Brother NC-8100h Setup Guide

Quick Network Setup Guide

version A

Caution: DO NOT

For more details about how to optimize the Network board, please refer to the Network User's Guide on the CD-

ROM supplied with the MFC.

Before Starting Installation:

Be careful when handling the NC-8100h. There are many delicate electronic components that are susceptible to

damage from static electricity. To avoid such damage, use the following precautions when handling the board:

• Leave the NC-8100h in its anti-static bag until you are ready to install it.

• Make sure that you are adequately grounded before touching the NC-8100h. Use an anti-static wrist strap and a
grounding mat if possible. If you do not have an anti-static wrist strap, touch the bare metal surface on the back
of the machine before handling the NC-8100h.

• Avoid moving around the work area in order to eliminate static charge build-up.

• If possible, do not work on a carpeted area.

• Do not flex the board and do not touch the components on the card.

touch the surface of the main boards within 15 minutes after turning off the power.

NC-8100h
Print/Fax Server

Quick Network Setup GuideTwo Sc re ws

One Touch
Key Sheet
(For use with MFC9660, MFC9880,
MFC9800 Only)

Too l s R eq u ire d :

Phillips Screwdriver

Step 1: Hardware Installation

1. Unplug the power cord from the AC Outlet.

2. Disconnect any interface cables that are connected to the rear of the machine. (Ex. Parallel Interface Cable).

3. Unplug the handset cable (if applicable) and phone lines from the side of the machine.

Caution:

Make sure the power cable is unplugged before installing or removing the NC-8100h Board.

1

4. Remove the screws securing the rear cover and remove the cover.

Protective
Label

5. Peel off the protective label from the chassis as illustrated in the detailed blowup.

6. Remove the screws securing the access plate and remove the plate.

Back up Battery

7. Remove the screw securing the small plate.

Back up Battery

8. Hold the NC-8100h with the connector on the bottom of the board facing down. Plug the NC-8100h into con-

nector P1 located on the main board and reinstall the two screws into the NC-8100h support bracket.

Caution: Always hold the NC-8100h by the edge. Do not touch the surface of the network or main boards.

2