Car Navigation
QY-8900 MODEL
Navigation system manual
Names of Various Parts
Basic Operations
Bluetooth Operation
Navigation
�����������������������������������������������������������
���������������������������������������������������
�������������������������������������������������������
������������������������������������������������������
Navigation System Settings
Route Guidance
About Information
��������������������������������������������������������
������������������������������������������������������
Table of contents
�������������������������������������������������
10
3
4
English
5
6
8
9
1
Warning
●Changes or modifications to this unit not expressly approved by the party responsible for compliance could
English
void the user’s authority to operate the equipment.
NOTE:
G This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
zReorient or relocate the receiving antenna.
zIncrease the separation between the equipment and receiver.
zConnect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
zConsult the dealer or an experienced radio/TV technician for help.
exposure,this device must be installed to provide a separation distance of at least 20cm from all persons.”
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
●This device may not cause harmful interference, and
●This device must accept any interference received,
including interference that may cause undesired operation.
Shielded cables must be used with this unit to ensure
compliance with the Class B FCC limits.
The device must not be co-located or operating in conjunction with any other antenna or transmitter.
To comply with FCC’s and Industry Canada’s RF radiation exposure limits for general population/uncontrolled
2
1 2 3 4
6
8
9
5
!
0
@
#
7
Names of Various Parts
Panel Buttons
or night mode.
[CAMERA] button: To enter camera mode.
8
[x]Next Track button: In CD/USB/iPod/Bluetooth Au-
9
dio Device mode, short press it to select the next track
to play, and long press it to Fast Forward; in AM/FM
English
mode, short press to search radio station frequency up
automatically.
Previous Track button: In CD/USB/iPod/ Bluetooth
[v]
0
Audio Device mode, short press it to select the previous
track to play, and long press it to Fast Reverse; in AM/
FM mode, short press to search radio station frequency
down automatically.
[AUDIO] Audio button: To enter audio selection screen
!
or Audio Mode.
[MAP] Map button: Press to enter the map screen.
[Q]Eject button: Short press it to eject the disc inside
1
the unit.
Disc slot: CD disc can be inserted for playing.
2
LCD(touch screen): To display the working statuses of
3
various modes.
SD card slot: Map SD card.
4
[
TUNE-SCROLL
5
] knob/[ENTER/SOUND] button: In
AM/FM mode, rotate to search radio station frequency
manualy; press to store radio stations in memory. Press
and turn the knob to jump to previous or next touch key
@
[MENU] Menu button:Press to enter Menu Screen to
#
select audio function or navigation function.
button/Volume Knob: Switch to adjust volume; short
$
press to turn off/on audio device.
Caution
●It is prohibited to pull out the map SD card or the
system will not work.
and select it in source and menu mode. In other mode,
press and turn the knob to adjust the volume balance.
[ BACK] button: Back to the previous mode.
6
[ ]Day/night button: Press to switch between day
7
3
Basic Operations
Mode Switch
Switch to navigation mode
■
English
Press [MAP] button on the panel to
switch to navigation mode for map
display.
Switch to source mode
■
Press [AUDIO] button on the panel
or touch to switch to source mode
such as Radio mode.
touch to enter main menu
screen.
Switch to Bluetooth mobile
■
phone mode
Touch switch to Bluetooth mobile
phone mode.
4
Press [AUDIO] button or touch
in Source mode to switch
to source selection screen.
Main menu operations
On main menu screen you can enter
corresponding work mode by touch
the icons on the screen.
Press [MENU] on the panel or
1
zChange page by dragging left or
right or touch and .
Basic Settings
Press [MENU] button on the
1
panel.
Touch to enter Settings
2
Screen.
Touch the icon to enter the appro-
3
priate setting.
Source Media Mode
Press [AUDIO] button on the
1
panel or touch to enter source
screen.
Touch the icon to enter the appro-
2
priate source media.
Bluetooth Operation
Pair Bluetooth Device
Touch to enter Set-
1
tings Screen.Then touch
tooth setting screen.
