CHAMPION UL-130 Installation Instructions
Attention Installers
Undercounter Installation Instructions (High Temp.)
0512242 REV C
1
2
!
!
!
Location
All plumbing and electrical connections must be made by qualified installers in accordance
with all local plumbing and electrical codes.
Plumbing connections must be made BEFORE power is connected to the dishwasher.
Damage to the water heaters will result if power is turned on without adequate water supply.
All plumbing and electrical connections must be positioned to allow the unit to be removable
for service and cleaning.
Place dishwasher in permanant location
Level dishwasher with 4 leveling feet
Level side to side and front to back
Remove front Panel
Hot Water Supply Hot Water Connection
Min. 140°F (60°C) for 40° rise
@ 20 PSI (138kPa) min. flow pressure
Min. 110°F (43°C) for 70° rise
@ 20 PSI (138kPa) min. flow pressure
Min 1/2” water supply line
6 ft. fill hose supplied
3/4” garden hose fitting
3
4
5
Drain Connection
1-1/2” Wye fitting
* Maximum drain height: 3 ft.
Electrical Connections
Check data
plate for
electrical
power
requirements
Fill Booster Tank
ON
OFF
Booster Fill
3/4” MNPT
by 5/8” hose adaptor
Remove front panel
Remove connection
box cover
4 ft. clear braided
drain hose supplied
L1
L2
115V
Neutral
Single Phase
208-240/60/1
115V split connection
3 wire plus ground
wire rated min 190°F (88°C)
Booster Service Switch is located on the left side of
chemical pump bracket
Push Service Switch to “Booster Fill” position and
hold until water enters wash tank
Push Service Swtich to the “On” position.
Replace front panel. Installation is complete!
208/
240V
115V
L1
L2
L3
N
1
2
3
N
G
Attention Installers
Undercounter Installation Instructions (Low Temp.)
0512242 REV C
1
2
!
!
!
Location
All plumbing and electrical connections must be made by qualified installers in accordance
with all local plumbing and electrical codes.
Plumbing connections must be made BEFORE power is connected to the dishwasher.
Damage to the water heaters will result if power is turned on without adequate water supply.
All plumbing and electrical connections must be positioned to allow the unit to be removable
for service and cleaning.
Place dishwasher in permanant location
Level dishwasher with 4 leveling feet
Level side to side and front to back
Remove front Panel
Hot Water Supply Hot Water Connection
Min. 140°F (60°C)
@ 20 PSI (138kPa) min. flow pressure
Min 1/2” water supply line
6 ft. fill hose supplied
3/4” garden hose fitting
Drain Connection
3
* Maximum drain height: 3 ft.
Electrical Connections
4
1-1/2” Wye fitting
4 ft. clear braided
drain hose supplied
5/8” adapter
Check data
plate for
electrical
power
requirements
4 ft. standard power cord supplied.
Connect to 15 amp/120 volt receptacle.
Installation is complete!
Loading...