Bush BC-501, BC-503, BC-502, BC-404 Instruction Manual

BC-501 Pets Bagged Cylinder Vacuum Cleaner

Instruction Manual -

Please keep for future reference

BC-501

For help, spares or
assistance please call

0845 6042377

or visit
www.bagsandfilters.com

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 1

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 2

1

IMPORTANT SAFETY INSTRUCTIONS

Read all instruction before use and keep for future reference.

FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety
precautions should always be observed, including
the following:

1. Only use the vacuum cleaner indoors on dry surfaces.
Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.

2. Turn off the vacuum cleaner controls before
disconnecting or connecting from the mains supply.

3. Always unplug the vacuum cleaner before connecting
or disconnecting the vacuum hose and accessories.

4. Children should be supervised to ensure that they do
not play with the appliance.

5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.

6. Only use as described in this manual. Only use
recommended attachments.

7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into water.

8. Do not use the vacuum cleaner with a damaged cord
or plug. If the supply cord is damaged, call the helpline
for assistance.

9. Do not pull or carry by cord. Do not use the cord as a
handle, close a door on the cord or pull cord around
sharp edges or corners. Do not run the vacuum cleaner
over the cord. Keep the cord away from heated
surfaces.

10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air-flow.
Keep all openings free of dust, lint, hair or anything that
might reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.

12. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.

13. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene etc.) or use in the
presence of explosive liquids or vapours.

14. Do not vacuum up harmful or toxic material
(chlorine, bleach, ammonia, drain cleaner etc.).

15. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.

16. Do not use without ALL of the filters in place.

17. Take extra care when vacuuming on stairs.

18. Keep vacuuming area well lit.

19. Store the vacuum cleaner in a cool, dry area.

20. Turn off the on/off switch before unplugging the
vacuum cleaner.

21. Only use CE - approved 13 amp extension cords.
Non-approved cords may overheat. Care should be
taken to arrange the cord so that the cord cannot be
tripped over.

WARNING: Always switch off and unplug the

vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, connecting/disconnecting the attachments, or
carrying out maintenance or troubleshooting checks.

CAUTION: The vacuum cleaner is a very

powerful unit. Before plugging the cord into the

electrical outlet, make sure the switch is in the
‘off’ position. Hold the vacuum cleaner firmly when
starting and in use.

IMPORTANT: If the inlet, hose or extension

tube is blocked, switch off the vacuum cleaner

and remove the blockage(s) before re-starting
the vacuum cleaner.

IMPORTANT: We recommend that filters should

be checked and cleaned periodically. For
washable filters, ensure they are completely dry before
inserting back into the vacuum cleaner. Do not wash
with detergents. Use only warm water, max 40°c.

IMPORTANT: The motor is equipped with a

thermal cut-out. If for any reason the unit

should overheat, the thermostat will
automatically turn the unit off. Should this occur, unplug
the vacuum cleaner from the electrical outlet and turn
off the switch. Remove dirt container and empty. Clean
filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and switch
back on.

This vacuum cleaner is intended for household use
only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.

!!!

!

!

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 3

2

CONTENTS

SAFETY INFORMATION 1

KNOW YOUR MACHINE 3

ASSEMBLY 4

OPERATION 4

Accessories 5

MAINTENANCE 5

Emptying the dirt container 5

Cleaning the pre motor filter 6

Cleaning the post motor filter 6

CLEARING BLOCKAGES 7

Removing debris from the hose 7

Removing debris from the TurboTool 7

TROUBLESHOOTING 8

TECHNICAL SPECIFICATIONS 10

PRODUCT GUARANTEE 11

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 4

3

KNOW YOUR MACHINE

4

1

6

7

Vacuum Cleaner

13 15 16

17

18

11 12 14

Filters (pre-assembled in product)

Accessories

11 Pre motor filter
12 Post motor filter
13 Hose & handle
14 2-in-1 tool (dusting brush & upholstry tool)
15 Tool storage

16 Combination floor head
17 HEPA dust bag
18 2pc extension tube
19 Crevice tool
20 TurboTool

19

3

5

2

20

10

9

8

1 On/off button
2 Variable power
3 Cord rewind
4 Bag full indicator
5 Carry handle

6 Dirt container release handle
7 Hose inlet
8 Floor tool parking slot
9 Plug

10 Post motor filter cover

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 5

4

ASSEMBLY

OPERATION

Assembling your vacuum cleaner

Operating the appliance

IMPORTANT: Fully unwind the power cord. A yellow mark indicates the recommended cord length. Do not exceed the cord length beyond the yellow mark.

!

CARPETS

HARD FLOORS

VARIABLE POWER

POWER

SUCTION CONTROL

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 6

5

Packing away and storage

MAINTENANCE

Emptying the dirt container

OPERATION

Accessories

NOTE: Do not use TurboTool on suede and leather surfaces.

!

NOTE: To obtain the best results, empty the dust bag regularly. When the dust bag indicator shows red and performance reduce s, it is necessary to replace the
dust bag.

!

WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from the electrical outlet before performing
maintenance/troubleshooting checks.

!

