Page 1
MS120-8 Series Installation Guide
Model Number Description
MS120-8
MS120-8LP
MS120-8FP
Package contents
In addition to the MS switch, the following are provided:
Wall Mount Kit includes
• Dry Wall Anchors, 2 of each
• Mounting Screw, 2 of each
MS120-8FP Series front panel
Layer-2 8-port gigabit Ethernet switch with 2 SFP
interfaces
Layer-2 8-port gigabit Ethernet 67W PoE switch
with 2 SFP interfaces
Layer-2 8-port gigabit Ethernet 124W PoE switch
with 2 SFP interfaces
MS120-8/LP Series front panel
1
Page 2
Ports and Status Indicators
The MS uses LEDs to inform the user of the device's status. When the device powers on, all the Internet LEDs flash
twice. Additional functions are described below, from left to right.
Item Function LED Status Meaning
1 Power Solid orange Switch is unable to connect to the Meraki cloud
Flashing white Firmware upgrade in process
Solid white Switch is fully operational and connected to the Meraki cloud
Off Switch does not have power
2 Restore N/A
3 Switch Ports Off No link is detected on this port
Flashing orange (RJ45
ports only)
Solid green 1 Gbps link detected
In addition, there is a RESTORE button available on the front panel.
Insert a paper clip if a device restore is required.
• A brief, momentary press: To delete a downloaded configuration and reboot.
• Press and hold for more than 10 sec: To force the unit into a full factory restore.
Restore button to clear switch IP and local configuration
settings
Activity indicator
MS120-8FP Series back panel
2
Page 3
MS120-8/LP Series back panel
Additional functions on the back panel are described below, from left to right.
Power input Power cords may be ordered separately.
Equipment is to be used only in a restricted access location and installed/operated only by trained service
personnel.
Mounting hardware
MS120-8 models come with unique and easy-to-use integrated mounting slides for one-step mounting.
3
Page 4
Connecting to the Meraki Cloud
All Meraki MS devices must have a logical network connection and valid IP address. An IP address can be assigned
dynamically through a local DHCP server or statically through a local management interface. For details on getting
started, read the Quick Start.
4
Loading...