Bush W-120 Instruction manual

EN
6
Setting sleep timer
1. Press SLEEP. “90” will illuminate on the display.
2. Repeatedly press SLEEP to select the desired sleep time from 90, 80, 70,
60, 50, 40, 30, 20 or 10 minutes.
To check remaining sleep time, press SLEEP. To cancel sleep timer, press SLEEP until “OFF” is
selected.
To turn off the radio before the sleep time has elapsed, press
POWER.
DIMMER CONTROL
Repeatedly press DIMMER to adjust the brightness of display (bright or dim).
Care and Maintenance
Wipe external surfaces with a soft cloth. If the cabinet is very dirty, unplug from the mains supply and use a damp cloth soaked in a weak solution of washing up liquid and water. Allow to dry thoroughly before reusing.
Specifications
Power source: AC 230V-240V~ 50Hz, 5W Power consumption (clock only) : < 1W FM: 87.5 – 108 MHz Clock backup: 2 x 1.5V AAA size batteries (not included)
We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development.
Recycling electrical products
You should now recycle your waste electrical goods and in doing so help the environment. This symbol means an electrical product should not be disposed of with normal household waste. Please ensure it is taken to a suitable facility
for disposal when finished with. Visit www.recycle-more.co.uk, click on “bank locator” and enter your postcode to find your nearest recycling site.
Instruction Manual
W-120
Wooden Alarm Clock Radio | Instruction manual
Table of content
Warnings
Battery Handling and Usage
UK Mains Plug Information
Location of Control
Battery Backup
Standby Mode
Setting The Clock
Power On/radio Mode
Radio Operation
Presetting Your Favourite Radio Stations
Dual Alarms Operation
Setting Alarm 1 or Alarm 2
Checking Alarm Time
Snooze Function
Sleep Timer Operation
Setting Sleep Timer
Dimmer Control
Care and Maintenance
Specifications
Recycling Electrical Products
1
2
2
3
4
4
4
4
4
5
5
5
5
5
5
6
6
6
6
6
.............................................................................................
............................................................
............................................................
.........................................................................
...............................................................................
................................................................................
...........................................................................
....................................................................
..............................................................................
..........................................
....................................................................
................................................................
.......................................................................
.............................................................................
....................................................................
..........................................................................
...............................................................................
.....................................................................
...................................................................................
.........................................................
EN
5
NOTE:
For the best FM reception, extend the FM aerial to its full length.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM radio stations can be preset.
1. Follow steps in "RADIO OPERATION" and tune into the station that you wish to preset.
2. Press and hold SET for about 2 seconds, “P01” will flash on the display.
3. Press SET again to store the station.
4. Repeat steps 1 to 3 to store desired stations.
5. To listen to preset radio stations, press MEM repeatedly to select the desired radio station.
DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
1. In standby mode, press and hold AL1 or AL2 for 2 seconds.
The hour and minute digits will flash.
2. Set the alarm time by repeatedly pressing HR and MIN respectively.
Press and hold HR and MIN respectively for fast advance.
3. Press AL1 or AL2 again to select the alarm sound (OFF>BUZZER>RADO in
cycle.
Checking alarm time
Press and hold AL1 or AL2 for 2 seconds, the alarm time will flash on the display.
To turn off the alarm, press POWER and the alarm will come on again at
the set time on the following days.
To cancel the alarm, repeatedly press AL1 or AL2 until the alarm indicator
light goes out on the display.
Snooze function
This function can be used to stop the alarm temporarily for about 9 minutes once the alarm is activated. When the snooze button is pressed, the buzzer or radio alarm sounds will stop and sound again after about 9 minutes.
SLEEP TIMER OPERATION
The sleep function is designed to automatically turn off the Radio.
Loading...
+ 2 hidden pages