Carnes RKRBV User Manual

Imperial [IP] Dimensions

Metric (SI) in Parentheses

SPECIFICATION SHEET

MODELS RLRB, RMRB, RKRB

STAINLESS STEEL

0° FIXED DEFLECTION RETURN GRILLES & REGISTERS

CARNES COMPANY 448 S. Main St., P. O. Box 930040, Verona, WI 53593-0040 Phone: (608)845-6411 Fax: (608)845-6470 www.carnes.com

SUPERSEDES 14144 14144-A

Notes:

1. Standard screws are #6 x 1-1/4” (32) phillips trusshead screws.

2. Polyurethane foam gasket around edge of frame is available on request.

3. The standard finish is #22 Satin Polish with one coat of clear lacquer. Other finishes available on request.

4. Blades can be aligned either horizontally or vertically, and are fixed at 0° deflection.

5. Center mullion is used for blade lengths exceeding 24” (610) nominal size in either dimension.

6. Standard sizing is in even inch increments in both dimensions. Odd inch and fractional sizing [in 1/8” (3) increments] is available on request.

7. This product is covered by U.S. Patent #5,771,647.

8. Grille construction is type 304 stainless steel.

9. Damper construction on Model RMRB is electrogalvanized steel.

10. Damper construction on Model RKRB is type 304 stainless steel blades and frame ends, with electrogalvanized frame sides.

11. The standard operator on the damper takes a medium size flat-blade screwdriver.

12. Maximum size shown is the maximum single panel size. Panels can be joined for larger sizes.

13. Metric dimensions are given in millimeters.

Blade Minimum Maximum

Model Construction Damper Alignment W x H W x H

RLRBH No Horizontal

RLRBV No Vertical RMRBH Stainless Steel Horizontal 4” x 4” 36” x 36” RMRBV Steel Steel Vertical (102 x 102) (914 x 914) RKRBH Stainless Steel Horizontal

RKRBV Stainless Steel Vertical