Thank you for purchasing the Clarion TB741P/TB742P/TB743W.* Please read this Owner’s manual & Installation manual in its entirety before proceeding with wire
connection and installation.
* After reading this manual, be sure to keep it in a handy place (e.g., glove compartment).
9. SAMPLE SYSTEMS ................................................................................................................... 28
English
Owner’s manual
2TB741P/TB742P/TB743W
Be sure to unfold and read the next page.
English
1. CONTROLS/控制器/컨트롤
Note:
Be sure to spread this page and refer to the front diagrams when you read each chapter.
注意:
Owner’s manual
在您閱讀每一章時請把本頁打開,併與前視圖對照。
참고: 이 페이지를 펼쳐두고, 각 장을 읽을때 전면 그림을 참조하도록 하십시오.
w
da
[
BND
]
z
LCD panel
LCD顯示屏
LCD 패널
[
PWR
[
RESET
[
]
]
]
[
]
DISP
[
TILT
[
OPEN/CLOSE
]
[PS]
[
MEMO
]
[
]
ADJ
SENSOR
]
English
2. FEATURES
■ 7" Wide (16:9) TFT Active Matrix Color LCD Panel
■ 4 Modes Supported: Cinema, Wide, Full Wide and Normal
Owner’s manual
■ Wide Viewing Angle, Low Reflection and High-brightness Panel Employed
■ Fully-Motorised Mechanism
■ Preset Tuning (total of 12 stations), Manual Tuning and Automatic Tuning
Facilities for Speedy Selection of Any Broadcast Station
■ Very Easy and Functional Operation
■ Built-in 4-channel Diversity Unit
■ 2 AV input (RCA/DIN)
■ 1 AV output (RCA)
■ RADIO ANT IN/OUT (TB741P, TB742P only)
3. PRECAUTIONS
English
CAUTION
For your safety, the driver should not watch
the TV or operate the controls while driving.
Please note that watching and operating the
TV while driving is prohibited by law in
some countries. Also, while driving, keep
the volume to a level at which external
sounds can be heard.
1. When the inside of the car is very cold and
the player is used soon after switching on
the heater, moisture may form on the disc or
the optical parts of the player and proper
playback may not be possible. If moisture
forms on the disc, wipe it off with a soft cloth.
If moisture forms on the optical parts of the
player, do not use the player for about one
hour and the condensation will disappear
naturally to allow normal operation.
2. Driving on extremely bumpy roads which
cause severe vibration may cause the sound
to skip.
3. This unit uses a precision mechanism. Even
in the event that trouble arises, never open
the case, disassemble the unit, or lubricate
the rotating parts.
4. TV broadcast reception
When receiving TV broadcasts, the strength
of the signals changes since the car is
moving, so in some cases it may not be
possible to receive clear pictures.
• TV signals are strongly linear, so
reception is affected by buildings,
mountains, and other obstacles.
• Such external factors as electric train
lines, high voltage lines, and signal
devices may disturb the picture or cause
noise.
∗ If the reception is poor, switch to a station
with good reception.
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE
MANUFACTURER WILL VOID THE WARRANTY.
Owner’s manual
TB741P/TB742P/TB743W5
English
4. BUTTON TERMINOLOGY
Note: Be sure to read this chapter referring to the front diagrams of chapter “1. CONTOROLS” on page 3
Owner’s manual
(spread).
[OPEN/CLOSE] button
• Use this button to open/close the liquid crystal
panel.
• Press and hold this button for about 2
seconds or longer so that the liquid crystal
panel is positioned horizontally when the
liquid crystal panel is open. Press the button
again to return the panel to the original
position. Even if the button is not pressed, the
panel returns to the original position after
about 10 seconds.
[TILT] button
• Use this button to adjust the angle of the
liquid crystal panel in 5 steps.
• Each time this button is pressed and held for
about 2 seconds or longer, the liquid crystal
panel moves forward/backward in 3 steps.
[ADJ] button
• Shows the ADJUST MODE menu to change
the settings.
[MEMO] button
• Shows the manual memory screen to store
the station.
• Press and hold this button for 1 second or
longer to store the station in manual memory
function.
[BND] button
• Press this button to switch the receiving
bands.
• Press and hold this button for 1 second or
longer to turn on/off the monitor.
• Press this button to return to the previous
screen in the adjustment menu screen.
[a], [d] buttons
• Press to perform the Manual tuning operation.
• Press and hold for 1 second or longer to
perform the Seek tuning operation.
• Press to select the desired mode in
adjustment menu screen.
[w], [z] buttons
• Press to select the preset channel.
• Press to select the desired menu in
adjustment menu screen.
[SENSOR]
• Remote control infrared sensor.
[RESET]
• Press [OPEN/CLOSE] button or [TILT]
button, the LED of this button blinks.
• Press this button, frequencies of TV, etc.
stored in memory are cleared.
[PS] button
• Press to perform preset scans.
• Press and hold for 1 second or longer to
perform the auto store operation.
