MC100AML |
Battery: |
|
|
|
CR2032 |
ORDERING OPTIONS
G
Art.
MC100AML
SPECIFICATIONS
Chamberlain
Frequency - Multiple
Buttons - 2
COMPATIBLE WITH
CG842 CG844 CM842 CM844 84335
E950C 94335 E950M C945 E945M
C940 E940M E943M CM128 062730
70241 70241-O 70241-P 62733 062730
70241 70241-O 70241-P 62733 4335EBD
COMPATIBLE WITH (EXTENDED)
84330 |
C940 |
C943 |
E940C |
E943M |
4330EBD |
CAD603 |
062170 |
SL4BRM SLEUROTX |
PTX4 |
PTX4-P |
PTX4v1 |
TX2 |
HC101 |
HC107 |
HC106 |
HE433 |
HC105 |
HC108 |
HC104 |
HC102 |
|
|
|
Remote Programming Steps
ON NEXT PAGE
Remote Programming Steps
Program New Remotes to Receiver
1.Start with your garage door closed. Ensure that the door is clear of all obstructions.
2.Press and hold the bottom button on the remote control until the blue LED on the remote stays solid (approximately 15 seconds), then release the button.
3.Press and hold the LEARN button on your garage door opener for 2-3 seconds before releasing it
4.On the remote control, press and release the remote button you would like to program. The blue LED will blink for up to 60 seconds. Once the LED changes to solid blue, press & release the button on the remote that you are programming.
5.The remote will begin flashing once every three seconds. Once the door begins moving press the remote button again. Your remote is now programmed to the garage door opener.
6.Repeat process for additional remotes if necessary
Program New Remotes to ATA Receiver
1.Start with your garage door closed. Ensure that the door is clear of all obstructions.
2.Press and hold the bottom button on the remote control until the blue LED on the remote stays solid (approximately 15 seconds), then release the button.
3.Press and hold the CODE SET button on the opener until the completion of the next step
4.On the remote, press and release the remote button that you would like to program. The blue LED on the remote will blink for up to 60 seconds. Once the remote LED changes to solid blue, release CODE SET button on the opener and press & release the remote button you are programming.
5.The remote will begin flashing once every three seconds. Once the door begins moving press the remote button again. Your remote is now programmed to the garage door.
6.Repeat process for additional remotes if necessary
Whilst every effort has been made to ensure the accuracy of the information supplied herein, we assume no liability for any errors or omissions. Information contained in this document is subject to change without prior notice.