Campbell Hausfeld WS090001AV User Manual

Additional Model Instructions

Model WS090001AV

Addendum to Owner’s Manual

IN170138AV 2/99

Shielded Metal
Arc Welder

© 1999 Campbell Hausfeld/Scott Fetzer

Description

Thank you for purchasing the
Campbell Hausfeld 70 amp Arc Welder,
Model #WS090001AV. This instruction
sheet is to be used in conjunction with
the standard owner’s manual included
with the welder (IN198904AV). Please
refer to this sheet for WS090001AV
assembly instructions.

Please read all
warning instructions in
the owner’s manual
before operating.

Components

The WS090001 comes with the
following additional equipment:

• Automatic amperage adjustment ­low position for 1/16” rods and
high position for 5/64” rods--for
ease of use.

• Cable storage clips (shown in
Handle Assembly) for safer storage
of welding cables.

Handle Assembly

1. Align the end holes on the handle
with the holes on top of the welder,
then secure with screws (Figure 1).

2. Insert cable clips by pressing inward
on sides of clip and pushing into
the slots on front of handle as
shown in Figure 2. Repeat for
opposite side of handle.

Electrode Holder Assembly

(Refer to Figure 3)

1. Remove insulation handle from the
holder body by pulling the two

pieces apart.

2. Slide the other weld cable through
the handle.

3. Loosen the wire clamping screw
and slide the bare cord wire under
the clamp block. Tighten the
clamping screw and make sure the
wire is secure.

4. Slide the handle over the electrode
holder body and press to stop.
Make sure the handle is secure and
there is no exposed metal on the
holder.

Figure 3 - Electrode Holder

Figure 2

Figure 1

For parts, product & service information

visit www.campbellhausfeld.com

BUILT TO LAST

!

NOTICE

MANUAL

TM

Ref. Part Number
No. Description for WS090001 Qty

1 Electrode holder assembly - cord not included (includes ref. # 2-7) WC200000AV 1
2 Electrode holder handle - cord not included WC200001AV 1
3 Electrode holder body WC200002AV 1
4 Insulation cap WC200003AV 1
5 #10-24 x .5” machine screw * 1
6 #10-24 x 7/16” square nut * 1
7 Work clamp WC100300AV 1
8 Handle WC301300AV 1

9 #8-36 x 3/4” pan head screw * 2
10 Safety decal (right) DK404300AV 1
11 Safety decal (left) DK404400AV 1
12 Welding cable 6 AWG (6 ft) * 2
13 Power cord 14-3 AWG (6 ft) Type SJT WC000100AJ 1
14 High/off/low thermal indicator WC401000AV 1
15 Strain relief WC102000AV 2
16 Cord storage clip WC301301AV 2

* Standard hardware item, available at local hardware or welder supply store

Additional Model Instructions WS090001

For Replacement Parts, call 1-800-746-5641

9

10

16

15

7

12

13

14

11

9

8

2

6

5

1

3

4

Address parts correspondence to:

The Campbell Group
Attn: Parts Department
100 Production Drive
Harrison, Ohio 45030

Please provide following information:

- Model number

- Serial number (if any)

- Part description and number as
shown in parts list

12