Page 1
Data Sheet
Cisco Video Surveillance 2800 Series Standard
Definition PTZ IP Camera
Product Overview
Cisco® Video Surveillance 2800 Series Standard Definition PTZ IP Cameras are feature-rich cameras designed for
superior performance, image quality, and ease of deployment. These cameras use a 1/4" SONY EX12E EXmor™
CCD Sensor that allows up to a 12x optical zoom while viewing and recording at D1 resolutions.
The cameras are equipped with an integrated camera optics assembly which offers 360° continuous pan ro tation,
a 220° tilt range, and 16 PTZ presets. In addition, the cameras support an SD/SDHC slot for local storage that can
be used to store video if network connectivity is lost.
Cisco Video Surveillance 2800 Series IP Cameras support two simultaneous video streams. The streams can be
compressed in MJPEG and H.264 formats across several resolution configurations, and can be configured in a
variety of frame rates and bit rates for additional bandwidth administration. The cameras feature a ¼ inch SONY
EXmor CCD Sensor for increased sensitivity and low light capability that allow the cameras to compensate in
scenes where minimal light is present. In addition, the cameras feature built-in motion detection and wide dynamic
range (WDR) that enables the system to compensate in scenes where dramatic contrasts in lighting are present.
For unparalleled simplicity of setup and monitoring, the cameras support the Cisco Medianet interface. When
connected to a Cisco switch that also supports Medianet, the switch recognizes the camera as a video endpoint
and then uses SmartPort macros to set the right network parameters for the video stream on the network. In
addition, the camera can be automatically discovered and configured when connected to Cisco Video Surveillance
Manager 7.0, thereby minimizing installation time and cost.
Cisco Video Surveillance 2800 Series Standard Definition PTZ IP Cameras offer a variety of benefits, including:
Full Range of Motion: The camera supports a continuous 360° pan rotation , 220° tilt angle range, and 12x optical
zoom. The camera operator can remotely control the camera to track subjects or reposition the camera’s field
of view.
Camera Presets: Operators can program up to 16 preset locations that the camera can automatically cycle
through while recording.
Wide Dynamic Range: The camera employs powerful digital imaging technology, allowing it to capture highquality images in a wide variety of lighting conditions. It uses a progressive scan image sensor with global
electronic shuttering to ensure natural color rendition, zero blooming and smear and minimal motion blurring.
Outdoor Ready: The housing for the camera is IP66 rated, allowing for outdoor mounting without an
additional enclosure.
Day/night operation: The camera provides true day/night functionality and includes an IR filter that automatically
switches to night mode in low-light scenes. This function can be set to manual, automatic, or scheduled control.
Open API: Support for ONVIF 2.0 allows for standards based interoperability and communications with other
ONVIF appliances.
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 1 of 5
Page 2
Flexible power options: The camera supports Power over Ethernet (PoE+) 802.3at, High PoE, or 24 VAC power
through an external power supply.
Simple Web Interface: The Cisco Video Surveillance 2800 Series supports Internet Explorer 8.0 for remote setup
and administration.
Privacy Masking: Privacy masking is used to conceal user-defined privacy areas that cannot be viewed by an
operator. The Cisco Video Surveillance 2800 Series supports up to four privacy masked regions. A masked area
will appear on the screen as a solid, or user defined colored window.
Product Specifications
Table 1 lists the product specifications for the Cisco Video Surveillance 2800 Series.
