Cardo SCALA-700 User Manual

scala-700

TM

QUICK GUIDE

INTRODUCTION

This quick guide will assist
you with the use of the scala-
700 headset. For more
detailed information please
download the User Manual
from our website at
www.cardowireless.com.
Before using the scala-700 we
recommend that you
familiarize yourself with the

Bluetooth® functionality of

your cellular phone. See the
User Manual for safety
information.

IMPORTANT: Please visit

www.cardowireless.com/FAQ.php

to check whether your particular
cellular phone has any Bluetooth
related bugs that may affect its
operability with your headset.

COMPONENTS

Wheel

USB

Charging

Jack

Speaker

Control

Button

Ear

Loop

Status

Light

scala-700

BEFORE USING

1. Make sure that the headset is fully charged for at least four hours
before initial use.

2. To charge the headset, plug the charger into the headset’s Charging
Jack, which is located just below the Wheel.

3. While charging, the red Status Light illuminates. When charging is
completed the light will turn off.

NOTE: Plugging in the charger turns off the headset. You must
turn on the headset after charging.

When plugging the headset into the charger, it may take up to
15 seconds before the red Status Light turns on.

GENERAL INSTRUCTIONS

All headset functions are controlled either by:

• Pressing the Control Button either for a short period of less than a

second, or a long period of over three seconds,

Or

• Moving the Wheel up or down, or by pressing it inwards.

TM

2

scala-700

TM

TURNING THE HEADSET ON FOR THE FIRST TIME

In order for your headset to work with your cellular phone, they must
first recognize each other. This process is called “pairing”, and only
needs to be performed once for each phone.

1. To initiate pairing, press the Wheel for at least 8 seconds while the

headset is turned off. The Status Light will flash red and blue indicating
that the headset is in pairing mode.

2. Turn on your phone and make sure that its Bluetooth function is

activated.

3. Search for Bluetooth devices on your phone by following the phone’s

instructions.

4. After a few seconds the phone will list the scala-700 as a “discovered

device”. Select it and follow your phone’s instructions to accept the
pairing.

5. When prompted, enter 0000 (four zeros) as your PIN or passkey.

6. Your phone will confirm that pairing has succeeded.

Note: If pairing is not completed within two minutes the headset
will return to standby mode.

3

scala-700

TM

You can enter pairing mode at any time by pressing the Wheel
for at least 8 seconds while the headset is turned off

Your Headset can pair with up to eight phones, and will automatically
connect to the last phone connected to the Headset. To connect to a
different phone go to the Bluetooth menu of the active mobile phone
and disconnect the Headset. Now go to the Bluetooth menu of the
desired phone and connect the Headset to this phone.

ATTACHING THE HEADSET TO YOUR EAR

Attach the Headset to your ear using the Ear-Loop. Insert the pin of the
Ear-Loop to a suitable depth so that the speaker fits snugly into your
ear (hovering above your ear canal), then bend the flexible bow of the
Ear-Loop to produce a snug but comfortable fit.

SWAP BETWEEN TWO ACTIVE MOBILE PHONES

The scala-700 allows you to swap, i.e. to alternately use one among the
last two phones to which it has been connected.

While both phones are turned on and the headset is on standby, double­press the wheel. Now the Headset will switch to the second phone.
Each time you double-press the wheel, the alternate phone connects
to the Headset.

4