Browning 9190E Instruction Manual
TorqTaper® Plus Fan Kit
Installation Instructions
F O R M
9190E
Revised
October 2015
• Read and follow all instructions carefully.
• Disconnect and lock-out power before installation and maintenance.
Working on or near energized equipment can result in severe injury or death.
• Do not operate equipment without guards in place. Exposed equipment can
result in severe injury or death.
1. Fan Kit Installation
1.1 Attach the fan housing to the reducer with the at head screws
provided. Reducers are furnished with tapped holes surrounding the
input shaft for this purpose. Tighten the at head screws to the
recommended value (see Bolt Torque Specication Table).
1.2 Rotate the reducer’s input shaft until the keyway is in the ‘up’
position.
1.3 Place the key into the keyway of the input shaft and slide the fan
blade into position with the hub away from the housing. Make sure the
fan blade seats against the shaft shoulder. Attach the fan blade to the
input shaft with the set screws provided. Tighten the set screws to the
recommended value (see Bolt Torque Specication Table).
1.4 Attach the fan cover to the fan housing with the cap screws
provided. Tighten the cap screws to the recommended value
(see Bolt Torque Specication Table).
Fan Kit Parts Description
Item
Number
1 Fan Housing
2 Fan Blade
3 Fan Cover
4 Flat Head Cap Screws
5 Socket Set Screws
6 Hex Head Cap Screws
Description
• Periodic inspections should be performed. Failure to perform proper maintenance
can result in premature product failure and personal injury.
• All electrical work should be performed by qualied personnel and compliant with
local and national electrical codes.
4
6
3
5
2
1
Fan Housing Fan Blade Fan Cover
Reducer
Size
Flat Head Bolt
Size
Ft Lbs
Set
Screw
Size
Ft Lbs
Cap
Screw
Size
307 3/8-16 29 3/8-16 24 1/4-20 12
315 3/8-16 29 3/8-16 24 1/4-20 12
407 3/8-16 29 3/8-16 24 1/4-20 12
415 3/8-16 29 3/8-16 24 1/4-20 12
507 3/8-16 29 3/8-16 24 1/4-20 12
608 3/8-16 29 3/8-16 24 1/4-20 12
800 3/8-16 29 3/8-16 24 1/4-20 12
Browning and TorqTaper are trademarks of Regal Beloit Corporation or one of its afliated companies.
©2015 Regal Beloit Corporation, All Rights Reserved. MCIM15088E • Form 9190E • Printed in USA
Ft Lbs
Loading...