in the event that you need
warranty service.
If you have any questions
about your JV-35, please
call our Customer Service
Department at 800-874-
3005.
2
Package Checklist
OPERATING
INSTRUCTIONS
AND
QUICK GUIDE
JV-35
Handset
Base Unit
Telephone Line Cords
Handset
Coil Cord
Operating Guides
Figure 1 - Package Components
Phone Base Plate
Phone Cords
E
N
G
L
I
S
H
3
Features on the JV-35
Figure 2 - Base Unit Controls
Ringer volume
control switch
Audio output jack
AC adapter
Announcement
switch
Tone / Pulse switch
Emergency buttons
Braille characters
Raised letters for
easy identification
REDIAL button
MEMORY button
VOL control (volume)
AMPLIFY button
PROG button
(program)
TONE
selector
HOLD
button
4
Installation
A. Desk Mounting
1. Plug in the long phone
cord.
2. Plug the handset cord
into the telephone.
3. Insert the AC Adapter
cord into the receptacle
on the back of the
JV-35. Then plug the
AC Adapter into an
electrical outlet.
4. Lift the handset and
listen for a dial tone
5. Your JV-35 is ready to
use.
B. Wall Mounting
1. Pull the handset hook
out and reverse its
position so that the
hook points up.
2. Install the Base Plate by
sliding the small tabs
into the upper slots.
Push on the bottom of
the Base Plate until it
snaps into place.
Fig.3 - Connections and
installation
Fig. 4- Repositioning the hook
Fig. 5 - Phone base installation
for wall mounting
E
S
P
A
Ñ
O
L
F
R
A
N
Ç
A
I
S
5
Installation
3. Plug in the short phone
cord.
4. Insert the AC Adapter
cord into the receptacle
on the back of the
JV-35. Then plug the
AC Adapter into an
electrical outlet.
5. Align the posts on the
wall mount with the
holes in back of the
JV-35. Slide the phone
down on the posts to
secure it.
6. Lift the handset and
listen for a dial tone.
7. Your JV-35 is ready to
use.
C. Batteries
During a power outage the
JV-35 will maintain full
function if back-up batteries
have been installed in
advance. If batteries are not
installed during a power
outage, the
AMPLIFY button,
the voice announcements and
the Ring Flasher will not
work.
Note: A set of new batteries
can last up to 100 hours
during a power outage.
Install four AA alkaline
batteries. Use alkaline
batteries only.
E
N
G
L
I
S
H
Fig. 6 - Wall mounting
installation.
Loading...