C. Crane TR1 User Manual

ADVANTAGE
OWNER’S MANUAL
AM Advantage Indoor Antenna
ADVANTAGE
Making Connections With Your New AM Advantage
Intended for AM use ONLY. Most receivers and radios have external AM antenna terminals. If your receiver or radio does NOT have these terminals, you cannot connect the antenna and it must be used in Wireless Operation (see Wireless Operation on the following page).
AM Advantage Hook-Up & Tuning:
Your new AM Advantage can improve your AM reception dramatically!
1. Connect the supplied wire’s jack into the port located on the back of the antenna. See Figure 1.
2. Locate the set of terminals for an external AM antenna on the back of your radio or receiver. (These terminals can be either two screws or two push-buttons.)
3. Simply insert the exposed wire leads into the terminals. See Figure 2.
4. Tune in the AM station you wish to listen to on your radio.
5. Turn the dial on the AM Advantage to approximately the same frequency. Improved reception performance should be noted. See Figure 3.
1
Loading...
+ 4 hidden pages