Bush DFTA45R Instruction Manual
High Definition Digital Set Top Box
With USB Record
INSTRUCTION MANUAL
DFTA45R
The Gold Technical Support Line: 1902 215 259
(Charges will apply at $2.95 per minute)
Safety Instructions
Always read the safety instructions carefully
Keep this Instruction Manual for future reference
Keep this device away from humidity
Lay this device on a reliable flat surface before setting it up
Do not stand it on soft furnishings
If any of the following situation arises, get the Set Top Box checked by
a service technician:
It has been exposed to moisture
It has been dropped and damaged
It has obvious sign of breakage
It has not been working well or you cannot get it to work according
to the Instruction Manual
Warning
To prevent the risk of electric shock, do not open the cover or the
back of the receiver.
Do not block the ventilation holes of the device. Leave appropriate
gap above and around it to allow for adequate ventilation.
Do not place the device in an unventilated cabinet or on top of a unit
which emits heat.
Copyright Statement
No part of this publication may be reproduced in any form by any means
without the prior written permission. Other trademarks or brand names
mentioned herein are trademarks or registered trademarks of their
respective companies.
Disclaimer
Information in this document is subject to change without notice.
The manufacturer does not make any representations or warranties
(implied or otherwise) regarding the accuracy and completeness of this
document and shall in no event be liable for any loss of profit or any
commercial damage, including but not limited to special, incidental,
consequential, or other damage.
Introduction
Thank you for buying this Bush product, which is designed to give you many
years of trouble-free service.
You may already be familiar with using a similar unit, but please take time to
read these instructions. They are designed to familiarise you with the unit s
m any features and to ensure you get the very best from your purchase.
Safety is important
Your safety and the safety of others is important. Please therefore, ensure you
read the Safety Instructions before you operate this unit.
Warranty
In the unlikely event that your product fails to work normally, please call the
below Bush warranty number for support.
Australia
Bush Warranty: 1800 509 394
New Zealand
Bush Warranty: 0800 450 259
About the Set Top Box
This DVB-T TV Receiver allows you to access Free-to-Air Digital TV
Channels and Radio Broadcasts on your TV set. Its digital reception
covers VHF & UHF band. Digital TV eliminates noise and interference
and offers high quality video and audio.
An easy to use on-screen installation guide is provided. In addition,
a fully featured Remote Control is included that offers you access
to every feature with a simple press of a button.
Main Features
Compliant with Australian DVB-T Standards
Full MPEG2 ISO/IEC 13818 Transport Stream Compliant Audio/
Video Decoding
Bandwidth of 7/8MHz Supported
COFDM Demodulator
Automatic/Manual Channel Search
Channel Edit, Moving and Deletion
Parental Lock Control
EPG (Electronic Program Guide) and Teletext Function (where
available)
HDMI Output
Multiple-Language OSD
Supports Multi-Subtitle
Recording and Software Upgrade
Tuner RF In/Loop Through
Component / Video / Digital Audio via Coaxial Output
Full Function Remote Control
USB Input Supports JPEG Files, Music Files, Video Files for
Timeshift
Package Contents
Before installation, please check the items of the package.
The package should contain the following items:
~ DVB-T TV Receiver x1 pc
~ Remote Control x1 pc
~ AAA Battery for the Remote Control x1 pair
~ Instruction Manual x1 pc
~ Composite RCA Cable x1 pc
Table of Contents
Front and Rear Panel ..........................................................................5
Remote Control ................................................................................6-7
Connecting to a Television................................................................... 8
Connecting to an Audio System............................................................. 9
Connecting to a DVD Recorder or VCR.................................................10
First Time Installation... ......................................................................11
Basic Operations..........................................................................
Troubleshooting
................................................................................20
11-19
Technical Specifications..................................................................... 21
Warranty........................................................................................... 22
Front and Rear Panel
1. Front panel
3
5
6
4
1 POWER BUTTON:
2 STANDBY INDICATOR:
Press the Power Button to turn the unit on or off.
Standby Indicator will be red if the Set Top Box is in
Standby Mode or Green if the unit is on.
3 REMOTE CONTROL SENSOR:
4 USB:
USB Input Supports JPEG Files, Music Files, Video Files for Recording and
Receives the Signal from the Remote Control.
Software Upgrade
5 CHANNEL UP/DOWN:
6 STANDBY:
Press the Standby Button to turn the unit to standby.
Press the Channel Buttons to change the Channel.
