Project
Item No.
Quantity
PP3 TASKMASTER
STANDARD FEATURES
• Type 304 polished stainless steel construction
• 14 gauge stainless tanks and drain boards
• 10" high x 3-1/4" deep back splash
• Twist handle drains
• Taskmaster Control System
Single Cycle Microprocessor Control
Integrated low water detection
Plug and play service system
• Stainless steel legs and cross rails
• Stainless steel adjustable bullet feet
• Dual stainless steel pump and impeller
• Self-draining pump systems
• Stainless steel front skirting
• Multi-sided discharge
• Removable discharge plates
• Centrifugal pump with 4" diameter intake
and 3" diameter outlet
• Two - 1-1/2 HP fully enclosed (TEFC) wash pump motors
with permanently sealed bearings
• Inherent motor overload protection,
manual reset
• Low water protection for wash pump motor
• 2,500 watt wash tank heater
• 1 year labor, 3 years parts on pumps and control panel
SPECIFIER STATEMENT
Specified unit will be Champion model PP-3 Taskmaster
Power Wash Sink System.
Features (2) 1-1/2 TEFC Hp wash pump motors, taskmaster
control system, dual stainless steel pump and impeller and
self draining pump systems.
Champion Industries, Inc.
P. O. Box 4149, Winston-Salem, NC 27115
Tel: 336/661-1556 Fax: 336/661-1979
2674 N. Service Road,
Jordan Station, Ontario, Canada L0R 1S0
Tel: 905/562-4195 Fax: 905/562-4618
www.championindustries.com
(1M) 8/09 Printed in U.S.A.
CH004
PP3
Taskmaster
Power Wash Sink System
NEW!
OPTIONS & ACCESSORIES
480/60/3 electrical
Utensil basket
Removable wash tank cover
Sheet pan rack
5,000 watt wash tank heater
Sanitize tank heat
Pot and pan rack
Table mounted over shelf
Stainless steel under shelving
1/2" pre-rinse faucet
1/2" fill faucet
Multi-Taskmaster
• Variable speed
• Temperature control
• Programmable wash cycle
• Integrated soap dispensing
Auto Fill
Auto Drain
Direction from soiled to clean end (select one)
Left to right
Right to left
PP3
18"
37"
12"
44"
10"
8"
3"
132"
18"x28"x18"
Sanitize Tank
36"
12"x28"x3" Scrap Sink
w/Perforated Basket
42"x28"x18"
Wash Tank
PLAN VIEW
18"x28"x18"
Rinse Tank
18-3/4"
18-3/4"
10"
R5/8"
3-1/4"
1"
Splash Detail
3-1/4"
3"
R5/8"
Rolled Edge Detail
Scale: 3/4" = 1'
Scale: 3/4" = 1'
1-1/2"
10"
R5/8"
3-1/4"
1"
Splash Detail
3-1/4"
3"
R5/8"
Rolled Edge Detail
Scale: 3/4" = 1'
Scale: 3/4" = 1'
1-1/2"
132"
36"
18-3/4"
18-3/4"
10"
R5/8"
3-1/4"
1"
3-1/4"
10"
R5/8"
3-1/4"
1"
Splash Detail
3-1/4"
3"
R5/8"
Rolled Edge Detail
Scale: 3/4" = 1'
1-1/2"
Taskmaster
Power Wash Sink System
(Consult the factory for custom lengths & widths)
PP3 TASKMASTER
A B C D E F G H
Edge
Type
M 1-1/2"
Rolled
M 3-1/4"
Splash
Drain Board
M 12"
M 18"
M 20"
M 24"
M 36"
M 42"
M 48"
M 54"
M 60"
M Custom___
Scrap Sink
M 20"
M 24"
M 36"
Custom___
M w/Scrap
M Basket
w/
Disposer
M Collar
Plan View
Wash Tank
M 36"
M 42"
M 48"
M 54"
M 60"
M Custom___
Options
M Rolling Lid
M Utensil Basket
M Sheet Pan Rack
Rinse Sink
M Omit
M 20"
M 24"
M 36"
M Custom___
Sanitizer
Sink
M Omit
M 20"
M 24"
M 36"
M Custom___
Options
M w/Heater
Dimensions shown in inches
Drain Board
M Omit
M 12"
M 18"
M 20"
M 24"
M 36"
M 42"
M 48"
M 54"
M 60"
M Custom___
Edge Type
M 1-1/2"
Rolled
M 3-1/4"
Splash
8"
Splash mount
fill faucet
Drain A
Front View
Drain A
Drain A
Splash mount
fill faucet
Single point electrical connection
made inside this control box
8" 8"
Splash mount
pre-rinse faucet
Warning: Plumbing and electrical connection should be made by qualified personnel who will
observe all the applicable plumbing, sanitation, and safety codes and the National Electrical Code.
PP-3 with 2.5 kW Electric Heat
Supply Ckt. Overcurrent
Elec. Rated Conductor Protective
Specs. Amps Ampacity Device
208-240/60/3 25 30 30
480/60/3 12 20 20
PP-3 without Electric Heat
Supply Ckt. Overcurrent
Elec. Rated Conductor Protective
Specs. Amps Ampacity Device
208-240/60/3 13 15 15
480/60/3 7 15 15
Minimum Maximum
Minimum Maximum
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
Champion Industries, Inc., P. O. Box 4149, Winston-Salem, NC 27115 • 336/661-1556 • Fax: 336/661-1979 • www.championindustries.com
Moyer Diebel, 2674 North Service Rd., Jordan Station, Ontario, Canada L0R 1S0
Utilities
1 Electrical (see box)
2 Hot Water
1/2" NPT connection for mixing faucet.
1/2" NPT connection for pre-rinse sprayer.
3 Cold Water
1/2" NPT connection for mixing faucet.
1/2" NPT connection for pre-rinse sprayer.
4 Drain
A. Sink drains, 2" NPT
B. Scrapper drain, 1-1/2" NPT
(25-5/8" AFF)
•
Tel: 905/562-4195
10"
44"
•
Side View
SPECIFICATIONS
Motor
Power Requirements
208-240/60/1; 208-240/60/3
Direction of Operation
Fax: 905/562-4618
3"
18"
37
12"
8"
1-1/2"
R5/8"
Rolled Edge Detail
Scale: 3/4" = 1'
Detail Views
2 x 1-1/2 Hp
www.moyerdiebellimited.com
•
3"
R-L or L-R