Bunn ICB SH, ICB SH TWIN Service Manual

ICB SH

ICB SH TWIN

Faucet Side Car Relocation

Instructions

TO BE PERFORMED BY QUALIFIED PERSONNEL

These instructions are intended for relocating the facuet side car on an ICB SH brewer. Ensure all tools are present before
performing the installation.

WARNING: Disconnect the brewer from the power source before performing the procedure. Ensure the
water is drained from the tank and be aware that many internal parts can be extremely hot; allow contents of
tank to cool before proceeding.

Note: If technical assistance is needed, please call 1-800-286-6345

Tools Required:

8/32 socket/wrench
Flat Blade Screwdriver

BUNN-O-MATIC CORPORATION

POST OFFICE BOX 3227

SPRINGFIELD, ILLINOIS 62708-3227

PHONE: [phone] FAX: [phone]

www.bunn.com

55227.0000A 07/18 ©2018 Bunn-O-Matic Corporation

ICB SH Faucet Side Car Installation Instructions

Remove Cover

STEP 1

• Disconnect power to the brewer.

• Remove the screws that secure the front
panel to the brewer (6 screws).

Remove Hose Snap

Remove Tube

STEP 2

• Carefully remove the front panel of the
brewer.

Remove Nuts ,
Washers, Screws
& grommet

STEP 3

• Remove the three screws that secure the
cover to the faucet side car.

• Remove the cover.

Spacer

Faucet Side Car

Plate Assembly

STEP 4

• Open the faucet handle to drain water from
the tank. Keep the faucet handle open until
water is no longer dispensing.

• Remove the hose snap clamp that secures
the tube to the faucet shank.

• Carefully remove the hose from the faucet
shank.

STEP 5

• Remove the two 8/32 nuts, two washers
and base screw from the faucet side car.

• Remove the black silicone grommet.

STEP 6

• Completely remove the faucet side car,
spacer and plate assembly from the left
side of the brewer.