Touch to select the mo-
2
bile phone or audio device to pair.
If you want to select the mobile
3
phone 秋to pair, touch .
to enter Blue-
If you want to select the audio
4
device秋to pair, touch , and
you have to edit the PIN (minimum
4 digits and maximum 16 digits) to
pair the audio device.
After entering the PIN, touch
5
and operate as per the information
prompted.
English
5
English
After successful pairing, it will
6
automatically return to Bluetooth
Setting screen.
Bluetooth Telephone
Touch to enter Phone screen.
1
Touch the icon to enter the appro-
2
priate function.
Navigation
Menu Types and Operation
Map menu (Menu on current
■
location map)
Touch on the map screen to
display the Map menu at the left side
of the screen.
Location menu (Menu on
■
scrolled map)
After scrolling the map by touching
the Map screen, touch on the
screen to display the Location menu
at the left side of the screen.
Map Screen Features
Types of the map
■
There are two types of map: the 2D
map and the 3D map.
●2D Map
6
●3D Map
Indicators on the map
■
Indicators displayed on the Map
screen are different according to the
conditions at that time.
Indicators on the map of the current
location
1
2
3
3
4
Audio mark
1
Vehicle mark
2
[ ]Map Menu key
3
[ ]Map scale key
4
[ ]Map bearing mark
5
Indicators on the scrolled map
Indicators are displayed after scrolling
the map.
1
2
3
[ ] (Slow Scroll)key
1
Displays the name of the street
2
under the cursor.
Indicators displayed during the route
guidance mode
After a destination is set and travelling
is started, the guidance route and
various guidance information are
displayed on the map.
1
2
3
Small Turn Arrow display
1
Guidance point
2
Distance to the waypoint/
3
destination
Manipulating the Map Screen
Scrolling the map
■
Touching the Map screen displays
a cursor at the centre of the screen,
you can scroll the map.
Slow scroll mode operation
■
Touch while scrolling the 2D map
to display the following screen:
Keep touching the desired arrow key
( , , , , , , , .) moves
the map slowly towards the corre-
sponding direction. To quit the slow
scroll mode, touch .
English
7
English
Zooming IN/OUT the map
■
Touch to display the zoom in/
1
out key.
Touch or to change the
2
map scale.
Changing the map appearance
■
The Map screen can be adjusted
regarding orientation or appearance
of the map.
Touch on the Map screen of
1
the current vehicle location.
Touch to enter Map
2
View screen.
8
Touch the corresponding key to
3
change the map view.
Navigation System
Settings
Press [MENU]/[MAP]/[AUDIO]
1
button on the panel to display the
function bar.
Touch , to enter
2
Navigation Settings Screen.
Touch the item to enter the appro-
3
priate setting.
Entering the Destination
Searching Your Destination
from the Destination Menu
You can search for a destination from
the Destination menu by using various methods. Use a suitable searching method according to the place
you wish to go to, then operate as
per the information prompted.
Destination menu screen
Junction Map
Turn List
1
Scrolling key
2
Route Guidance
After you have entered the destination and started the route guidance,
you will be guided along the route by
screen display and by voice.
1 2
Remaining distance indication
1
Guidance route
2
Guidance point
3
3
Turn list on Route
The screen is always divided into two
displays and the Turn List on Route
is displayed on the left display if Turn
List is activated.
Changing/Editing the Route
Settings
From the Route menu, editing the
current route, confirming the route
information, setting the conditions
of the route calculation, etc. can be
performed.
Press [MENU] button on the
1
panel.
Touch to enter Route menu
2
screen when a route had exist.
Touch the desired item to change
3
or edit the route settings.
English
1
2
9
About Information
This screen sets or displays various
information that is helpful for using
English
the vehicle safely and comfortably.
Press [MENU] button on the
1
panel.
Touch to enter Info screen.
2
Touch the desired item to view the
3
information, and about some items
you can operate as per the information prompted.
10
Loading...