MA1102-EA
Operation Guide 5228
••Your watch may differ somewhat from the one shown in the illustration.
Notes
••Some water resistant models are equipped with a screw lock crown.
••With such models, you must unscrew the crown in the direction noted in the illustration
to loosen it before you can pull it out. Do not pull too forcibly on such crowns.
••Also note that such watches are not water resistant while their crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting.
Crown (Normal position)
Click 1
(Day setting)
Click 2
(Time and day of week setting)
Day
Day of the week
To set the day
111Pull the crown out to Click 1. 222Rotate the crown to set the day.
Avoid changing the day setting between 9:00 p.m. and 1:00 a.m. (If you do, the day indication may not change at midnight).
333Push the crown back in to the normal position.
To set the day of the week and time
111Pull the crown out to Click 2 when the second hand is at 12 o’clock. The second hand will stop.
222Set the hands by rotating the crown. As you do, the day of the week changes accordingly.
333After setting the day of the week, rotate the crown to set the time. Make sure to distinguish between AM and PM.
444On a time signal, push the crown back in to the normal position.
■■For watch with the elapsed time bezel |
|
Rotate the elapsed time bezel to align the |
|
mark with the minute hand. |
|
After certain amount of time elapsed, read the |
|
graduation on the elapsed time bezel which the |
|
minute hand points to. |
|
The elapsed time is indicated. |
Elapsed time bezel |
Module No. |
Accuracy at normal |
Battery type |
Battery life |
|
temperature |
||||
|
|
|
||
|
|
|
||
5228 |
±20 seconds per month SR916SW |
Approx. 3 years |
1