2. Rear panel
Digital
LOOPRF
INRF
THROUGH
Audio
Coaxial
Pb
Pr
VIDEO
Y R
COMPONENT VIDEO / AUDIO OUT
L
POWER SUPPLY: AC 230V ~ 50Hz
MAX POWER CONSUMPTION: 8 WATTS
BUSH WARRANTY: 1800 509 394 AUSTRALIA
BUSH WARRANTY: 0800 450 259 NEW ZEALAND
Serial No.:
MADE IN PRC
DFTA45R
N14119
2010/10
HDMI OUT
AC 230V
~50Hz
1 2
RF IN : This socket connects to your external Aerial.
1
RF LOOP THROUGH: This socket will bypass the RF signal to either your TV or
2
3
another video system.
COAXIAL: This socket connects to a Coaxial cable on your surround sound system.
3
VIDEO: This socket outputs composite video signal.
4
These sockets connect to your TV component input
5 COMPONENT VIDEO OUT:
terminals.
AUDIO L/R: This socket outputs Analog Audio L/R signal.
6
HDMI
7
MAINS CABLE: This is used to connect to your main power supply.
8
High definition audio and video output used to connect to a HDMI device
4
6
5
7 8
5
Remote Control
1. MUTE: Press the Mute Button to switch off the
27
Sound only. Press again to restore audio output
STANDBY
MUTE
2. INFO: Press the INFO Button to display the current
channel information
EPG
INFO
TTX
3. TTX: Press the TTX to enter the Teletext Menu
4. SUBTITLE: Press the Subtitle Button to select the
subtitle setting
5. EXIT: Press the Exit button to exit the current
Menu or return to the previous Menu
6. OK: Press the OK Button to confirm settings or
menu selections. Also press to display the channel list
AUDIO
MENU EXIT
REC
CH+
OK
SUBTITLE
VOL+VOL-
7. RIGHT / LEFT: Press the Navigate Buttons to move
through the Menu options or to increases or decreases
the volume
8. TV/RADIO: Press the TV/Radio Button to switch
between from TV and Radio mode
9. RECALL: Press the Recall Button to go back to the
previous channel you were watching.
FAVOURITE
1 2 3
4 5 6
7 8 9 0
CH-
TV/RADIO
RECALL
GOTO
10. GOTO: Press the GOTO Button to select the
multimedia option
11. PREV: Press the Prev Button to skip to the
REV
PAUSE STOP REPEAT
PLAY
PREV NEXT
FWD
previous track in multimedia mode or timeshift in DTV
mode
12. NEXT: Press the Next Button to skip to the Next
track in multimedia mode or timeshift in DTV mode
13. REPEAT: Press the Repeat Button to repeat play in
multimedia mode
14. STOP: Press the Stop Button to stop play in Multimedia
mode and return to
normal viewing in timeshift mode.
15. STANDBY: Press the Standby Button to turn the unit to standby
16. EPG: (Electronic Program Guide) Press the EPG Button to enter the EPG
menu
17. AUDIO: Press the Audio Button to change the audio settings
18. UP / DOWN: Press the Navigate Buttons to scroll through the Menu or to
scroll through the channel list.
19. MENU: Press the Menu Button to enter the Main Menu
20. FAVOURITE: Press the Favourite Button to enter the Menu
21. 0-9 (Numeric Buttons): Press the Numeric Buttons to enter a channel
directly or setting information
22. FWD: Press the FWD Button to Fast Forward in Multimedia or mode
23. REV: Press the Rev Button to Rewind in Multimedia mode
timeshift
or timeshift mode
24. PLAY: Press the Play Button to begin or resume play in multimedia mode
25. Pause: Press the Pause Button to pause play in multimedia mode or to
pause live TV.
26. COLOUR BUTTONS: Press the Colour Buttons to select different options in
the menu, EPG and Teletext modes
27. REC: Press the Rec Button to record the program you are watching
6
Installing the Batteries
Remove the battery cover from the and put 2xAAA size
Remote Control
batteries inside the compartment.
The diagram inside the Battery Compartment shows the correct way to
install the batteries.
1.Open the cover
OPEN
2.Install batteries
3.Close the cover
N
E
OP
Using the Remote Control
To use the Remote Control, point it towards the front of the Digital Set Top Box.
The Remote Control has a range of up to 7 metres from the Set Top Box at an
angle of up to 60 degrees.
The Remote Control will not operate if its path is blocked.
Sunlight or very bright light will decrease the sensitivity of the
Remote Control.
7
Loading...