Canon C555 Owner's Manual

Step 1: Unpack the MultiPASS

1. Carefully remove all items from the box.

• Remove these items from the documentation package: Quick Start Guide, the Canon Creative for
MultiPASS CD-ROM, Registration card, and Warranty card.

• Remove these hardware items from the top tray:

• Lift out the MultiPASS unit. Always lift the unit from the bottom.

Important!

Save the box and shipping materials for transporting the MultiPASS in the future.

2. Remove all pieces of shipping tape and protective materials from the unit.

• Remove all pieces of shipping tape from the outside of the printer. Be sure to remove the tape
from the back of the printer also.

• Remove the protective plastic piece from the sheet feeder and protective foam block from the
paper path.

Note that tape may not be in the exact locations shown here.

3. Open the document tray.

• Remove the protective she et covering the operation panel.

4. Open the operation panel.

• Use both hands to grip the operation panel, and gently pull it toward you until it opens partially.

• Remove the soft foam sheet from the unit's Automatic Document Feeder (ADF).

Press the operation pa nel closed unt il it clicks into place.

5. Open the Automatic Document Feeder (ADF).

• Grasp both document guides and lift up. Check fo r any shipping tape or shipping material inside
the unit and remove it.

Step 2: Set Up the MultiPASS

1. Attach the sending document support.

2. Connect the phone line.

The MultiPASS unit has three telephone jacks (located on the left side of the unit) that will accept standard
line connections.

Use the bottom jack to c onnect the MultiPASS to the wall jack with the supplied line cord (unless
connected with Caller ID). The other two jacks are pass-through ports to connect other devices to the
MultiPASS and your telephone service. Selec t from the options in the diagram below to configure your
telephone device to work in conjunction with your MultiPASS.

If you have only one telephone line and plan to use the MultiPASS for receiving both faxes and voice calls,
you must attach a telephone and/or answering machine to the unit.

NOTE: If you use Caller ID with any of these configurations, place the Caller ID device between the
MultiPASS and the wall jack.