Page 1
The Dishwashing Machine Specialists
Technical Manual
Undercounter
Dishwasher
Model
TUW-15
August, 1992
P.O. Box 4149
Winston-Salem, North Carolina 27115-4149
Champion Industries, Inc.
Manual P/N 111482
Champion
Fax: 336/661-1660336/661-1556
Machine Serial No.
Page 2
WARRANTY
LIMITED WARRANTY
Champion Industries Inc. (herein referred to as Champion), P.O. Box 4149, Winston-Salem, North Carolina 27115,
and P.O. Box 301, 2674 N. Service Road, Jordan Station, Canada L0R 1S0, warrants machines, and parts, as set out
below.
Warranty of Machines: Champion warrants all new machines of its manufacture bearing the name
“Champion” and installed within the United States and Canada to be free from defects in material and
workmanship for a period of one (1) year after the date of installation or fifteen (15) months after the date of
shipment by Champion, whichever occurs first. [See below for special provisions relating to glasswashers.] The
warranty registration card must be returned to Champion within ten (10) days after installation. If warranty card
is not returned to Champion within such period, the warranty will expire after one year from the date of
shipment.
Champion will not assume any responsibility for extra costs for installation in any area where there are
jurisdictional problems with local trades or unions.
If a defect in workmanship or material is found to exist within the warranty period, Champion, at its election,
will either repair or replace the defective machine or accept return of the machine for full credit; provided, however, as to glasswashers, Champion’s obligation with respect to labor associated with any repairs shall end
(a) 120 days after shipment, or (b) 90 days after installation, whichever occurs first. In the event that Champion
elects to repair, the labor and work to be performed in connection with the warranty shall be done during regular
working hours by a Champion authorized service technician. Defective parts become the property of Champion.
Use of replacement parts not authorized by Champion will relieve Champion of all further liability in connection
with its warranty. In no event will Champion’s warranty obligation exceed Champion’s charge for the machine.
The following are not covered by Champion’s warranty:
a. Lighting of gas pilots or burners.
b. Cleaning of gas lines.
c. Replacement of fuses or resetting of overload breakers.
d. Adjustment of thermostats.
e. Adjustment of clutches.
f. Opening or closing of utility supply valves or switching of electrical supply current.
g. Cleaning of valves, strainers, screens, nozzles, or spray pipes.
h. Performance of regular maintenance and cleaning as outlined in operator’s guide.
i. Damages resulting from water conditions, accidents, alterations, improper use, abuse,
tampering, improper installation, or failure to follow maintenance and operation procedures.
j. Wear on Pulper cutter blocks, pulse vanes, and auger brush.
Examples of the defects not covered by warranty include, but are not limited to: (1) Damage to the exterior or
interior finish as a result of the above, (2) Use with utility service other than that designated on the rating plate,
(3) Improper connection to utility service, (4) Inadequate or excessive water pressure, (5) Corrosion from
chemicals dispensed in excess of recommended concentrations, (6) Failure of electrical components due to
connection of chemical dispensing equipment installed by others, (7) Leaks or damage resulting from such
leaks caused by the installer, including those at machine table connections or by connection of chemical
dispensing equipment installed by others, (8) Failure to comply with local building codes, (9) Damage caused by
labor dispute.
Warranty of Parts: Champion warrants all new machine parts produced or authorized by Champion to be free
from defects in material and workmanship for a period of 90 days from date of invoice. If any defect in
material and workmanship is found to exist within the warranty period Champion will replace the defective
part without charge.
DISCLAIMER OF WARRANTIES AND LIMITATIONS OF LIABILITY. CHAMPION’S WARRANTY
IS ONLY TO THE EXTENT REFLECTED ABOVE. CHAMPION MAKES NO OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED, TO ANY WARRANTY OF
MERCHANTABILITY, OR FITNESS OF PURPOSE. CHAMPION SHALL NOT BE LIABLE FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES. THE REMEDIES SET OUT ABOVE ARE
THE EXCLUSIVE REMEDIES FOR ANY DEFECTS FOUND TO EXIST IN CHAMPION DISHWASHING
MACHINES AND CHAMPION PARTS, AND ALL OTHER REMEDIES ARE EXCLUDED,
INCLUDING ANY LIABILITY FOR INCIDENTALS OR CONSEQUENTIAL DAMAGES.
Champion does not authorize any other person, including persons who deal in Champion dishwashing
Page 3
TANK
PART NUMBER ITEM NO. DESCRIPTION QTY/PER
0708105 1 TANK ASSEMBLY WELDED 1
0503717 2 DOOR SIDE GASKET 19" LONG 2
0501882 3 DOOR TOP GASKET 20-5/8" LONG 1
0503727 NS DOOR SWITCH HARNESS 1
0300132 5 DOOR SWITCH INSULATION 2
0501382 6 DOOR SWITCH 1
0300074 7 NUT PLATE 1
0300073 8 SWITCH PLATE 1
0705487 9 RH & LH SCREEN FRAME ASSEMBLY 2
0700079 10 LH TRAY SLIDE ASSEMBLY 1
0700080 NS RH TRAY SLIDE ASSEMBLY 1
0700311 12 VENT COVER ASSEMBLY 2
0704892 13 MOTOR GUARD SCREEN 1
0703373 14 SPRING CLIP ASSEMBLY 1
0700006 15 OVERFLOW COVER 1
0501836 16 HEATER “O” RING 1
0504601 17 HEATER 1200 W, 240V 500HT/UT 1
0501650 18 THERMOSTAT REDUCER 1
0501881 19 WASH PUMP GASKET 1
0501896 20 THERMOMETER SEAL 1
0305097 21 HEATER BOX 1
0300061 22 HEATER COVER 1
0504602 23 THERMOMETER 2" DIAL, 12" STEM 1
0503574 NS STRAIN RELIEF BUSHING, SMALL 1
0301684 25 BOTTOM SPRAYARM LOCK NUT 1
0705486 LOWER SPRAYARM ASSEMBLY 1
0705049 26 BOTTOM SPRAYARM 1
0501563 27 #8 x 3/8" TH SLOT TYPE “A” 2
0505044 28 BOTTOM SPRAYARM SUPPORT 1
0707602 29 SCREEN SUPPORT ASSEMBLY 1
0504910 30 VERTICAL PUMP AND MOTOR ASSY, 115 V, 60 HZ 1
0305495 31 CONNECTION TUBE 1
0503679 32 7/16 SS GEAR-TYPE HOSE CLAMP 2
0306618 33 DRAIN VALVE, REWORKED 1
0705041 34 TOP MANIFOLD ASSEMBLY 1
0305051 35 MANIFOLD CLIP 2
REPLACEMENT PARTS
21
Loading...