Candy CGM 61 User Manual

CGM61/1X-07,CGM61/1N-07,
CGM61/1W-07,CGM91/1X-07,
CGM91/1N-07,CGM91/1W-07

Instructionmanual
CGM61/1X-07,CGM61/1N-07,
1
CGM61/1W-07,CGM91/1X-07,
CGM91/1N-07,CGM91/1W-07
Cooker Hood
Instruction Manual
Content
2
1…………………………………..………………………………Safety instructions
2…………………………………..………………………………Installation
3…………………………………..………………………………Start using your cooker hood
4…………………………………..………………………………Troubleshooting
5…………………………………..………………………………Maintenance and cleaning
6…………………………………..………………………………Environment protection
SAFETY INSTRUCTIONS
3
This manual explains the proper installation and use of your cooker hood,
please read it carefully before using even if you are familiar with the product.
The manual should be kept in a safe place for future reference.
Never to do:
Do not try to use the cooker hood
without the grease filters or if the filters are excessively greasy!
Do not install above a cooker with a
high level grill.
Do not leave frying pans unattended
during use because overheated fats or oils might catch fire.
Never leave naked flames under the
cooker hood.
If the cooker hood is damaged, do not
attempt to use.
Do not flambé under the cooker hood.
CAUTION: Accessible parts may
become hot when used with cooking appliances.
The minimum distance between the
supporting surface for the cooking vessels on the hob and the lowest part of the cooker hood. (When the cooker hood is located above a gas appliance, this distance shall be at least 65 cm)
The air must not be discharged into a
flue that is used for exhausting fumes from appliances burning gas or other fuels.
Always to do:
Important! Always switch off the
electricity supply at the mains during installation and maintenance such as light bulb replacement.
The cooker hood must be installed in
accordance with the installation instructions and all measurements followed.
All installation work must be carried
out by a competent person or qualified electrician.
Please dispose of the packing material
carefully. Children are vulnerable to it.
Pay attention to the sharp edges
inside the cooker hood especially during installation and cleaning.
When the cooker hood is locat ed
above a gas appliance,the minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the cooker hood that distance must be: Gas cookers: 75 cm Electric cookers: 65 cm
Coal or oil cookers: 75 cm
Make sure the ducting has no bends
sharper than 90 degrees as this will reduce the efficiency of the cooker hood.
Warning: Failure to install the screws
or fixing device in accordance with these instructions may result in electrical hazards
Always to do:
4
Always to do:
Always put lids on pots and pans
when cooking on a gas cooker.
When in extraction mode, air in the
room is being removed by the cooker hood. Please make sure that proper ventilation measures are being observed. The cooker hood removes odours from room but not steam.
There shall be adequate ventilation of
the room when the cooker hood is used at the same time as appliances burning gas or other fuels.
Cooker hood is for domestic use only.
If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
This appliance can be used by
children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Caution: The appliance and its
accessible parts can become hot during operation. Be careful to avoid touching the heating elements. Children younger than 8 years old should stay away unless they are under permanent supervision.
There shall be adequate ventilation of
the room when the cooker hood is used at the same time as appliances burning gas or other fuels.
There is a fire risk if cleaning is not
carried out in accordance with the instructions
Regulations concerning the discharge
of air have to be fulfilled.
Clean your appliance periodically by
following the method given in the chapter MAINTENANC E.
For safety reason, please use only the
same size of fixing or mounting screw which are recommended in this instruction manual.
Regarding the details about the
method and frequency of cleaning, please refer to maintenance and cleaning section in the instruction manual.
Cleaning and user maintenance shall
not be made by children without supervision.
When the cooker hood and
appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
Warning: Before obtaining access to
terminals, all supply circuits must be disconnected.
INSTALLATION (VENT OUTSIDE)
5
If you have an outlet to the outside, your cooker hood can be
connected as below picture by means of an extraction duct (enamel, aluminum,
flexible pipe or inflammable material with an interior diameter of 150/120mm)
1. Before installation, turn the unit off and unplug it from the outlet.
2. The cooker hood should be placed at a distance of 65~75cm above the
cooking plane for best effect.
