Canon WP A1 User Manual
Océ User Manual
Two-Knife Booklet Trimmer-A1
Operating information
Copyright
Copyright 2011 by Canon Inc. All rights reserved.
No part of this publication may be reproduced or transmitted in any form or by any means,
electronic or mechanical, including photocopying and recording, or by any information
storage or retrieval system without the prior written permission of Canon Inc.
© 2011, Océ
All rights reserved. No part of this work may be reproduced, copied, adapted, or transmitted
in any form or by any means without written permission from Océ.
Océ makes no representation or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose.
Furthermore, Océ reserves the right to revise this publication and to make changes from
time to time in the content hereof without obligation to notify any person of such revision
or changes.
Edition: 07-2011
Contents
Contents
Chapter 1
Preface.................................................................................................................5
Notes for the reader...................................................................................6
Naming conventions for finishers (commercial naming and naming in
User Interfaces)..........................................................................................8
Chapter 2
Parts and their functions....................................................................................9
Machine description.................................................................................10
Two-knife trim section.............................................................................11
Conveyor section......................................................................................13
Trim ejecting section................................................................................15
Chapter 3
Operating procedures.......................................................................................17
Turn the trimmer on.................................................................................18
Operation while trimming.......................................................................19
Remove or install the delivery tray.........................................................22
Chapter 4
Troubleshooting................................................................................................23
Error messages.........................................................................................24
Overview of possible errors....................................................................25
Clear a paper jam.....................................................................................27
Appendix A
Specifications....................................................................................................29
Specifications............................................................................................30
3
Contents
4
Chapter 1 Preface
Notes for the reader
Notes for the reader
Introduction
This manual helps you to use the Two-Knife Booklet Trimmer-A1. The manual contains
a description of the product and guidelines to use and operate the Two-Knife Booklet
Trimmer-A1.
Definition
Attention-Getters
Parts of this manual require your special attention. These parts can provide the following:
•
Additional general information, for example, information that is useful when you
perform a task.
•
Information to prevent personal injuries or property damage.
Warning, Caution and Note
The words Warning, Caution and Note draw your attention to important information.
Overview of the attention-getters#
Warning
IndicatesIconWord
Ignoring this warning could cause serious injury or
even death.
The Warning indication has several icons that warn
against various hazards. The icons are shown below.
General hazardWarning
Hot surfaceWarning
Electric shockWarning
Moving partsWarning
Chapter 1 - Preface6
Notes for the reader
IndicatesIconWord
Laser beamWarning
Caution
Important safety instructions
Warning:
Do not remove the safety covers or deactivate the sensor switches for the safety covers.
Otherwise, the machine may start suddenly without warning, leading to severe injury.
Warning:
When removing jammed booklets from the infeed section, do not put your hands and
fingers close to the belt. Otherwise, if the belt moves suddenly without warning, your
hands and fingers may be caught.
Ignoring this warning could cause injury or damage to
property.
Indicates additional important information.Note
The use of heat-resistant gloves is mandatory when you
carry out these actions.
Warning:
This machine weighs 145 kg (319 lb). When you operate the machine, consider the machine weight and use the machine safely.
Chapter 1 - Preface 7
Naming conventions for finishers (commercial naming and naming in User Interfaces)
Naming conventions for finishers (commercial naming and
naming in User Interfaces)
Hardware and hardware naming in User Interfaces
To improve the readability of texts in User Interfaces of operator panels and software,
the finishers are generally referred to by their function. The table below shows the naming
conventions for finishers (commercial product names and the way these are referred to
in User Interfaces).
Note:
In some cases, there is only 1 name for several modules. The reason is that a configuration
can only contain 1 of the available types of modules.
Conversion table for commercial names versus user-friendly names in User Interfaces#
Commercial product name:
In UI, printer driver and software referred to as:
'Stacker/stapler'Finisher-AF1
'Stacker/stapler'Saddle Finisher-AF2
'Puncher'Puncher Unit-BP1/BQ1/BR1
'Folder'Paper Folding Unit-F1
'Inserter'Document Insertion Unit-F1
'Stacker'High-Capacity Stacker-E1
'Trimmer'Booklet Trimmer-D1
'Trimmer'Two-Knife Trimmer-A1
'Perfect Binder'Perfect Binder-C1
'Scanner'Duplex Color Image Reader Unit-D1
Chapter 1 - Preface8
Chapter 2 Parts and their functions
Machine description
Machine description
Illustration
Main sections
Main sections#
Chapter 2 - Parts and their functions10
More informationSection
‘Two-knife trim section’ on page 11Two-knife trim section1
‘Conveyor section’ on page 13Conveyor section2
‘Trim ejecting section’ on page 15Trim ejecting section3
Loading...