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 7

6

MAINTENANCE

Cleaning the pre motor filter

Cleaning the post motor filter

TA

P

24hr

N

OTE: Failure to keep filters clean will result in a loss of performance.

!

TA

P

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 8

7

CLEARING BLOCKAGES

Removing debris from the TurboTool

Removing debris from the hose

NOTE: Disconnect the hose from the vacuum cleaner and remove any blockages found and then reconnect the hose securely.

!

BLOCKAGE INDICATOR: Located in front of the carry handle, the blockage indicator light will illuminate red when the filters, hose or dirt container have become
blocked. When this occurs empty the dirt container, check the filters and refer to the maintenance section of your instruction manual.

!

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 9

TROUBLESHOOTING

For help, spares or assistance please call 0845 6042377
or visit www.bagsandfilters.com

PROBLEM POSSIBLE CAUSES SOLUTIONS

T

here is an accessory

m

issing

1

. A part(s) is missing from box

1

. Check the ‘KNOW YOUR MACHINE’ page

o

f your instructions

The vacuum cleaner
does not switch on

1

. The unit is not plugged into a mains socket

2. The power button on the unit has not been
depressed

3. The thermal motor cut out has been activated
4

. There is no electricity to the power socket

1

. Ensure the plug is firmly in socket and

switched on

2. Depress the power switch on the unit
3 If the unit has cut out during use, disconnect
t

he unit from the wall socket, allow to cool for
one hour, clean the filters, empty bin/dust bag
and check the hose/accessories for blockages

4. Seek expert help from a qualified electrician

The vacuum cleaner won’t
pick up

1. The accessories are not correctly fitted
2 There are blockages in the hose/accessory

3. The dirt container/dust bag is full

4. The filters are blocked/clogged

1. Check hose and tools are correctly attached
to the machine/hose/tube; refer to ‘OPERATION’
section

2. Check the air paths of the hose/accessory are
not obstructed by blockages

3. Check dirt container/dust bag and if necessary
empty/replace

4. Frequent cleaning of filters will maintain
performance; see ‘MAINTENANCE’ section

Dust is escaping from the
vacuum cleaner

1. The filters/dust bag/dirt container are not
fitted correctly

2. The filters/dust bag are damaged

1. See ‘ASSEMBLY’ and ‘MAINTENANCE’ sections

2. If the filters/dust bag are damaged these will
need to be replaced

Accessories wont pick up
dust/debris

1. The wrong tool is fitted for the task

2. The tools are blocked

3. The filters are blocked

4. The dirt container/dust bag is full

5. The hose/tubes are blocked

1. See ‘KNOW YOUR MACHINE’ section

2. Check the air paths of the tools are not
obstructed by blockages

3. Frequently cleaning filters will maintain
performance; check ‘MAINTENANCE’ section

4. Check and empty the dirt container/replace
dust bag

5. Check the air paths of the hose/tubes are not
obstructed by blockages

The blockage indicator
(if applicable to model)
activates

1. The filters/dust bag/dirt container are blocked

2. The dust bag/dirt container is full

3. The accessories/hose/tube are blocked

1. Frequently cleaning filters will maintain
performance; check ‘MAINTENANCE’ section

2. Check and empty dirt container/replace dust
bag

3. Check the air paths of the accessories/hose/
tubes are not obstructed by blockages

8

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 10

This page has been left intentionally blank.

9

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 11

10

TECHNICAL SPECIFICATIONS

Model number : BC-501

Voltage: 220-240V ~ 50Hz

Wattage: 1800W max.

EEC Statement of Compliance

Manufacturer/EEC importer: Hereby on our own responsibility, declare that the

BC-501 is manufactured in compliance with the following Directives:

Safety: 2006/95/EC Low Voltage Directive

EMC: 2004/108/EC Electromagnetic Compatibility Directive

Waste electrical products should not be disposed of with household waste.

Please recycle where facilities exist. Check with your Local Authority or

retailer for recycling advice.

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 12

PPRROODDUUCCTT GGUUAARRAANNTTEEEE

This product is guaranteed against manufacturing defects for a period of

Year

This product is guaranteed for twelve months from the date of original purchase.
Any defect that arises due to faulty materials or workmanship will either be
replaced, refunded or repaired free of charge where possible during this period by
the dealer from whom you purchased the unit.

The guarantee is subject to the following provisions:

- The guarantee does not cover accidental damage, misuse, cabinet parts,
knobs or consumable items.

- The product must be correctly installed and operated in accordance with
the instructions contained in this manual.

- It must be used solely for domestic purpose.

- The guarantee will be rendered invalid if the product is re-sold or has
been damaged by inexpert repair.

- Specifications are subject to change without notice.

- The manufacturer disclaims any liability for the incidental or consequential
damages.

- The guarantee is in addition to, and does not diminish your statutory or
legal rights.

Guarantor: Argos Ltd

489 - 499 Avebury Boulevard

Central Milton Keynes

MK9 2NW

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 13

This page has been left intentionally blank. This page has been left intentionally blank.

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 14

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 15

BC-501 Guide.qxd:Value 21/1/10 12:33 Page 16