Camden Door Controls CV-800EV, CV-800SES-EV, CV-800SES Quick Start Guide

CV-800SES/CV-800EV Serial

to Wiegand Converter

Installation Instructions

Section 1:

General Description

The CV-800SES/CV-800EV is a Serial to Wiegand Converter
for the SES TEC/CAT & Viscount Elektra Telephone Entry
Systems.

It captures the Dial code a visitor enters into the lobby Panel,
Converts it to 26bit Wiegand Format, then sends it to an

Access Control System when the Resident Grants the visitor
Access.

The CV-800SES/CV-800EV also has provision for the postal
Lock Switch. When the normally open postal Lock switch
is activated, the CV800 will send “9999” in 26bit Wiegand
format to the Access Control system.

Note: THE CV-800SES/CV-800EV Requires that the SES CAT/
TEC and the Viscount Electra telephone entry systems have
the OPTKSERIAL Serial Port adapter installed (available as an

option from your SES & Viscount Distributors)

a) The Baud rate must be set to 9600 (default)

b) Communications parameters must be set to
8bits, stopbit, no parity (8,N,1)(default)

c) Dial Codes must not have a value greater than

65535.

Section 2:

Installation

To Install the CV-800SES/CV-800EV

1) Connect the Rx terminal of the CV800 to the TX terminal
of the OPTKSERIAL Serial Port adapter.

Connect the Gnd terminal of the CV800 to the COM
terminal of the OPTKSERIAL Serial Port adapter.

2) Connect the 12V terminal of the CV800 to the Access
Control Reader +12V Input.

Connect the 0V terminal of the CV800 to the Access
Control Reader 0V Input.

Connect the D1 terminal of the CV800 to the Access
Control Reader D1 Input.

Connect the D0 terninal of the CV800 to the Access
Control Reader D0 Input.

Program the Access Control System with the Dial Codes

Section 3:

Specifications

Output Format

Facility Code

Power Supply

Maximun Current
Requirements

Cable Distance

The following must be programmed in the SES or
Viscount telephone entry panels.

Push Buttons Keypads Strikes Magnetic Locks Key Switches Relays & Timers Access Control

5502 Timberlea Blvd.,
Mississauga, ON Canada L4W 2T7

www.camdencontrols.com
Toll Free: 1.877.226.3369

Page 1 to 1

Warranty

26 bit Wiegand

0 (zero)

9 to 14VDC
(Linear Power Supply Recommended)

Average 7ma, Peak 10ma.

300 Feet (90 Metres) (Reader Input )

3 Year Warranty against defects in
Materials and Workmanship

File: CV-800SES/CV-800EV
Installation Instructions R3.innd
Revision: 5/09/2018
Part No.: 40-82B101