BUNN® TU-3/TB-3 3 GALLON
ICED TEA BREWER
On this card you’ll find instructions for operating, cleaning and troubleshooting your tea brewer
plus product hold time standards and water filter ordering information.
Instructions:
Always start with a clean server
®
Place three (3) Tazo
into the brew basket. Note: if using 3 oz.
1
portion pack of loose leaf tea, place one
12.25" x 4.75" filter (SKU #11012306,
SUPC# 0478406) into the brew basket
before placing tea in brew basket.
one gallon filterbags
TM
Slide the brew basket into the rails until it
2
3
stops. Make sure the server is under the
brew basket.
Press the start button when ready to brew.
When brewing has completed, dispose of
used tea filterbags.
EQUIPMENT INFORMATION
1
BUNN® TU-3/TB-3 3 GALLON
ICED TEA BREWER
TM
Brewer and Airpot Cleaning
•
Daily
Brewed Tea Hold-Time Standard
24 hours — Refrigerated
12 hours — Not Refrigerated
Brewer & Server Troubleshooting Guide
PROBLEM POSSIBLE CAUSE SOLUTION
Brew cycle will not start
Weak tea
Strong tea / Tastes old
Tea is cloudy
Rinse brew basket and airpot with hot water after each brew cycle.
•
Wipe around spray head of brewer daily. Do not use soap or abrasives.
•
Wipe exterior of brewer daily. Do not use abrasives.
Power switch off Turn on power switch
No power to brewer Make sure unit is plugged in
No water to brewer Make sure shut-off valve is open
Improper dose Make sure you are using recommended dosage
Ice added to server
Improper dose Make sure correct dosage is used
Servers are not clean inside Always start with a clean server
Too much water added during dilution
Cold cycle not allowed to finish
Hard water
Ice added to tea before serving Do not add ice before serving
Hot water hooked to machine
Water filter needs changing
Do not start brew until ready light is on
Allow customers to pour freshly brewed Iced
Tea into a cup of ice to insure quality
There should be roughly 72 oz. of extracted tea
before cold water is added to make 3 gallons
Ensure that the brewer is allowed to complete
its final cold water infusion
If cloudy tea persists after cold water cycle,
have water hardness checked. A softener may be
needed (at acct cost) to allow proper tea extraction
Check to make sure that a cold water line is
attached to machine
Check water filter date and make sure it has been
changed in the last 6 months. If not, change
Plugged water filter Change water filter
Short potting
Not using a dedicated water line
Hook up to a dedicated water line, a water line
not shared with other equipment
Note — Ordering, changing and cost of water filtration is the customers responsibility.
To order water filters go to http://starbucksfs.com/ContactUs/Equipment/Order_Filter
For directions on how to change filters go to http://starbucksfs.com/Support/Equipment/Water_Filtration
Or contact your Starbucks rep who can direct you to the right place to get the right water filter.
2
© 2012 Starbucks Coffee Company. All Rights Reserved. SFS-007-WPS-ECD-00622