CENTRAL BRASS 1555 Installation Manual

Multi-Tub Trip Lever Bath Drain adjustable for 14 to 16-inch Tubs

1555 Series Light Pattern Cast Brass Tee and Top Ell
1655 Series Heavy Pattern Cast Brass Tee and Top Ell
1665 Series Heavy Pattern Cast Brass Tee, Top Ell and Plug Body

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

031303 I-1655

www.CentralBrass.com

INSTALLATION INSTRUCTIONS

FOR TRIP LEVER BATH DRAINS

1. Apply a layer of sof t putty (plumbers set), to underside of strainer plug body, assemble in

bathtub drain hole and screw tightly into shoe elbow as shown.

2. Assemble tubes with slip joint washers into tee as shown and screw on coupling nuts finger

tight. Rotate rubber beveled washer on top ell to match angle of tub.

3. With the trip handle in the down position, insert the plunger and linkage down through the top
elbow as shown. Linkage can be screwed in and out of clevis to obtain the desired lift of
plunger. When proper lif t is adjusted tighten locknut and screw in the two screws to hold
face plate secure.

4. Tighten coupling nuts on tee with wrench to pull t apered slip joint washers securely into tee.

5. Assembly of a threaded t ailpiece requires the use of a thread sealant to prevent leakage.

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

031303 I-1655

www.CentralBrass.com