[DISP] button
• Press this button to show the information on
the screen.
• Press and hold this button for 1 second or
longer to switch the display sizes.
[PWR] button
• Press this button to turn on/off the power.
6TB741P/TB742P/TB743W
5. CAUTIONS ON HANDLING
English
For a longer service life, be sure to read the
following cautions.
• Be sure to store the LCD panel inside the
source unit when parking the car outdoors
for long periods of time.
The LCD panel will operate properly in a
temperature range of 0 to 60°C.
• Don’t allow any liquids on the set from
drinks, umbrellas etc. Doing so may damage
the internal circuitry.
• Do not disassemble or modify the set in any
way. Doing so may result in damage.
• Do not draw the LCD panel out and use it as
a tray. Also, subjecting the LCD panel to
shocks may result in breakage, deformation
or other damage.
• Do not let cigarettes burn the display. Doing
so may damage or deform the cabinet.
• Do not insert objects into the video input
jack.
• If a problem should occur, have the set
inspected at your store of purchase.
• Do not insert objects or poke in the space
between the LCD panel and the source unit
when the panel is tilted.
• Do not place anything on the display when
the LCD panel is tilted.
• Do not hold on the screen when adjusting
the angle of the LCD panel. Doing so may
damage it.
• The remote controller may not work if the
remote control sensor is exposed to direct
sunlight.
• The fluorescent light used behind the screen
eventually wears out. It should be replaced if
the picture becomes extremely dark or
flickers.
• The LCD panel may stop temporarily when it
is opened or closed when the engine is
stopped or when it is cold. This is not a
malfunction. If this happens, repeat the
operation.
Concerning the LCD screen
Owner’s manual
• Do not leave droplets of water on the LCD
panel since they can cause discoloration
and stains. In addition, entry of moisture
inside the unit can cause malfunctioning.
Any drops of water on the panel should be
removed immediately using absorbent
cotton or a soft cloth.
• In extremely cold weather, the movement of
the picture may be slow and the screen may
be dark, but this is not a malfunction. The
set will work normally once the temperature
increases.
• Small black and shiny dots inside the LCD
panel are normal for LCD products.
Cleaning
•
Cleaning the cabinet
Use a soft, dry cloth and gently wipe off the
dirt.
For tough dirt, apply some neutral detergent
diluted in water to a soft cloth, wipe off the
dirt gently, then wipe again with a dry cloth.
Do not use benzene, thinner, car cleaner,
etc., as these substances may damage the
cabinet or cause the paint to peel. Also,
leaving rubber of plastic products in contact
with the cabinet for long periods of time may
cause stains.
•
Cleaning the LCD panel
The LCD panel tends to collect dust, so wipe
it off occasionally with a soft cloth.
The surface is easily scratched, so do not
rub it with hard objects.
Concerning the wide
screen
• A wide-screen TV comes with a function for
selecting various screen modes. If you
select a screen mode that differs from the
picture ratio of the TV program or other
software media, you will not be able to view
the original pictures as was originally
intended. Bear this point in mind when
selecting the screen mode.
TB741P/TB742P/TB743W7
English
6. REMOTE CONTROL
Owner’s manual
w
da
z
Remote control unit
Receiver for remote
control unit
Operating range: 30˚ in all directions
Signal transmitter
[
POWER
[
BAND/RTN/ADJ
Inserting the Battery
]
1. Turn the remote control unit over, then slide
the rear cover in the direction of the arrow.
]
[
DISP
]
2. Insert the AA (SUM-3/1.5V) batteries that
came with the remote control unit facing in
the directions shown in the figure, then close
the rear cover.
Notes:
PS/AS
explode. Take note of the following points:
Using batteries improperly can cause them to
]
[
• When replacing batteries, replace both batteries
with new ones.
• Do not short-circuit, disassemble or heat
[
]
1-6
batteries.
• Do not dispose of batteries into fire or water.
• Dispose of spent batteries properly.
AA (SUM-3/1.5V)
Batteries
Rear cover
Rear side
8TB741P/TB742P/TB743W
Functions of Remote Control Unit Buttons
[POWER] button
• Power on/off.
[DISP] button
• Showing the information on the screen.
• Hold down (for 1 second) to select the screen
sizes.
[w], [z] buttons
• Selecting the preset channel.
• Selecting the desired menu in the adjustment
menu screen.
[BAND/RTN/ADJ] button
• Switching the receiving bands.
• Change to the previous screen in the
adjustment menu screen.
• Hold down for 1 second to show the
adjustment menu screen.
[a], [d] buttons
• Manual tuning UP/DOWN.
• Selecting the desired mode in the adjustment
menu screen.
• Hold down for 1 second for Seek tuning.
English
Owner’s manual
[PS/AS] button
• Preset scan.
• Hold down for 1 second for auto store.
[1-6] buttons
• Selecting the preset channel directly.
• Hold down for 1 second to store the current
station into preset memory.
TB741P/TB742P/TB743W9
Loading...
+ 21 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.