3. Install the hook on a suitable place once the installation height is fixed, and
keep it in line. The fixed position of the inside chimney bracket is the place of
chimney. See pic 2.
4. Fix the expansion pipe according to the lead direction and way, and then put
6
the cooker hood on the hook. Lay the expansion pipe to the wall outlet. Fix the
expansion pipe with the cable tie on the wall-outlet if it is aluminium foil
pipe.See pic 3.
5. Put the glass according to the lead direction and way on the cooker hood,
and then use the screws to fix the glass, also lead the expansion pipe outside of
the room, meanwhile adjust the height of the inside chimney to the position of
the inside chimney bracket and fix on it by screw , here should be sure the
inside chimney can be flexed freely. See Pic 4.
6. Put the two chimneys together onto the cooker hood body, meanwhile adjust
the height of the inside chimney into the suitable height, and fix the inside
chimney to the inside chimney bracket by screw. Finally, fix the body with safety
screw. See Pic 5.
Note: The two safety vents are positioned on the back housing, with diameter
of 6mm.
MOUNTING OF THE V-FLAPOptional
7
If the cooker hood does not have an assembled V-flap 1, you should mount the
half-parts to the its body.
To mount the V-flap 1 you should:
• Mount two half-parts 2 into the body 6
• a pin 3 should be top oriented;
• the axis 4 should be inserted in the holes 5 on body;
• repeat all the operations for the 2nd
half-part
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
• Keep expansion pipe short and straight.
• Do not reduce the size or restrict expansion pipe.
• When using expansion pipe always install the pipe pulled taut to minimize pressure loss.
• Failure to observe these basic instructions will reduce the performance and increase noise levels of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent person.
•Do not connect the ducting system of the hood to any existing ventilation system which is being used for any other appliance ,such as warmer tube, gas tube , hot wind tube.
•The angle of the bend of the expansion pipe should not be less than 120º; you must direct the pipe horizontally, or, alternatively, the pipe should go
up from the initial point and should be led to an outer wall.
•After the installation ,make sure that the cooker hood is level to avoid
WARNING:
For safety reason, please use only
screw which are recommended in
device in accordance with these
result in electrical
hazards.
8
grease collection at on end.
•Ensure the expansion pipe selected for installation complies with relevant standards and is fire retardant.
the same size of fixing or mounting this instruction manual.
Failure to i nstall the scre ws or fi xing
instructions may
Start Using Your Cooker Hood
Push button
1) Push stop button, and the motor will stop.
2)Push the low button, and the motor runs at low speed.
3)Push the middle b ut ton, and the motor runs at mid speed.
4)Push the high button, and the motor runs at high speed.
5)Push the light button and the two lights will come on. Push it again and the light will turn off.
TROUBLESHOOTING
9
Fault Possible Cause Solution
Light on, but
motor does not
work
Light does not
work, motor does
not work
Oil leakage
Lights not
working
Fan switch turned off Select a fan switch position.
Fan switch failed Contact service center.
Motor failed Contact service center.
House fuses blown Reset/Replace fuses.
Power cord loose or
disconnected
One way valve and the air
ventilation entrance are not
tightly sealed
Leakage from the connection
of U-shaped section and
cover
Broken/Faulty globes
Refit cord to power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take U-shaped section down
and seal.
Replace globes as per this
instruction.
The distance between the
Insufficient
suction
The Cooker hood
inclines
cooker hood and the gas top
is too far
The fixing screw not tight
enough
Refit the cooker hood to the
correct distance.
Tighten the hanging screw
and make it horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local,
state and federal laws.Please contact the service centre if in any doubt before undertaking any of the above.Always disconnect the unit from the power sou rce whe n ope ni n g the unit .
MAINTENANCE AND CLEANING
Caution:
Before maintenance or cleaning is carried out,
the cooker hood should be disconnected from the main power supply. Ensure that the cooker hood is switched off at the wall socket and the plug removed .
Loading...
+ 21 hidden pages