Cisco Systems F1DP116G, F1DP108G User Manual

Self Help Guide

®

®

Self Help Guide

IMPORTANT!

This Guide refers to the
following Products:

F1DP108G

KVM-Over-IP Mouse Synchronisation Guide

Please read the following carefully;

Synopsis:

This guide is designed to help you configure the
mouse settings to overcome the problems of
poorly synchronised local and remote mice via the
SMB Cat 5 KVM-Over-IP.

The guide is based on a remote session being
established from a Windows 2000 or XP machine.

F1DP116G

Requirements:

This guide assumes that you are an Administrator
or Owner of an SMB Cat 5 KVM-Over-IP (F1DP108G
or F1DP116G) and have access to the KVM and its
connected Hardware.

• SMB Cat 5 KVM-Over-IP Unit

• IEC Power Cord for KVM

• Minimum 1 Host Machine

• Minimum 1 Server Interface Module (SIM)

• Ethernet Cable (To connect KVM to LAN)

• LAN Client PC with remote access to KVM

TSG-UK-1-001 | www.belkin.com | Page 1 of 1

TSG-UK-2-002 | www.belkin.com | Page 1 of 4

Self Help Guide

®

®

Self Help Guide

KVM-Over-IP Mouse Synchronisation Guide | Step 1

First it is necessary to check the ‘Mouse Settings’ on the Servers connected to the KVM
to ensure that ‘Mouse Acceleration’ is adjusted to suit remote access. The ‘Mouse
Settings’ are accessed via ‘Control Panel’

Windows XP | 2003 Server | Vista

Set ‘Pointer Speed’ is set half-way and
ensure the checkbox for ‘Enhance Pointer
Precision’ is un-ticked.

Windows ME

Set ‘Pointer Speed’ to half-way and make
sure that acceleration is turned off.

Windows 98 | 98SE | NT

Check that the ‘Pointer Speed’ is set to its
slowest position and leave trails off.

Windows 2000

Set ‘Speed’ to slow and ensure that the
acceleration is set to ‘None’.

TSG-UK-1-001 | www.belkin.com | Page 1 of 1

TSG-UK-2-002 | www.belkin.com | Page 2 of 4