Chamberlain TX4UNIS, CB11 User Manual

How to program a new TX4UNIS remote into Chamberlain Liftmaster CB11 swing gate
control board which uses the 433Mhz radio frequency module.

1. Take the new TX4UNIS remote and slide the cover down to expose the four button. Press

and hold the left and right hand buttons together and the white LED is flashing. Keep holding
until the LED stays on constant and then let go. Now press the top button on the remote once
and the LED flashes. Press the top button a second time and the LED flashes again. Now
press the bottom button once and the LED goes out.

2. Locate the orange Learn button CH1 on the CB11 logic board. Press the CH1 button once and

the red LED comes on.

3. Press & hold the top button on the remote control, for 3 seconds, and the LEDs light will

flash. Now let go of the remote control button, LEDs will goes out and then back on again, and
the remote is ready to use.

To delete all remote control codes. Press & hold the CH1 button until the red LED goes out, then let
go. (Approximately 25 seconds).