2. Insert three LR44 Button Cells into
the battery compartment according
to the polarity indicators on the
bottom plate.
3. Close the BATTERY
COMPARTMENT COVER securely
with the screw.
Important: Please remove the batteries
if storing the globe for an extended
period of time.
PAIRING YOUR DEVICE
1. Prepare your device to pair using
Bluetooth
®
technology, making sure
you are within 33 feet of the speaker.
Refer to your device’s owner’s
manual for details if necessary.
2. Press and hold the Power Button for
3 seconds. The LED Indicator light
will flash blue quickly. The speaker
will sound a guitar cord tone and
enters pairing mode.
3. Once the speaker is in pairing mode
and your device is ready to pair,
select “Eluma Lights Speaker”. If
prompted, use 0000 as a PIN for
the pairing code. Once the speaker
is selected, it will sound a beep tone
and the blue light will flash slowly to
confirm pairing is complete.
LITHIUM-ION BATTERY
WARNINGS
This device contains a non-removable
lithium-ion battery. The battery must be
recycled or disposed of properly.
Contact your local waste management
office for information on battery
recycling or disposal.
FCC INFORMATION
This equipment has been tested
and found to comply with the
limits for a Class B Digital Device,
pursuant to Part 15 of the FCC
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the distance between
the equipment and receiver.
• Connect the equipment to
an outlet
on a circuit different from
that to
which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
This equipment complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
1. This equipment may not cause
harmful interference.
2. This equipment must accept any
interference received, including
interference that may cause
undesired operation.
Modifications not authorized by the
manufacturer may void the user’s
authority to operate this device.
FCC ID: 2ADOI-SP968
ELUMA LIGHTSTM
SPEAKER SYSTEM
STARTER SYSTEM INCLUDES
1 WIRELESS LIGHT-UP SPEAKER
PLUS 4 SMALL SATELLITE GLOBES
(Additional Satellite Globes sold separately)
LOCATION OF PORTS AND
CONTROLS (MASTER SPEAKER)
1. Speaker Grill
2. Speaker Translucent Body
3. LED Indicator
4. Power Button
5. Micro USB Charging Port
6. Light Control Zone
7. Base Stand
8. Micro USB Charging Cable
(not shown)
CHARGING THE SPEAKER
1. Connect the USB Cable (included)
to the Micro USB Port on the
Speaker.
2. With the speaker’s power off, plug
the other end of the USB Cable into
a USB Port on your computer.
3. The LED Indicator light will illuminate
Red while charging, and the light
will go out when the speaker is
fully charged. Charges in
approximately 5.5 hours for up to
8 hours of listening enjoyment.
CHARGING THE MEDIUM
GLOBE
1. Connect the USB Cable (included)
to the Micro USB Port on the globe.
2. Plug the other end of the USB
Cable into a USB Port on your
computer.
3. The LED Indicator light will illuminate
Red while charging and it will go
out when the globe is fully charged.
INSTALLING THE BATTERIES
IN SMALL GLOBE
1. Unscrew the BATTERY
COMPARTMENT COVER.
LOCATION OF PORTS AND
CONTROLS (SMALL GLOBE)
1. Translucent Body
2. Battery Compartment Cover
3. Power Switch
LOCATION OF PARTS
AND CONTROLS (MEDIUM
GLOBE)
(SOLD SEPARATELY)
1. Translucent Body
2. LED Indicator
3. Micro USB Charging Port
1
2
5
4
3
6
7
1
2
3
1
2
3
SPECIFICATIONS
Speaker Power Supply: 5V 500mA
Total Output: 5 Watts
Range: Class 2, up to 33 ft (10 m)
Li-ion Rechargeable Battery: 2200mAh
Speaker Driver: Dia. 3.5 inch, 4 Ohm
Charging Time: Approx. 5.5 hours
Battery Life: Approx. 8 hours
Compatibility: Bluetooth
®
2.0 or above
device with A2DP/AVRCP
Medium Globe –
Power Supply: 5V 400mA
Li-ion Rechargeable Battery: 700 mAh
Charging Time: Approx. 2 hours
Battery Life:
Approx. 4 hours (LAMP mode)
Approx. 12 hours (BEAT mode)
Small Globe –
Battery Life:
Approx. 4 hours (LAMP mode)
Approx. 13 hours (BEAT mode)
The Bluetooth
®
word mark and logos
are registered trademarks owned of
Bluetooth
®
SIG, Inc. and any use of
such marks by Brookstone is under
license.
© Brookstone 2016
2. Double tap to enter MOOD LIGHT
mode. The light will turn into
changing rainbow color.
NOTE: Tap the LIGHT CONTROL ZONE
once to select the specified single
light color within the first two rainbow
light cycles.
3. Triple tap to enter BEAT mode. The
light will flash red 4 times to indicate
entering BEAT mode. When the
music is on, the changing rainbow
light will dance to the music.
NOTES: • The light will turn into changing
rainbow color if no audio signal is
streaming to the speaker.
• Turn up the music volume to make
the beating light more visible.
4. Quadruple tap to enter PARTY
mode. The light will flash white 4
times to indicate entering PARTY
mode. When the music is on, the
strobe light will dance to the music.
NOTES: • The light will turn into changing
rainbow color if no audio signal is
streaming to the speaker.
• Turn up the music volume to make
the strobe light more visible.
5. A single tap again in the Light Control
Zone will turn the light off.
LISTENING TO YOUR
AUDIO DEVICE
1. Play your audio device as you
normally would.
2. Volume is adjusted on your
audio device.
3. To pause audio, press the Power
Button on the Speaker. To resume
audio playback, press the Power
Button again.
4. Press and hold the Power Button on
speaker for 3 seconds. The speaker
will sound a tone and power off.
TURNING ON/OFF LIGHT
EFFECT (MASTER SPEAKER)
1. Tap once in the Light Control Zone
to turn the light on and enter the
LAMP mode.
TURNING ON/OFF LIGHT
EFFECT (SMALL GLOBE)
1. Slide the Power Switch to ON.
2. The globe will automatically sync
to the master speaker.
3. Use the master speaker to control
the light effect of the globe.
See steps under TURNING ON/OFF
LIGHT EFFECT (MASTER SPEAKER)
.
4. Slide the Power Switch to OFF
to turn the globe off to save
battery power.
NOTE: You can sync unlimited globes to
the speaker. Additional globes
(SMALL/MEDIUM) are available
for purchase in store.
TURNING ON/OFF LIGHT
EFFECT (MEDIUM GLOBE)
1. The globe will automatically sync
to the master speaker.
2. Use the master speaker to control
the light effect of the globe.
See steps under
TURNING ON/OFF
LIGHT EFFECT (MASTER SPEAKER)
.
CARE AND STORAGE
Store the speaker and globes in a
cool, dry place
Merrimack, New Hampshire, USA 03054
800-846-3000 • Brookstone.com
318025 • 318024 • 318026
Loading...