Casio DQR-300U User Manual

MA0402-EB

Operation Guide DQR-300U

Main unit

Sub-unit

1

CASIO

F

C

D

SELECT

RESET

°C/ °F

°C/ °F

TEST

SELECT

RESET

TEST

E

RESET

TEMP.

MAX/MIN

CLEAR

DOWN(—)

WAVE

°C/ °F

7
9

4
0
6

°C/ °F

SELECT

RESET

TEST

°C/ °F

SELECT

RESET

TEST

HUMIDITY

8

S

N

Z

O

N

OFF

5

SNZ
O

N

A

L

M

O

FF

AL

M

HUMIDITY
MAX/MIN

RE-SYNC

SELECT

TEMP.

MAX/MIN

CLEAR

SET

UP(+)

DOWN(—)

WAVE

°C/ °F

RESET

MAX/MIN

SET

3

UP(+)

2

RE-SYNC

A

SELECT

B

¡

™

¡

™

1

Operation Guide DQR-300U

• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the
clock.

• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.

Alarm Off Alarm On

Current time
(Hour, minutes, seconds)

PM indicator

DATE (month - date)

Current Temperature

• In locations subject to radio frequency interference, the product may malfunction and require you to reset the
product.

Day of the week

Wave OK indicator
Antenna Icon

Current Humidity

Upcomimg weather
indicator

Alarm time

Snooze on indicator

Alarm on
indicator

GENERAL GUIDE

Main unit

1 SNOOZE/LIGHT button

• Press this button to illuminate the display for about four seconds.

• Pressing this button while the alarm is sounding stops the alarm.

2 Alarm Time Set buttons

Use these buttons to change the alarm time or current time setting.

3 SET button

Use this button when setting the current time.

4 WAVE button

Press this button to receive the time calibration signal and adjust timekeeping.

5 Alarm Mode selector

SNZ: Snooze alarm on
ON: Alarm on
OFF: Alarm off

6 RESET button

Press this button to reset the clock after replacing its batteries.

7 MAX/MIN TEMP. button

Press this button to display the high and low temperature values.

8 MAX/MIN HUMIDITY button

Press this button to display the high and low humidity values.

9 CLEAR button

Press this button to clear the currently displayed high/low temperature or humidity.

0 °C/ °F button

Press this button to toggle the temperature units between Celsius and Fahrenheit.

A RE-SYNC button

Press this button to re-synchronize the timing of the main unit and the sub-unit.

B SELECT button

Press this button to toggle the display between main unit (INDOOR) and sub-unit (OUTDOOR) data.

Sub-unit

C SELECT button

Press this button to toggle the display between the current temperature and humidity.

D RESET button

Press this button to reset the sub-unit after replacing its batteries.

E TEST button

This button is for testing the unit. Normally, you should not press it. If you do, be sure to press the RESET
button (D) next.

F °C/ °F button

Press this button to toggle the temperature units between Celsius and Fahrenheit.

2