Table 1. Product Specifications
General
Available Languages English
Supported Protocols TCP/IP, UDP/IP (Unicast, Multicast IGMP), UPnP, DNS, DHCP, RTP, RTSP, NTP, IPv4, SNMP, QoS, HTTP,
Security Access Password-protected
Certifications/Ratings/Patents CE, Class A
Signal Format NTSC (CIVS-IPC-2830)
Scanning System Progressive
Image Sensor 1/4-inch CCD
Lens 3.7 to 44 mm
Zoom 12x optical
PTZ Speed Pan speed: 0.05° to 450°/sec
Horizontal
Angle of View
Minimum Illumination Color:
White Balance Automatic with manual override
Shutter Speed 1/4 sec to 1/10000 sec (20 steps) NTSC
Iris Control Automatic, with manual override
Gain Control Automatic/OFF
Wide Dynamic Range TBD
Motion Detection Integrated
HTTPS, LDAP (client), SSH, SSL, SMTP, FTP, mDNS (Bonjour)
FCC, Class A
UL/cUL Listed
C-Tick
PAL (CIVS-IPC-2835)
12x digital
Tilt speed: 0.05° to 450°/sec
56.3° (W) to 4.6° (T)
0.9 lux @1/60 sec (NTSC), 1/50 sec (PAL)
(F1.4, 50IRE)
0.05 lux @1/4 sec (NTSC), 1/3 sec (PAL)
B/W:
0.01 lux @ 1/4 sec (NTSC), 1/3 sec (PAL)
1/3 sec to 1/10000 sec (20 steps) PAL
Electronic
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 2 of 5
Page 3
Electrical
Ports RJ-45 connector for 100BASE-TX
Cabling Type Cat5 or better for 100BASE-TX
Input Power AC: 28W (-40 to 55’C)
PoE+: 18W (-5 to 55’C)
High PoE: 28W (-40 to 55’C)
Alarm Inputs 4
Auxiliary Outputs 2
Pan Movement 360° continuous pan rotation
Vertical Tilt 220° (+20° above horizon)
Audio
Streaming Bidirectional; full- or half-duplex
Input/Output Terminal connector
Compression G.711 A-Law, G.711 U-Law
Video
Video Encoding H.264 and MJPEG
Video Streaming
Resolution and Frame Rate
(H.264)
Resolution and Frame Rate
(MJPEG)
Weight 3.3 Kg
Operating Temperature AC 24V: -40 to 55°C
Outdoor Rating IP66 when installed properly
●
Single-stream H.264 or MJPEG up to 720 x 480 @ 30 fps (720 x 576 @ 25 fps)
●
Dual-stream H.264 and MJPEG
◦
Primary stream programmable up to720 x 480 @ 30 fps (720 x 576 @ 25 fps)
◦
Secondary stream programmable up to 720 x 480 @15 fps (720 x 576 @ 15 fps)
Refer to Table 2
Refer to Table 2
PoE+: -5 to 55°C
High PoE: -40 to 55°C
Table 2 lists the video stream support for the Cisco Video Surveillance 2800 Series for 4:3 aspect ratios.
Table 2. Video Stream Support for 4:3 Aspect Ratios
Primary (H.264) Maximum fps Secondary (H.264 or MJPEG) Maximum fps
720 x 480/576 30/25 720 x 480/576
704 x 480/576 30/25 704 x 480/576
352 x 240/288 30/25 352 x 240/288 15
Software
Table 3 describes the primary features of Cisco Video Surveillance 2800 Series IP Camera software.
Table 3. Primary Software Features
Item Specification
Activity Detection User-definable alerts with configurable sensitivities and thresholds, email alert, and HTTP notifications
Video Format NTSC and PAL
Image Settings White balance, automatic exposure, noise reduction, wide dynamic range, exposure compensation
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 3 of 5
15
352 x 240/288
15
352 x 240/288
Page 4
Item Specification
Overlay Capabilities Time, date, and text
Selectable Bit Rate Support for constant bit rate or variable bit rate
IP Filtering Ability for users to enter a list of allowed or blocked IP addresses for viewing video and configuring camera
Discovery Cisco Discovery Protocol and Bonjour Zero-Configuration discovery
Configuration
settings
●
Browser-based using Internet Explorer 8.0 or later
●
Two levels of user access with password protection
Figure 1 shows the dimensions of Cisco Video Surveillance 2800 Series IP Cameras. All dimensions are
in millimeters.
Figure 1. Cisco Video Surveillance 2800 Series IP Camera Dimensions
Warranty Information
Find warranty information on Cisco.com at the Product Warranties page.
Ordering Information
Availability
Cisco Video Surveillance IP Cameras are available through Cisco Advanced Technology Provider (ATP) program
partners. Table 4 lists part numbers for the Cisco Video Surveillance 2800 Series.
Table 4. Ordering Information
Product Name Part Number
Cisco Video Surveillance SD Outdoor IP PTZ Camera, NTSC CIVS-IPC-2830
Cisco Video Surveillance SD Outdoor IP PTZ Camera, PAL CIVS-IPC-2835
20cm Extension Pipe with Adapter CIVS-PA-EXT=
PTZ to 6KA Accessory Adapter CIVS-PA-PTZADPTR=
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 4 of 5
Page 5
Cisco Services
Cisco offers a wide range of services programs to accelerate customer success. These innovative programs are
delivered through a unique combination of people, processes, tools, and partners, resulting in high levels of
customer satisfaction. Cisco services help you to protect your network investment, optimize network operations,
and prepare your network for new applications to extend network intelligence and the power of your business. For
more information about Cisco Services, see Cisco Technical Support Services or Cisco Advanced Services.
For More Information
For more information about Cisco Video Surveillance IP Cameras, visit http://www.cisco.com/go/physec or contact
your local account representative.
Printed in USA C78-727789-01 12/13
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 5 of 5
Loading...