Champion EEUCCW-6 User Manual

Page 1
Project Item No. Quantity
EEUCCW6 SERIES UPRIGHT CONVEYORS
STANDARD FEATURES
Multi speed – 3 modes of operation to maximize savings
• All-purpose 29"-wide peg belt
• Dish capacities up to 16,135 dishes per hour (NSF Listed)
• Automatic tank fill
• Chemical dispensing equipment connection provisions
• Choice of tank heat: electric, steam coils or direct steam injectors
• Common hot water connection
• Common drain connection
• Common electric connection (separate connection required for optional electric booster and blower-dryer)
• One piece stainless steel wash/rinse manifold system, easy to remove
• Door safety switch
• Electric eye energy sentinel (idle pump shut-off)
• Easy-to-reach top-mounted controls
• Heavy-gauge stainless construction
• Low-water tank heat protection
• Push-button start-stop station – load end
• Recirculating flushing nozzles – load end with prewash
• Rinse saver device
• Conveyor shut-off shelf – unload end
• Stainless steel enclosure panels – front & ends
• Vent fan control connection provided
OPTIONAL WORLD CLASS FEATURES
Heat Recovery - redirects lost steam to heat using less energy
EEUCCW6
Upright 29" Conveyor
Dishwashing Machine
Water
Consumption
as low as
76 GPH
SPECIFIER STATEMENT
Specified unit will be Champion model EEUCCW6 upright 29" conveyor water saver dishwashing machine.
Features automatic tank fill, chemical dispensing connection provisions, common water, drain and electrical connections, door safety switch, low water tank heat protection, rinse saver.
1 year parts and labor warranty.
2674 N. Service Road, Jordan Station, Ontario, Canada L0R 1S0 Tel: 905-562-4195 Fax: 905/562-4618
(1M) 12/10 Printed in U.S.A
CH107
Champion Industries, Inc.
3765 Champion Blvd., Winston-Salem, NC 27105
Tel: 336/661-1556 Fax: 336/661-1979
www.championindustries.com
Page 2
EEUCCW6
Upright 29" Conveyor Dishwashing Machine
MODULAR SECTIONS: Right to Left Operation
Dimensions shown in inches and [millimeters]
EEUCCW6
18-5/8"
[473]
39" [991]
CL
2
1/2 HP
36" [914]
4'
[1219]
12" [305]
"B"
Unload
7" [178]
5'-8"
2'-6"
[762]
PrewashQuad
[1727]
"A"
Load
[102]
1
HP
4"
4A
7" [178]
4B
Overall Length "C"
2'
[610]
4"
[102]
4B
Rinse
0.2
HP
3'
[914]
Power
Rinse
3
HP
11'-4" CL-CL
6' [1829]
Wash/Rinse
[3454]
3
HP
31-1/2"
[800]
Minimum For Screen Removal
3'
[914]
5-1/2"
1
[140]
Wash
2'-1" [635]
1'-10"
[559]
1
4A
3
6" [152]
CL
29" Clear
[737]
6-1/4" [159]
19" [483] Clear
38"
[965]
3
37-1/4"
[946]
12" [305] Plumbing Clearance
100" [2540]
Door
Removal
95" [2413] Doors Up
62" [1575]
Machine
Height
Plumbing Clearance
10-1/2"
[266]
2
1-5/8"
[41]
Start/Stop
TABLE A - Machine Connection
Machine Only - Electric Heat
Minimum
Overcurrent
Protective
Device
Elec.
Specs.
Rated Amps
Minimum
Supply Ckt.
Conductor
Ampacity
208/60/3 183 250 250
240/60/3 158 200 200
480/60/3 80 100 100
Machine-steam
Minimum
Overcurrent
Protective
Device
Elec.
Specs.
Rated Amps
Minimum
Supply Ckt.
Conductor
Ampacity
208/60/3 29 40 40
240/60/3 26 35 35
480/60/3 14 20 20
Notes:
Load Section (A) Standard 5',
contains 30" Prewash
Prewash also available in a
48" HD section
Non-standard load section
available in 12" increments
Minimum load length 5'
(includes 30" prewash)
Unload Section (B) Standard
TABLE B - Booster Connection
40°F/22°C Rise – 15 kW Electric built-in booster
Minimum
Overcurrent
Protective
Device
Elec.
Specs.
Rated Amps
Minimum
Supply Ckt.
Conductor
Ampacity
208/60/3 42 60 60
240/60/3 36 45 45
480/60/3 18 25 25
70°F/39°C Rise – 25 kW Electric built-in booster
Minimum
Overcurrent
Protective
Device
Elec.
Specs.
Rated Amps
Minimum
Supply Ckt.
Conductor
Ampacity
208/60/3 70 90 90
240/60/3 60 80 80
480/60/3 30 40 40
Contact Factory for additional voltages.
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
Champion Industries, Inc., 3765 Champion Blvd., Winston-Salem, NC 27105 • 336/661-1556 • Fax: 336/661-1979 • www.championindustries.com
2674 N. Service Road, Jordan Station, Ontario, Canada L0R 1S0 • 905/562-4195 • Fax: 905/562-4618
5 ft contains 24" Aux.
Rinse and 36" belt, available
in 12" increments
Built in electric booster requires
a 5' minimum unload
Built in steam booster requires
a minimum 6' unload
Blow dryer section adds 4' to
overall length of machine
Page 3
Shipping weight crated: 150 lbs./ft. [68kg./m.] Height with doors up: 95" Height to remove doors: 100"
SPECIFICATIONS
Eco
Extended
Capacities
Dishes per hr. (NSF rated) 10,756 10,756 16,135 Conveyor speed (ft./min.) 6.8 6.8 10.2
Clean
Clean
Water consumption
Gal. per hr. (max. use) 76 132 132
Motor horsepower
Drive 1/2 Hp Prewash 30" [762] 1 Hp Prewash 48" [1219] 3 Hp Wash 3 Hp Power Rinse 3 Hp
Auxiliary Rinse 1/5 Hp
Temperatures °F
Wash (min.) 150 Power Rinse (min.) 160 Auxiliary Rinse (min.) 165 Final rinse (min.) 180
Heating
Tank heat Steam Electric
Wash tank 125 lbs./hr. 25 kW Rinse tank 100 lbs./hr. 20 kW Auxiliary rinse 50 lbs./hr. 10 kW
Electric booster 15
(kW required for 40°F rise)
Electric booster 25
(kW required for 70°F rise)
Steam booster 75
(lbs./hr. required for 40°F rise)
Steam booster 125
(lbs./hr. required for 70°F rise)
Venting
Minimum CFM, load end 300 Minimum CFM, unload end 800
Express
Clean
EEUCCW6
Upright 29" Conveyor
Dishwashing Machine
Utilities EEUCCW6
1
Electrical Connection
Contact factory for specific machine electrical requirements NOTE: Electric booster connection – contact Factory
2
Hot Water
3/4" NPT 180°F hot water connection. (For machine without built-in booster)
3
Drain
2" NPT connection, 62 gpm max
4
Vents
A Load end: 300 CFM 1/4" S.P. B Unload end: 800 CFM 1/4" S.P. With blower-dryer,
increase room ventilation by 600 CFM.
Note Water heater sizing is based on express clean water usage
Booster connections may vary. Contact the Factory.
Standard Voltages (Specify choice): 208/60/3, 240/60/3, and 480/60/3.
Available in 3-phase only. For non-standard 3-phase voltages, contact the Factory.
Plumbing Notes Because of the variation in house-supplied water
pressure, a water pressure regulating valve (PRV) is needed (water PRV is standard). Steam PRV’s may be required for pressure higher than 30 psi. The PRVs can either be purchased from Champion or obtained locally.
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
Champion Industries, Inc., 3765 Champion Blvd., Winston-Salem, NC 27105 • 336/661-1556 • Fax: 336/661-1979 • www.championindustries.com
2674 N. Service Road, Jordan Station, Ontario, Canada L0R 1S0 • 905/562-4195 • Fax: 905/562-4618
Warning Plumbing and electrical connections should be made by
qualified personnel who will observe all the applicable plumbing, sanitary, safety codes and the National Electrical Code.
Note Water Hammer Arrestor (meeting ASSE-1010 standard or
equivalent) to be supplied (by others) in common water supply line at service connection.
Venting Notes
Fabricated duct size: 3-7/8" x 23-7/8" (outside dimensions)
Page 4
EEUCCW6
Upright 29" Conveyor Dishwashing Machine
OPTIONS & ACCESSORIES
□ Tank heat; choices of electric, steam coil or
steam injectors
□ Booster Heaters – stainless steel (completely
inter-plumbed, controls are inter-wired)
□ Electric: (40°F rise or 70°F rise)
□ Steam: (40°F or 70°F rise)
EEUCCW6 UPRIGHT CONVEYOR
□ 48" Blower Dryer, electric or steam (add 4' to
overall length)
□ Belts: standard peg belt, flat belt, thermal tray
belt, silverware belt, belts with upper cross rods, and other select combination belts
□ Start/Stop station, unload end
□ Back panels, stainless steel
□ Conveyor, variable speed, electric
□ Cold water thermostat (for pre-wash)
□ External scrap bucket on 48" pre-wash
(standard on 30" pre-wash)
□ External scrap bucket on wash tank
□ Insulated hoods, lower panels
□ Motor pumps, 2 or 3 Hp optional in lieu of
1 Hp on pre-wash
□ Bumper rail, machine mounted
□ Steam pressure regulating valve (unmounted)
□ Drain water tempering kit (mounted)
□ Horizontal split door (insulated)
□ Hinged doors (insulated)
□ Shock arrestor (water)
□ Drain interlocks
□ Unmounted fused disconnect switch for
machine and/or booster
□ Heat Recovery Unit redirects lost steam to
heat using less energy
Heat Recovery –
Redirects lost steam to heat using less energy.
(available on EUCCW6,
EUCCW8 and EUCCW4 only)
Water leaves
booster at
180°F+
and travels to
nal rinse arms
Heated 110°F water travels back to booster
Booster
60°F incoming water
to machine.
Multi-Speed –
3 modes of operations to maximize savings
• Eco Clean – lowest water usage in the industry
• Extended Clean – for heavily soiled items
• Express Clean – highest production in the industry
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
Champion Industries, Inc., 3765 Champion Blvd., Winston-Salem, NC 27105 • 336/661-1556 • Fax: 336/661-1979 • www.championindustries.com
‘USGBC’ and related logo is a trademark owned by the U.S. Green Building Council and is used by permission.
2674 N. Service Road, Jordan Station, Ontario, Canada L0R 1S0 • 905/562-4195 • Fax: 905/562-4618
Loading...